CrimeStopper RS-840 инструкция обслуживания

RS-840 Model REMOTE ENGINE STARTING SYSTEM OPERATING INSTRUCTIONS INTRODUCTION Congratulations on your choice of a Crimestopper CoolSt art remote engine starter! This installation Handbook covers the RS-840 Model Remote Start & Keyless Entry System. *IMPORTANT INFORMATION: Primary and Optional Features -PRIMARY: These are features that must be [...]

TABLE OF CONTENTS Operation Cautions & Warnings…….……………..….…………………………………….…………………………2 Remote Control Diagrams………...……………………………………………………………………………...…….3 Remote Engine Control…………….…..………………?[...]

REMOTE CONTROL DIAGRAM #3 #1 #2 #4 LOCK T RUNK ENGINE UNLO CK VEHICLE #2 FLA SHL IGHT (A UX.) ST A RT /ST OP RS-840 SYSTEM The transmitter supplied with the RS-840 system has a tota l of 6 buttons. The button configuration of the RS-840 is Factory-set and unchangeable. See Page 11 for additional information on how to use your remote to operate a se[...]

REMOTE ENGINE CONTROL REMOTE ENGINE STARTING - SUCCESSFUL START: 1) Press the remote start button for at least 1 second. 2) Parking lights flash once; return solid, and the Ignition/Accessory circuits turn on. 3) After a few seconds the Starter Motor engages, Parki ng lights and Accessory circuits will turn off while cranking. 4) Engine Starts and [...]

REMOTE ENGINE CONTROL ENTERING YOUR REMOTE STARTED VEHICLE: 1) With engine running, Remote Unlock system or open door with key. 2) Enter vehicle and be careful not to step on brake pedal! (Remote Start Reset) 3) Turn Ignition to ON/RUN position, then press brake pedal to reset the Remote Starter & Shift out of park. 4) Remote starter will reset[...]

REMOTE ENGINE CONTROL INFINITY RUN MODE This mode can only be activated when "Idle Down" procedure. The Infinity Run mode allows the vehicle engine to remain running INDEFINITELY after the programmed run time elapses . This mode will allow the vehicle to be left running and unattended without the ignition key in the switch preventing the [...]

TURBO TIMER MODE (OPTIONAL) The optional Turbo Timer mode allows the CoolStart syst em to keep a Turbo or Turbo Diesel vehicle running for 1 to 5 minutes [selectively] after you remove the key, exit the vehicle, and lock the doors rem otely. This is handy for turbo cool-down without the need for expensive turbo timers. This mode requires the use of[...]

CONVENIENCE AND SAFETY FEATURES KEYLESS ENTRY (POWER DOOR LOCK CONTROL, Optional) This system enables you to remotely lock and unlock the vehicle’s doors (if equipped with power locks) via remote control for safety and convenience. Note: This feature may require extra labor and/or parts to install. Press the Lock or Unlock transmitter button as y[...]

CONVENIENCE AND SAFETY FEATURES HOOD OPEN SAFETY (Requires grounding hood pin installation) This feature prevents the engine from being remote started when hood is open. Helps eliminates risk of injury to someone working under the hood of the vehicle with a properly working hood pin installed. If Remote Start button is pressed with the hood open, t[...]

TRANSMITTER PROGRAMMING TRANSMITTER PROGRAM DIAGRAM: IGN OFF WAIT F O R 4 FLA SHES PRESS 4 X's FLA SH 2, 3, or 4 X's (GRA Y WIRE GR OUNDED) IGN OFF PRESS LOCK BUTTON COMPLETE 10[...]

2-VEHICLE OPERATION The RS-840 system can be used for 2 vehicle operation. A single remote can control a second vehicle with an RS-840 or other CoolStart system installed. There are some exceptions. See “Multi-Vehicle Notes” section below. VEHICLE #2 Press low er s ide button first, then you hav e 3 seconds to control v ehicle #2. Pressing the [...]

TROUBLESHOOTING: “BEFORE YOU CALL” SECTION UNIT FLASHES LIGHTS ONCE AND WILL NOT ATTEMPT A START: The unit senses a fault at the Brake (Purple wire is active) or the Hood is OPEN (Gray wire grounded). This is a safety feature of the unit. Check installation for faults and make sure hood is closed and latched and brake wire is not active. UNIT C[...]