CrimeStopper CS-2011RS инструкция обслуживания

CS-2011RS Series IV Super Rage™ Remote Control Alarm & Remote Engine Starting System OPERATION INSTRUCTIONS INTRODUCTION CONGRATULATIONS on your choice of a Super Rage ™ Alarm & Remote Engine Starter by Crimestopper Security Products Inc. This booklet contains the information necessary for operating your system. If any questions arise, [...]

TABLE OF CONTENTS Operation Cautions & Warnings……..………..…………………………………………………………….………2 Operating Instructions - Alarm……………………………………………………….………..……………..……..3-6 LED Diagnostics………………..…………………………[...]

OPERATING INSTRUCTIONS - ALARM Active Arming / Locking: Press and release button #1 (Lock sym bol) on the transmitter. The System will arm and confirm with one siren chirp, one light flash, and the LED will begin to flash. Power locks will lock (if equipped). Starter disable circuit will turn on. After a short delay to allow the vehicle and electro[...]

OPERATING INSTRUCTIONS - ALARM Prior intrusion Alert This system will notify you if the alarm was tripped wh ile you where away. Upon di sarming, the two normal disarm chirps will be heard then the system will emit 4 additional siren chirps. Check your vehicle for any signs of a break in or tampering. Also see LED Diagnostics Section to determine t[...]

OPERATING INSTRUCTIONS - ALARM Remote AUX. Output 2 (Optional) This system contains a second auxiliary output to acti vate other accessories or devices. To activate the systems’ Second Auxiliary Output, press and hold Button #3 (Trunk Symbol) on the transmitter for more than 2 seconds. This is a momentary output that will stay acti ve as long as [...]

OPERATING INSTRUCTIONS - ALARM Optional M.A.P. (Mobile Accessories Protection) This system can be programmed to provide Crimestopper’ s unique M.A.P. (Mobile Accessories Protection) feature that allows you to prevent unauthorized access of your vehicles Audio, Cellular, Navigation, or Entertainment systems. This feature is OPTIONAL and will requi[...]

REMOTE ENGINE CONTROL REMOTE ENGINE STARTING - SUCCESSFUL START DIAGRAM: A FTER IGN 3 ST ARTER THEN FLA SH 1X SOLID SOLID SEC. ST AR T REMOTE ENGINE STARTING - UNSUCCESSFUL START In the event that the engine does not start on the firs t attempt, the system shuts down for a few seconds, then attempts to restart the engine a 2 nd and 3 rd time. For h[...]

REMOTE ENGINE CONTROL ENTERING YOUR REMOTE STARTED VEHICLE: 1) With engine running, Remote Unlock/Disarm system (If armed) or open door with key. 2) Enter vehicle and be careful not to step on brake pedal! (Remote Start Reset) 3) Turn Ignition to ON/RUN position, then press brake pedal to reset the Remote Starter & Shift out of park. 4) Remote [...]

REMOTE ENGINE CONTROL INFINITY RUN MODE This mode allows the vehicle’s engine to remain running INDEFINITELY. This mode can be beneficial to law enforcement vehicles or commercial vehicles that need to remain running unattended for long periods of time. INFINITY RUN MODE – EXITING THE VEHICLE: 1) Follow steps on the last page for “IDLE DOWN M[...]

REMOTE ENGINE CONTROL TIMED SELF START MODE This mode allows the vehicle to be programmed to self-start every 4 hours and run for the programmed run time. This can be helpful during extremely cold conditions where engine fluid freeze-up is a concern. THE VEHICLE MUST BE OUTDOORS OR IN A WELL VENILATED AREA. TIMED SELF-START MODE – EXITING THE VEH[...]

OPTIONAL TURBO TIMER MODE OPTIONAL TURBO TIMER MODE: IMPORTANT NOTE: This mode requires the use of an extra part called a momentary switch or button that is not included with the kit. Check with y our installer about adding th is feature. The optional Turbo Timer mode allows the your system to keep y our vehicle running for 1 to 5 minutes [selectiv[...]

ANTI CARJACK PROTECTION REMOTE OPERATED CARJACK PROTECTION This feature provides Active Carjack protection through the remote control. When the Ignition is on (vehicle is running), press and hold the #1 LOCK Button and #3 TRUNK Button for 2 seconds. The parking lights will flash 2 times and the LED will begin to flash rapidly to confirm the beginni[...]

TRANSMITTER PROGRAMMING Note: Remotes Transmitters come pre-programmed fr om the Factory. When re-learning remotes or adding remotes, ALL your system’s remote codes mu st be learned at time of programming!! This system allow storage of up to 4 different remote codes in memory. 1. Open hood (ground the Blue hood pin wire if no hood pin is installe[...]

2 VEHICLE OPERATION The CS-2011RS Series IV system can be used for 2 car operation. A single remote can control two independent vehicles with an identical systems installed. See diagram below on how to switch your remote to car 2 operation. Follow the “Transmitter Programming” steps on the second vehicle and learn YOUR remote, along with Car #2[...]

TROUBLESHOOTING: “BEFORE YOU CALL SECTION” Before calling your dealer or Crimestopper, read the following section for tips that may remedy or explain your problem. SYSTEM LED FLICKERS WHEN PRESSING REMOTE CONTROL BUTTONS: This is normal operation. There may be a slight flick er visible from the LED w hen pressing the remote as the system is aut[...]

ONLINE TECHNICAL SUPPORT www.crimestopper.com/techweb03.html www.crimestopper.com email@crimestopper.com Phone (800) 998-6880 FAX (805) 581-9500 © 2003 Crimestopper Security Products[...]