Electrolux MGH 621 инструкция обслуживания

GAS HOB MGH 621 INSTRUCTION BOOKLET Please read this instruction booklet before using the appliance Keep this instruction book for future reference and ensure it is passed on to any new owner. 1. Hob T op 2. Rapid Burner 3. Semi-rapid Burners 4. Auxiliary Burner 5. Control knobs 6. Electric Ignition Push Button 1 3 2 4 3 6 5 These instructions are [...]

2 Import ant Safety Information You MUST read hese warnings carefully before installing or using the hob. If you need assistance, contact our Customer Care Department on 08705 950950 Inst allation  This appliance must be installed and serviced by a competent person as stated in the Gas Safety (Installation and Use) Regulations Current Editions a[...]

3 The following symbols will be found in the text to guide you throughout the Instructions: Safety Instructions Step by step instructions for an operation Hints and Tips Environmental information  Guide to Use the instructions  Never use plastic or aluminium foil dishes on the hob.  Perishable food, plastic items and areosols may be affect[...]

4 Maintenance and Cleaning Before any maintenance or cleaning can be carried out, you must DISCONNECT the hob from the electricity supply . The hob is best cleaned whilst it is still warm, as spillage can be removed more easily than if it is left to cool. The Hob T op Regularly wipe over the hob top using a soft cloth well wrung out in warm water t[...]

5 SYMPTOM  There is no spark when lighting the gas.  The gas ring burns unevenly . SOLUTION  Check that the unit is plugged in and the electrical supply is switched on.  Check that the RCCB has not tripped (if fitted).  Check the mains fuse has not blown.  Check the burner cap and crown have been placed correctly , e.g. after clea[...]

6 Overall dimensions Cut out dimensions Width: 580 mm. Width: 550 mm. Depth: 500 mm. Depth: 470 mm. Engineers technical data Instructions for the Inst aller Rear Left Burner (semi-rapid) Heat Input 2.0 kW (6824 BTU/HR) Front Left Burner (rapid) Heat Input 3.0 kW (10236 BTU/HR) 2.8 kW L.P .G . (9554 BTU/HR) Rear Right Burner (semi-rapid) Heat Input [...]

7 Import ant safety requirement s 700 mm 400 mm 100 mm 400 mm 50 mm 55 mm 50 mm 650 mm 400 mm 400 mm 100 mm 50 mm 50 mm 55 mm 600 mm FO 0812 FO 0813 FITTING THE GAS HOB WITHOUT A COOKER HOOD ABOVE FITTING THE GAS HOB WITH A COOKER HOOD ABOVE This hob must be installed in accordance with the Gas Safety (Installation and Use) Regulations (Current Edi[...]

8 When the hob is first installed Once the hob has been installed, it is important to remove any protective materials, which were put on in the factory . On the end of the shaft, which includes the GJ 1/2" threaded elbow , adjustment is fixed so that the washer is fitted between the components as shown in the diagram. Screw the p arts together[...]

9 FO 0763 FO 0764 Dimensions are given in mm. Building In Building over a cupboard or drawer If the hob is to be installed above a cupboard or drawer it will be necessary to fit a heat resistant board below the base of the hob on the underside of the work surface. It is also recommended to carry out the electrical connection to the hob as shown in [...]

10 Permanent Connection In the case of a permanent connection, it is necessary that you install a double pole switch between the hob and the electricity supply (mains), with a minimum gap of 3 mm. between the switch contacts and of a type suitable for the required load in compliance with the current electric regulations. The switch must not break t[...]

11 Wiring Diagram Commissioning When the hob has been fully installed it will be necessary to check the minimum flame setting. T o do this, follow the procedure below . 1. Turn the gas tap to the MAX position and ignite. 2. Set the gas tap to the MIN flame position then turn the control knob from MIN to MAX several times. If the flame is unstable o[...]

12  Conversion from Natural Gas to LPG It is important to note that this model is designed for use with natural gas but can be converted for use with butane or prop ane gas providing the correct injectors are fitted. The gas rate is adjusted to suit. Method 1. Ensure that the gas taps are in the 'OFF' position 2. Isolate the hob from t[...]

13 BURNER RAPID SEMI-RAPID AUXILIARY (large) (medium) (small) POSITION MA X MIN MAX M IN MAX M IN NOMINAL THERMAL 3. 0 0.65 2.0 0.45 1.0 0.33 POWER (kW) NOMINAL FLOW 0.286 0.062 0.190 0.043 0.095 0.031 RATE (m 3 /h) NOZZLE REFERENCE 11 9 Adjust. 96 Adjust. 70 Adjust. (1/100 mm) NOMINAL THERMAL 2. 8 0.65 2.0 0.45 1.0 0.33 POWER (kW) NOMINAL FLOW 20 [...]

Service and S pare Part s If you require spare parts or an engineer contact your local Service Force Centre by telephoning: 08705 929 929 Your call will be routed to the Service Centre covering your post code area. The addresses of Service Force Centres are detailed on the following pages. CUSTOMER CARE For general enquiries concerning your Moffat [...]

[...]

Grafiche MDM - Forlì 35676-2903 07/06 www .electrolux.com[...]