Electrolux EWS 10470 W инструкция обслуживания

user manual Washing Machine EWS 10470 W[...]

Electrolux. Thinking of you. Share more of our thinki ng at www.electrolux.com Contents Safety information 2 Product description 4 Control panel 5 First use 7 Personalisation 7 Daily use 7 Helpful hints and tips 11 Washing programmes 13 Care and cleaning 16 What to do if.. . 20 Technical data 23 Consumption values 23 Installation 23 Electrical conn[...]

Installation • This appliance is h eavy. Care should be taken when moving it. • When unpacking the appliance, check that it is not damaged. If in doubt, do not use it and contact the Service Centre. • All packing and transit bolts must be re- moved before use. Serious damage can occur to the product an d to property if this is not adhered to.[...]

Product description Your new appliance meets all modern requir ements for effective treatm ent of laundr y with low water, energy and detergent consum ption. Its new washing system allows total use of detergent and reduces wate r consumption so saving energy. 1 2 3 4 5 6 1 Detergent dispenser drawer 2 Control panel 3 Door opening han dle 4 Ratin g [...]

Control panel Below is a picture of the control panel. It shows the progra mme selector dial as well as the buttons, pilo t light and the display. These are presented by relevant numbers on the following pages. 1 2 4 5 6 7 8 9 10 3 1 Programme selector dial 2 TEMPERATURE button 3 SPIN reduction button 4 PREWASH button 5 EXTRA RINSE button 6 DELAY S[...]

This option is recommended for heavily soiled laundry. Extra Rinse This appliance is design ed for saving energy. If it necessary to rinse the laundry using an extra quantity of water (extra rinse), select this option. Some additional rinses will be performed. This option is rec ommended for people who are allergic to detergents, and in areas where[...]

• Wash • Rinses • Drain • Spin By selecting the wash programme, the pro- gramme phase icons corresponding to the various phases making up the programme are shown in the bottom part of the display. After having pressed button 8 only the icon of the running phase stays on. 7.3: Heating phase During the washing cycle the display shows a temper[...]

Measure out the detergent and the fab- ric softener Pull out the dispenser dr awer until it stops. Measure out the amount of detergent re- quired, pour it into the main wash compart- ment or in the appropriate compartment if the selected programme/option it requires (see more details in «Detergent dispenser drawer»). If required, pour fabric soft[...]

Reduce the spin speed by pressing button 3 By selecting a programme, the appliance proposes automatically the m aximum spin speed provided for that programme. Press button 3 repeatedly to change the spin speed, if you want your laun dry to be spun at a different speed. The relevant li ght illumi- nates. Select the available option by pressing butto[...]

Important! The Time Manager cannot be selected with the Econ omy programmes. The availability of these soil level icons change according to th e type of fabric as shown in the following chart. Fabric Soil Level Cottons 95°/90°C X X X X X X 60°C/50°C X X X X X X 40°C X X X X X X 30°C X X X X X X Cold X X X X X X Synthetics 60°C/50°C X X X X [...]

blinking to indicate th at the appliance has to be switched off. By pr essing any button the appliance will come out from the energy sav- ing status and you can set another pro- gramme or switch the appliance off. Helpful hints and tips Sorting out the laundry Follow the wash code symbols on each gar- ment label and the manufacturer’s washing ins[...]

Mould stains: treat with bleach, rinse well (whites and fast coloureds only). Grass: soap lightly and treat with bleach (whites and fast coloureds only). Ball point pen and glue: moisten with ace- tone 1) , lay the garment on a soft cloth and dab the stain. Lipstick: moisten with acetone as above, then treat stains with methylated spirits. Treat an[...]

Washing programmes Programme - Maximum and Min imum Tempera- ture - Cycle Des cription - Maximum Spi n Speed - Maximum Fabrics Load - Type of Laundry Options Detergent Com- partment COTTONS 90° - Cold Main wash - Rinses Spin at the maximum speed Max. load 6 kg - Red. load 3 kg 1) For white and coloured cotton (normally soiled items). SPIN REDUCTIO[...]

Programme - Maximum and Min imum Tempera- ture - Cycle Des cription - Maximum Spi n Speed - Maximum Fabrics Load - Type of Laundry Options Detergent Com- partment SOAK 30° Prewash - Soak for about 40 minut es - Stop with water in the tub Max. load 6 kg Special programme for heavily soiled laundry. The ma- chine performs a soak at 30°C. At the end[...]

