Drolet DB03060 инструкция обслуживания

INSTRUCTIONS & OPERATIONS MANUAL DROLET COMPAK EPA EXEMPT US ENVIRONMENTAL PROTECTION AGENCY 28A CERTIFIED WOODSTOVES Verified and tested following UL 1482 Standards by: Manufactured by : STOVE BUILDER INTERNATIONAL INC. 1700, Leon-Harmel, Quebec (Quebec) G1N 4R9 Tel : ( 418 ) 527-3060 Fax : ( 418 ) 527-4311 w w w .drolet.ca READ AND KEEP THIS [...]

TABLE OF CONTENTS INTRODUCTION ............................................................................................................... 2 ASSEMBLY ....................................................................................................................... 3 INSTALLATION .............................................................[...]

2 INTRODUCTION STOVE BUILDER INTERNATIONAL INC., one of the most important wood stove and fireplace manufacturers in Canada, congrat ulates you on your purchase and wishes to help you get maximum satisfaction from your w ood stove. In the pages that follow, we will give you advice on wood heating and contro lled combustion as well as technical spec[...]

ASSEMBLY Legs installation: Position the stove on its back and screw the legs in place with 8 screws, 8 bolts, and 8 washers; Ash lip Installation: Screw in place with 2 bolts, 2 screws, and 2 washers. 3[...]

Cast iron flue collar installation: 1. Peel off the tape from the back of the gasket and attach the gasket to the rope groove at the back of the flue collar; 2. Mount flue collar on top of the stove. Make sure that the damper holes on each side of the flue collar are parallel to the back of the stove; 3. Fix the flue collar with the hardware suppli[...]

5 INSTALLATION SAFETY NOTICE • I F THIS STOVE IS NOT PROPERLY INSTALLED , A HOUSE FIRE MAY RESULT . T O REDUCE THE RISK OF FIRE , FOLLOW THE INSTALLATION INSTRUCTIONS . F AILURE TO FOLLOW INSTRUCTIONS MAY RESULT IN PROPERTY DAMAGE , BODILY INJURY , OR EVEN DEATH . • C ONSULT YOUR MUNICIPAL BUILDING DEPARTMENT OR FIRE OFF ICIALS ABOUT RESTRICTIO[...]

CLEARANCES FROM COMBUSTIBLES It is of outmost importance t hat the clearances to combusti ble materials be scrupulously respected upon installation of the stove you hav e selected. Refer to the tables below : Single pipe / Double pipe A B C D E F 29” 30” 39” 34-3/4” 22” 32” • Floor to ceiling height must be at least 7' (84")[...]

7 CHIMNEY Your wood stove may be hooked up with a factory built or masonry chimney. If you are using a factory built chimney, it must comply with UL 103 standards; t herefore it must be a Type HT (2100°F). It is extremely important that it be install ed according to the manufacturer's specifications. If you are using a masonry chimney, it is [...]

CHIMNEY CONNECTOR (STOVE PIPE) The stove pipe must be made of aluminized or cold roll steel with a minimum thickness of 0.021" or 0.53 mm. It is strictly forbidden to use galvanized steel. Your smoke pipe should be assembled in such a way that the male section of the pipe faces down. Attach each of the sections to one another with three equidi[...]

TYPICAL INSTALLATIONS FACTORY BUILT CHIMNEY: ROOF FLASHING 18" CLEARANCE WALL SUPPORT WALL RADIATION SHIELD RAIN CAP Wall installation CEILING SUPPORT RADIATION SHIEL D Vertical installation 9[...]

MASONRY CHIMNEY: Cl ay l i n er Thim b l e C l ea n out door 10[...]

FACTORY BUILT THIMBLE: 11[...]

BRICK THIMBLE: 12[...]

13 WOOD STOVE UTILISATION Your heating unit was designed to burn wood onl y; no other materials should be burnt. Wastes and other flammable materials should not be burnt in your wood stove. Any type of wood may be used in your stove, but spec ific varieties have better energy yields than others. Please consult the following table in order to make t[...]

14 Smaller pieces of wood will dry faster. All l ogs exceeding 6" in diameter should be split. The wood should not be stored directly on the ground. Air should circulate through the cord. A 24" to 48" air space should be left between each row of logs, which should be placed in the sunniest location possible. The upper layer of wood s[...]

15 ASH DISPOSAL Ashes should be removed from the stove ever y few days or when ashes get to 2 to 3 inches deep. Always empty the stove when it is cold, such as in the morning. Always dispose of ashes in a metal container with a tight fitting lid. Place this container on a non combustible floor or on the ground, well away from all combustible materi[...]

16 AIR CIRCULATION SYSTEM In order to improve air circul ation in the room where the wood stove is installed, certain options are available for specific stove models. Blower: A variable speed-control blower is available. The part number is AC02050. Thermodisc: The thermodisc is installed on the bl ower's electrical supply cord, and it will sta[...]

17 WARNING: • N EVERS OPERATE THE STOVE WITHOUT A GASKET OR WITH A BROKEN ONE . D AMAGE TO THE STOVE OR EVEN HOUSE FIRE MAY RESULT PAINT Only clean your stove with a dry soft clothe that will not harm the paint finish. If the paint becomes scratched or damaged, it is possible to gi ve your wood stove a brand new look, by repai nting it with a 120[...]

18 DROLET LIMITED LIFETIME WARRANTY The warranty of the manufacturer extends only to the original consumer purchaser and is not transferabl e. This warranty covers brand new products only, whic h have not been altered, m odified nor repaired since shipm ent from factory. Proof of purchase (dated bill of sale), model name and serial num ber m ust be[...]