Electrolux 8490 D инструкция обслуживания

8490 D Cooker hood Operating and Installation Instructions[...]

2 Contents Safety instructions ..................................................... 2 Description of the cooker hood ................................... 3 Using the cooker hood ............................................... 4 Maintenance and cleaning .......................................... 6 What to do if ......................................[...]

3 Description of the cooker hood Accessories The following are included with the cooker hood. ● 1 Adaptor 150-125 mm ● 2 Tube clamps ● 1 hood canopy complete with controls , lighting and fan motor . ● 1 telescopic chimney stack formed by: U-shaped upper section and U- shaped lower section. ● 1 reduction flange Ø 150-125 mm. ● 1 recircu[...]

4 The contr ol panel Using the cooker hood T 1 : Main switch on/off (Activating and deactivating the stand-by mode) T 2 : Sensor switch enable/disable T 3: Lamps on/off D 1 : Filter saturation indicator D 2 : Motor speed display 1-2-3-P (intensive) D1-D2: Minute count down display (delayed switch off) T 4 : Motor speed T 5 : Intensive speed on/off [...]

5 Delayed switch off ● The delayed switch off can be activated with knob T6 while the motor is running ● The display shows remaining minutes until the motor and lamps (if on) are switched off ● The switch off delay is depending on motor speed: Speed 1: 20 minutes Speed 2: 15 minutes Speed 3: 10 minutes Intensive speed: 5 minutes Filter satura[...]

6 Maintenance and cleaning Before doing any maintenance work on the hood, disconnect it from the main supply by disconnecting the plug from the wall socket or unscrewing the fuse. Cleaning the hood Clean the outside of the hood using a damp cloth and a mild detergent. Never use corrosive, abrasive or flammable cleaning products. Cleaning the grease[...]

7 Changing the light Disconnect the cooker hood from the main supply before changing the light. T o change the light (Fig. 5): ● Press (1) the lamp cover (2) and open it. ● Replace the old bulb with a new one of the same type (3). ● Close the lamp cover (4). After approximately three years of use, the KF8 filter should be replaced with a new,[...]

8 What to do if If your appliance fails to work properly please carry out the following checks. Symptom Solution The cooker hood will not start... The hood is connected to the electricity supply. Check that the fan speed control is set to 1, 2 or 3. The cooker hood is not working The fan speed is set high enough effectively... for the task. The gre[...]

9 Ser vice and spare par ts In the event of your apppliance requiring service, or if you wish to purchase spare parts, contact your local AEG Service Force Centre by telephoning 08705 929 929 Your call will be automatically routed to the Service Centre covering your post code area. Please ensure that you have read the section „What to do if....?[...]

10 Guarantee conditions Guarantee Conditions AEG offer the following guarantee to the first purchaser of this appliance. 1. The guarantee is valid for 12 months commencing when the appliance is handed ov er to the first retail purchaser, which m ust be v erified by purchase invoice or similar documentation.The guarantee does not cover commercial us[...]

11 T echnical data Model 8490 D Size Height 820-1370 mm Width 898 mm Depth 480 mm Light Max 2X20 W Grease filter 3 pcs. V oltage 220-240 V T otal power 175 W Fuse Rating 13 A mp Extra accessories: Carbon filter KF 8 P-nr . 942 118 609 Carbon filter KFL 60/80 610 899 421 Before you move please contact your nearest Customer Care Centre, listed below,[...]

12 Installation Unpac king Check that the cooker hood is not damaged. Transportation damages should immediately be repor ted to the transpor t company . Damages, f aults and missing par ts should immediately be repor ted to the retailer. Dispose carefully of the packaging material so that it is out of the way of small children. Position The cooker [...]

13 Mounting the cooker hood - Fig. 7 Position the template on the wall and mark the position, and drill the holes (2 x Ø 8 mm).Mount the two rawl plugs with the hooks (3) Hang the hood on the hooks and level it with the adjustment screws (4) Remove the grease filters (5) and mark for the two screws (6). Remove the hood and drill the holes (2 x Ø [...]

14 Fig. 7 12 12[...]

15 Fig. 8 Power outlet Exhaust tube Electric hob 500 mm Gas hob 650 mm Charcoal and oil 700 mm Wall bracket Electric hob 500 mm Gas hob 650 mm Charcoal and oil 700 mm[...]

AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http://www .aeg.hausgeraete.de © Copyright by AEG LI1IAE[...]