Electrolux ERN28700 инструкция обслуживания

user manual Fridge-Freezer ERN28700[...]

Electrolux. Thinking of you. Share more of our thinking at www.electrolux.com CONTENTS Safety information 2 First use 5 Daily use 5 Helpful hints and tips 6 Care and cleaning 7 What to do if… 9 Technical data 10 Installation 11 Environmental concerns 16 Subject to change without notice SAFETY INFORMATION In the interest of your safety and to ensu[...]

damage to the cord m ay cause a short- circuit, fire and/or electric shock. Warning! Any electrical component (power cord, plug, compressor) must be replaced by a certified service agent or qualified service personnel to avoid hazard. 1. Power cord must not be lengthened. 2. Make sure that the power plug is not squashed or damaged by the back of th[...]

• Make sure that the mains plug is accessi- ble after the installation of the appliance. • Connect to potable water supply only. 4) Service • Any electrical work required to do the servicing of the appliance should be car- ried out by a qualified electrician or com- petent person. • This product must be serviced by an au- thorized Service C[...]

FIRST USE Cleaning the interio r Before using the appliance for the first time, wash the interior and all internal accesso- ries with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, th en dry t horoughly. Important! Do not use detergents or abra- sive powders, as thes e will damage the fin- ish. DAILY [...]

Positioning the doo r shelves To permit storage of fo od packages of vari- ous sizes, the door shelves can be placed at different heights. To make these adjustments proceed as fol- lows: gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required. HELPFUL HINTS AND TIPS Hints for energy saving • Do not[...]

to make it possible subsequen tly to thaw only the quantity required; • wrap up the food in aluminium foil or pol- ythene and make sure that the packages are airtight; • do not allow fresh, unfrozen food to touch food which is al ready frozen, thus avoiding a rise in temperature of the lat- ter; • lean foods st ore bett er and longer than fat[...]

Defrosting the freezer A certain amount of frost will always form on the freezer shelve s and around the top compartment. Defrost th e freezer when the frost layer rea- ches a thickness of about 3-5 mm. Important! About 12 hours pr ior to defrosting, set the Temperature regulator toward higher settin gs , in order to bu ild up sufficient chill rese[...]

• leave the door/doors ajar to prevent un- pleasant smells. If the cabinet will be kept on, ask some- body to check it once in a while to prevent the food inside from spoiling in case of a power failure. WHAT TO DO IF… Warning! Before trou bleshooting, disconnect the mains plug from the mains socket. Only a qualified electrician or compe- tent [...]

Problem Possible cause So lution The product temperat ure is too high. Let the product temperature de- crease to room temperature be- fore storage. Many products are stored at the same time. Store less products at the same time. The temperatu re in the refrigerator is too hig h. There is no cold air circulation in the appliance. Make sure that ther[...]

The technical informatio n are situated in the rating plate on the inte rnal left side of the appliance and in the energy label. INSTALLATION Read the "Safety In formation" carefully for your safety and correct operation of the appliance before installin g the appliance. Positioning Install this appliance at a location where the ambient t[...]

5. Make sure the electricity supply voltage is the same as that indicated on the ap- pliance rating plate. 6. Switch on the appliance. The appliance is supplied with a 13 amp plug fitted 2 . In the event of having to change the fuse in th e plug supplied, a 13 amp ASTA approved (BS 1362) fuse must be used. Warning! A cut off plug inserted into a 13[...]

min. 200 cm 2 min. 200 cm 2 Installing the appliance Caution! Make sure that the mains cable can move freely. Do these steps. 1. If necessary cut the adhesive seal ing strip and then apply it to the appliance as shown in figure. x x 2. Install the appliance in the niche. Push the appliance in the direction of the arrows (1) until the upper gap cove[...]

3. Adjust the applia nce in the niche. Make sure that the distance between the appliance and the cupboard front- edge is 44 mm. The lower hinge cover (in the accesso- ries bag) makes sure that the distance between the appliance and the kitchen furniture is correct. Make sure that the clearance between the appliance and the cupboard is 4 mm. Open th[...]

7. Connect the applian ce laterally to the kitchen furniture sidewall: a) Loosen the screws of the part (G) and move the part (G) till the fu rni- ture sidewall. b) Tighten the screws of the part (G) again. c) Attach the part (H) to the part (G). G H 8. Disco nnect the parts Ha, Hb, Hc a nd Hd Ha Hb Hc Hd 9. Install the part Ha on the inner side of[...]

11. Open the appliance door and the kitch- en furniture door at an angle of 90°. Insert the small square (Hb) i nto guide (Ha). Put together the appliance door and the furniture door and mark the holes. Ha Hb 8 mm 12. Remove the brackets and mark a dis- tance of 8 mm from the outer edge of the door where the nail must be f itted (K). Ha K 8 mm 13.[...]

electrolux 17[...]

18 electrolux[...]

electrolux 19[...]

222301056-A-4 82010 www.electrolux.com/shop[...]