CDA EVM9 инструкция обслуживания

E V M9 Extr act or s Manual for Inst allation, Use and Maintenanc e Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshir e • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www .cda.eu Passionate about style[...]

Important The manufacturer cannot be held r esponsible for injuries or losses caused by inc orrect use or inst allation of this product. Please note that the manufactur er reserves the right t o invalidate the guar antee supplied with this pr oduct following incorr ect installation or misuse of the appliance or use in a commer cial envir onment. Th[...]

2 Using your Extr act or For best perf ormance, you should switc h on the extract or 1 5 minutes befor e starting to cook and lea ve it to run f or appro ximately 1 5 minutes after the end of cooking. Contr ol Panel A - Light key B - Decrease speed k ey C - Display D - Increase speed k ey E - Timer key T o switch the extr act or light on and off ?[...]

3 Car e and Maintenanc e IMPOR T ANT : DO NO T PERFORM MAINTENANCE OR CLEANING OF THE EXTRACT OR WITHOUT FIRST SWIT CHING OFF THE ELE CTRICITY SUPPL Y . Cleaning Y ou should use a nonabrasive cleaner . Any abrasiv e cleaner (including Cif) will scratc h the surface and could er ase the contr ol panel markings. Y ou can clean your extractor eff ecti[...]

4 Fig. 5 Changing the Light IMPOR T ANT : DO NO T PERFORM MAINTENANCE OR CLEANING OF THE EXTRACT OR WITHOUT FIRST SWIT CHING OFF THE ELECTRICITY SUPPL Y . DO NO T CHANGE THE LIGHT BULB IMMEDIA TEL Y AFTER USE AS THE BULB WILL BE HO T . ALL OW IT T O COOL BEFORE REM OVING IT . Carefully prise the bulb fr om the extract or using a small, flat-bladed[...]

5 DOUBLE POLE SWIT CHED FUSED SPUR OUTLET USE A 3 AMP FUSE Mains Electricity Connection THIS APPLIANCE MUST BE C ONNECTED T O THE MAINS SUPPL Y BY A C OMPE TENT PERSON, USING FIXED WIRING VIA A DOUBLE POLE SWIT CHED FUSED SPUR OUTLET AND PR O TECTED B Y A 3A FUSE. W e r ecommend that the appliance is c onnected by a qualified electrician, who is a[...]

6 Installation Y our extractor can be used to filter and r ecycle the air within your kitc hen, or to extract the air outside. When extr acting air to the outside, the unit can be vented as shown in the diagr am below . Note that we recommend the use of ducting with a diameter of 1 50mm. Ducting with diameters of 1 00mm or 1 20mm may be used, but [...]

7 Fitting your extr actor to the w all Next, remov e the top cover by loosening the scr ews (b), closing the front panel and then lifting the c over off. The extractor is mount ed using four scr ews. Ensur e that the wall fixings and scr ews are suit able for the wall mat erial. Mark the positions of the four holes on the wall, ac cording to (fig[...]

8 Fitting your extr actor to the w all Insert the 4 wall plugs in to the holes and fix 2 scr ews in the top holes so that they ar e protruding fr om the wall by appro x 5mm (fig 1 2). Next, lift the hood onto the 2 scr ews as shown in (fig1 2). Secure the t op two scr ews and fix the hood into position using screw s inserted into the 2 lower ho[...]

9 Using the extr act or as an extr action device W ork out the r equir ed height of the optional chimney for your ceiling and mount the c himney fixing brack et as shown in the (fig 1 6), then secur e the chimney as shown in (fig 1 7a). Finally , locate the chimney to the body of the extractor as shown in (fig 1 8). Fig. 1 6 Fig. 1 8 Fig. 1 7 2[...]

10[...]

Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshir e • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www .cda.eu Passionate about style T o cont act our Customer Car e Department, or f or Service, please contact us on the det ails below .[...]