Programme - Maximum and Min imum Tempera- ture - Cycle Des cription - Maximum Spi n Speed - Maximum Fabrics Load - Type of Laundry Options Detergent Com- partment CURTAINS 40° - Cold Prewash - Main wash - Rinses Maximum spin speed 700 rpm Max. load 2 kg Special washing cycle for cu rtains which add s auto- matically a prewash phase to eliminate th[...]

Care and cleaning Warning! You must disconnect the appliance from the electricity supply, before you can carry out any cleaning or maintenance work. Descaling The water we use normally contains lime. It is a good idea to periodically use a water softening powder in the machine. Do this separately from any laundry washing, and according to the softe[...]

Washing drum Rust deposits in the drum may occur due to rusting foreign bodies in the washing or tap water containing iron. Important! Do not clean the drum with acidic descaling agen ts, scouring agents containing chlorine or iron or steel wool. 1. Remove any rust deposits on the drum with a cleaning agent for stainless steel. 2. Run a washing cyc[...]

6. When no more water comes ou t, un- screw the pump cover, using a pliers, and remove the filter. Always keep a rag nearby to dry up spillage of water when removing the cover. 1 2 7. Remove any objects from the pump im- peller by rotating it. 8. Replace the filter in to the pump paying attention to insert it properly. When done, screw it firmly. 9[...]

Warning! When the appliance is in use and depending on the programme selected there can be hot water in the pump. Nev er remove the pump cove r during a wash cycle, always wait until the appliance has finished the cycle, and is empty. When replacing the cover, ensure it is securely re-tightened so as to stop leaks and yo ung children being able to [...]

• Screw the hose back to the machine and make sure the connection is tight. • Turn on the water tap. Emergency emptying out If the water is not discharged, proceed as follows to empty out the machine: 1. pull out the plug fr om the power socket; 2. close the water tap; 3. if necessary, wait until the water has cooled down; 4. open the pump door[...]

Problem Possible ca use/Solution The machine doe s not start: The door has not been closed. E40 •C l o s e t h e d o o r f i r m l y . The plug is not properly inserted in th e power socket. • Insert the plug into the power socket. There is no power at the socket. • Please check your domestic electrical installation. The main fuse has blown. [...]

Problem Possible ca use/Solution The door wi ll not open: The programme is still running. • Wait the end of washing cycle. The door lock has not been released. • Wait until the pilot light 9 goes off. There is water in the drum. • Select drain or spin programme to empty out th e water. The machine vib rates is noisy: The transit bolts and pac[...]

Technical data Dimensions Width Height Depth Depth (Overall dimensions) 60 cm 85 cm 45 cm 48 cm Electrical connection Voltage - Overall power - Fuse Information on the electrical connect ion is given on the rating plate, on the inner edge of the appliance door. Water supply pressure Minimum Maximum 0,05 MPa 0,8 MPa Maximum Load Cotton 6 kg Spin Spe[...]

2. Remove the power supply cable and the draining and inlet hose from the hose holders on the rear of the appliance. 3. Unscrew the three bolts. 4. Slide out the relevant plastic spacers. 5. Fill the smaller upper hole and the two large ones with the corresponding plastic plug caps supplied in the bag containing the instruction booklet. 24 electrol[...]

Positioning Install the machine on a flat hard floor. Ma ke sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units. Le vel the washing ma- chine by raising or lowe ring the feet. The feet may be tight to adjust as they incorporate a self locking nut, bu[...]

Water drainage The end of the drain hose can be positioned in three ways. • Hooked over the edge of a sink using the plastic hose guide supplied with the machine. In this case, make sure the end cannot come unhooke d when the ma- chine is emptying. This could be done by tying it to the tap with a piece of string or attaching it to the wall. • I[...]

Warning! The appliance is supplied with a 13amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13amp ASTA approved (BS1363/A) fuse must be used. The manufacturer does not accept any responsibility for damage or injury through failure to comply with the above safety precaution. Should the appliance power supply cable [...]

132952390 - 0 0 -242009 www.electrolux.com web portal 1 web portal 2[...]