Dacor MOV инструкция обслуживания

Installa tion I nstru ctions Dis cove r y W al l O ven EO, MOH and MOV Series Part No. 65433 Rev . L[...]

All specifications are subject to change without notice. Dacor ® assumes no liability for changes to specifications. © 2007 Dacor , all rights reserved.[...]

1 Planning the Installation ................................................... 6 Selecting the Location ...................................................... 6 Cabinet Cutout ................................................................. 6 Electrical Specifications ................................................... 9 Installation Instructions[...]

2 Impor tant Safety Instructions • Read the accompanying use and care manual before operating this appliance. • Keep packaging materials away from children. Plastic sheets and bags can cause suffocation. • If you receive a damaged product, immediately con- tact your dealer or builder . Do not install or use a damaged appliance. Do no[...]

3 If Y ou Need Help... If you have questions or problems with installation, contact your Dacor dealer or the Dacor Customer Service T eam. For repairs to Dacor appliances under warranty call the Dacor Distinctive Service line. Whenever you call, have the model and serial number of the appliance ready . The model and serial number are printed on the[...]

4 Product Specifications Model Number A B C D E F G H EO127 27” (68.6 cm) 27 15/16” (71.0 cm) 23 3/8” (59.4 cm) 2 5/16” (5.9 cm) 7 3/8” (18.7 cm) 6 3/8” (16.2 cm) 27 3/8” (69.5 cm) 25 3/8” (64.4 cm) MOH127 MOV127 EO130 30” (76.2 cm) 28 3/8” (72.1 cm) MOH130 MOV130 EO227 27” (68.6 cm) 51 1/16” (129.7 cm) 50 ½” (128.3 cm) 2[...]

5 G D E F C 66” (167.6 cm) Flexible conduit A B 1 1/4” (3.2 cm) H Chassis notch side view Control panel front T op of chassis L K T op of chassis Utility cutout J G D E F C 66” (167.6 cm) Flexible conduit A B 1 1/4” (3.2 cm) H Chassis notch side view Control panel front T op of chassis T op of chassis Utility cutout L K J Product Specificat[...]

6 Planning the Installation Selecting the Location • Carefully check the location where the oven is to be installed. The oven should be placed for convenient access, but away from drafts that may be caused by doors, windows, and heating, ventilation and air condi- tioning outlets. • Make certain that electrical power can be provided in th[...]

7 Planning the Installation Alternate electrical locations 4“ (10.2 cm) min. between cutout Recommended electrical location 4“ typical toe kick (shown) 1“ (2.5 cm) min. to combustibles A B 3/4” (1.9 cm) support platform A B 3/4” (1.9 cm) support platform 36” T ypical (91.4 cm) 1 1/2” (3.8 cm) typical counter 1 ¾“ (4.5 cm) min. to c[...]

8 Planning the Installation Cabinet Cutout (Continued) Suppor t Platform W ARNING The top surface of the support platform must be installed flush with the cutout in the front of the cabinet or wall and any trim. Failure to install the platform properly may cause the exhaust vent to deform and/or become obstructed. An obstructed exhaust area may cau[...]

9 Planning the Installation Installation Instructions Electrical Specifications IMPORT ANT • Preheat times and cavity temperature recovery times will be increased slightly if operating on less than a 240 V ac circuit. • This appliance is provided with electrical connection leads in a flexible metal conduit. These leads may be a smaller ga[...]

10 1. Before proceeding, turn off power to the circuit to which the oven will be connected at the circuit breaker or fuse box. 2. Position the oven directly in front of the cabinet cutout. 3. Feed the appliance conduit into the electrical junction box and attach it using a UL approved strain relief. 4. Depending upon local codes, utilize one of thr[...]

11 Installation Instructions Connecting to a Three (3) W ire Electrical System - Where Local Codes Permit W ARNING Do not connect the green appliance conduit wire to the neutral (white) junction box wire unless local building codes permit. 1. Separate the wires coming out of the appliance conduit. 2. Connect the green and white wire s from the appl[...]

12 Installation Instructions Three (3) Wire Connection with External Ground Conduit to wall oven Cable from circuit breaker panel or fuse box Wire nut (4 places) Junction box Separate No. 10 min. copper grounding wire Clamp must be tight on pipe Connecting to a Three (3) W ire Electrical System with External Ground - Where Local Codes Permit (Conti[...]

13 3. Raise the door so that it is at a 15° angle from the front of the oven. Hold the door with one hand on each side. Lift the door up and out. Install the Oven in the Cabinet W ARNING • Use an appliance dolly to move the appliance when installing it or removing it from the wall for service. Use of an appliance dolly will minimize the risk [...]

14 Installation Instructions Install Exhaust Deflector CAUTION Install the exhaust deflector before installing the oven door(s). Attach the exhaust deflector to the front of the oven. It attaches to the oven just below the oven chamber in the door jam. On a double oven, the exhaust deflector is mounted below the bottom oven chamber . 1. Line up the[...]

15 Installation Instructions Installation Checklist W ARNING • T o ensure a safe and proper installation, the follow- ing checklist should be completed by the installer to ensure that no part of the installation has been over- looked. • Proper installation is the responsibility of the home- owner . The importance of proper installation of[...]

16 Notes[...]

[...]

Dacor●600 AntonBlvd.Suite1000CostaMesa,CA 92626●Phone:(800)793-0093●Fax:(626)403-3130●www .Dacor .com[...]