Definitive Technology 2500 инструкция обслуживания

Congratulations on your purchase of the Definitive T echnology C/L/R 2500 Shielded Center/Left/Right Audio V ideo Loudspeaker System. This revolutionary loudspeaker utilizes state-of-the- art components (cast-basket homopolymer -coned bass/midrange drivers, moving coil ferrofluid-cooled dome high-frequency radiator , long excursion sub- woofer , in[...]

2 CAUTION! T o reduce the risk of electric shock and fire, do not remove the cover or back plate of this device. There are no user serviceable parts inside. Please refer all servicing to licensed service technicians. A vis: Risque de choc electricque, ne pas ouvrir . CAUTION! The international symbol of a lightning bolt inside a triangle is intende[...]

3 Unpacking Y our C/L/R 2500 Please Inspect For Shipping Damage Each loudspeaker leaves our plant in perfect condition. Any visible or concealed damage most likely occurred in handling after it left our plant and should be reported at once to your Definitive dealer or the delivery company that delivered your loudspeaker . Please unpack your system [...]

Rear Panel Gold Jumper High Mid Low ® CA UTION RISK OF ELECTRIC SHOCK DO NOT OPEN REPLACAE FUSE WITH SAME TYPE 1.2A 250V  A VIS  NE PAS OUVRIR U TILISER FUSIBLE DE  R ECHARGE DE MEME TYPE  1.2A 250V AC 120V 60HZ 2 50 WATT LEVEL FULL RANGE  LOW LEVEL IN P ower Automatic On/Off B AL TIMORE MD USA CLR - 2500 Center Channel T M[...]

5 Connecting Each Speaker with One Pair of Speaker Wires Only When the C/L/R 2500(s) are hooked up using simply one set of speaker wire per speaker (with no separate low-level input for the subwoofer sec- tion) a special circuit takes an infinitesimally small signal from the speaker level input and converts it to a low-level signal which then drive[...]

6 Bi- or T ri-Wiring The concept of bi- or tri-wiring is that higher sonic performance (greater inner detail, higher definition, increased transparency and improved depth) is achieved by utilizing two or three sets of wires to connect each loud- speaker to its respective channel of your amplifier or receiver . If you choose this method of hook-up, [...]

7 For tri-wiring: (See diagram # 3) Remove all the gold jumpers on the speaker and wire with separate wires to each of the low , mid and high ter- minals going to the appropriate + or - terminal of its appropriate channel of your amplifier . It is critical that all + terminals on each speaker be connect- ed to only the + terminal of its appropriate[...]

Using the Full-Range Low-Level Input for Driving the Built- In Powered Subwoofer Y our C/L/R 2500(s) has a separate RCA input jack labeled “Full Range Low Level In” which may be used to drive the built-in powered subwoofer directly from your preamp or preamp section of your receiver (if you have center channel low-level full-range output). This[...]

High Mid Low LEVEL FULL RANGE  LOW LEVEL IN Po wer Automatic On/Off When you use this low-level input to the subwoofer , it is very important to disconnect (on the speaker(s)) the gold jumper going between the + (red) mid and low , and - (black) mid and low 5-way binding posts. (There should be nothing connected to the 5-way binding posts lab[...]

10 Using Y our C/L/R 2500(s) in a Dolby Digital AC-3 System Using your C/L/R 2500 as a Center Channel in a Dolby Digital System When using your C/L/R 2500 as a center channel in a Dolby Digital system simply hook up the C/L/R 2500 to the center channel output of your system as described in the preceding section. Do not hook up a subwoofer/LFE outpu[...]

Setting Bass and T reble Contr ols on Y our Receiver or Amplifier Normally we recommend that you set the Bass and T reble controls on flat or 0 dB. This will give you the most linear and natural sound. If you want more bass, raise the subwoofer ’ s Level control on your C/L/R 2500, keeping in mind that even a little turn of the knob can make a bi[...]

VER Y IMPORT ANT : SETTING CHANNEL BALANCE AND BASS MANAGEMENT SYSTEMS Dolby Digital and Dolby ProLogic systems and decoders have a criti- cal channel balancing procedur e for the left and right fr ont speakers, center channel, r ears and subwoofer (if it is hooked up thr ough the “LFE or Sub Out” low-level connection) which must be followed if[...]

The C/L/R 2500 is supplied with brass inserts designed to go into the bottom of the speaker to hold adjustable feet which hold the speaker above the surface it is placed on as well as give you the option of angling the speaker up or down to point directly at the listeners. Install three of these inserts in the bottom of the speakers. There are pred[...]

Definitive T echnology warrants to the original retail purchaser only that this DefinitiveT echnology Loudspeaker Product (the “Product”) will be free from defects in materials and workmanship for a period of five (5) years covering the drivers and cabinets, and three (3) years for the electronic components from the date of the original purchas[...]