Casablanca Fan Company 65GxxD инструкция обслуживания

1 CIRCUIT BREAKER (TRIP BREAKER FOR THE CIRCUIT YOU WILL BE WORKING ON) FUSE BOX (REMOVE FUSE FOR THE CIRCUIT YOU WILL BE WORKING ON) • The blad es in each pack are m atched f or equal wei ght to assur e smooth f an operati on. If mor e than one f an is being in stalled, be careful n ot to mix blades fr om differen t cartons . • In spect the co[...]

2 Calculation of 32° Use th e tear-off Ceiling Angle T emplate card inserted in th e back of this m anu al, it provi des you with a simple “g o” or “no-g o” for in stalling your f an on a sloped ceiling. SLOPED CEILING INST ALLA TIONS MOUNTING RECOMMEND A TIONS 7 ′ MINIMUM P ole Length standard standard 18” 18” 24” 36” 48” Ceil[...]

3 V ER RA Z AN O ™ PREP ARA TION INSTR UCTIONS Unpacking: Befor e assembling an d installin g your ceiling f an, rem ove all parts from th e shipping carton s and ch eck them against th e parts listed her e . Befor e discardin g packagin g materi al, be certain that all parts have been rem oved. F AN PREP ARA TION MOTO R COUPLING T APERED THREAD [...]

4 CROSSBAR MOUNTING BRA CKET INST ALLA TION JOIST CEILING WIRING CROSSBAR MOUNTING BRACKET FLA T W ASHER GREEN GROUND WIRE CEILING F AN APPROVED WIRING BOX RIDGE SIDE DOWN APPROVED OUTLET BOX HARDW ARE Note: After removing the old fi xture , check the outlet box to ensure that it is supported by a joist or beam across its upper surface . If not, a[...]

5 V ER RA Z A N O ™ CANOPY INST ALLA TION Step 4. Attach th e canopy to th e crossbar m ountin g brack et with three o f the 8-32 x 2 1 / 2 ” lon g canopy screws an d lock washers pr ovid ed with your Casablanca f an. Han d-tigh ten until sn ug against th e ceiling. CANOPY SCREW CANOPY LOCK W ASHER FEED OUTLET BOX WIRES THROUGH CANOPY OPENING N[...]

6 HANGING THE F AN Step 5. T o hang th e fan bod y in the can opy , hold th e fan body fi rmly an d insert th e nylon ball in to the can opy open- ing. Rotate f an body un til slot on nylon ball fi ts into pin opposite canopy openin g. CANOPY BAL L SLOT PIN NOTE: The f an weight is 37.5 pounds. • The fan must be supplied with thr ee independent[...]

7 V ER RA Z A N O ™ CANOPY HA TCH INST ALLA TION Step 7. T uck th e wires in to the can opy with the wir e nuts poin ted upwards , so that the WHITE an d BLACK wir es are on opposite sid es of th e canopy an d all wires are clear o f the can opy opening. Step 8. Install can opy hatch with the last canopy scr ew and lock wash er . T o do this , ti[...]

8 BLADE BLADE ROD BLADE TIP SCREW (2 PER BLADE) BLADE HARD W ARE BLADE TIP Step 10. Remove th e shipping cover fr om each of th e blade r od hold ers on the f an body . Usin g the pr ovid ed Allen wren ch, unscr ew the blad e rod h older scr ew a few turns to assure pr oper installati on of th e blade rod . Insert th e metal en d of th e blade r od[...]

9 V ER RA Z A N O ™ INST ALL LIGHT KIT BASE Step 14. Route the m otor wires thr ough the cen ter of th e ligh t kit base . Align th e ligh t kit base onto th e switch housin g using th e tabs of th e switch housin g. Usin g the thr ee switch housin g screws r emoved in Step 13, attach the li ght kit base to th e switch housin g. LIGHT KIT P AR TS[...]

10 INST ALL B ULB AND GLASS INST ALL LIGHT KIT BASE Step 15. Attach th e WHITE wire plug fr om the bulb plate to the WHITE wir e plug of th e fan. Th en at- tach the BLA CK wire plug fr om the bulb plate to the BLA CK wire plug o f the f an. The plugs have alignm ent tabs , assure th ese are ali gned —do n ot for ce the conn ection. Usin g the pr[...]

11 1. Raise the Fan slid er to incr ease fan speed , lower it to decr ease . 2. For th e fan, f our position s are available: OFF , LOW , MEDIUM, and HI GH. The bottom positi on is OFF . 3. The Li ght sli der is a dimm er , the bottom is OFF; raise to incr ease inten sity of th e ligh t. W -1811 OPERA TION W -1811 CEILING F AN/LIGHT CONTROL REVERSI[...]

12 12 TROUBLESHOO TING Befor e requesting service: Please consult this tr oubleshooting guide befor e contacting your dealer f or assistance . PROBLEM POSSIBLE REMEDIES F AN WILL NOT ST ART Check m ain circuit fuses , circuit break ers, or wall switch position. Check all wir e connecti ons, m aking sure th e power is turned off d uring this in spec[...]

13 V ER RA Z A N O ™ A UTHORIZED SER VICE CENTERS STATE/C IT Y ZI P SE RV IC E CE NT ER N AM E PHO N E T YP E COLORADO BOULDER 80306 ENERGETICTECH 303-684-7543 FFS COLORADO SPRINGS 80903 HOME LIGHTING 719-471-3520 WTS DENVER 80229 M.D ELECTRIC 303-288-7988 FFS FORT COLLINS 80525 LIGHT CENTER 970-226-3430 WTS LONGMONT 80503 ENERGETICTECH 303-684-7[...]

14 A UTHORIZED SER VICE CENTERS STATE/C IT Y ZI P SER VI C E CEN TE R N AM E PH O NE T Y PE IOW A CARROLL 51401 J & L ELECTRIC INC. 712-792-2444 ISO CEDAR RAPIDS 52404 ACME ELECTRIC COMP ANY 319-365-8677 FFS CORAL VILLE 52241 RALSTON CREEK 319-351-2189 S2W DA VENPORT 52803 SHAW ELECTRIC 563-323-361 1 FFS DES MOINES 50311 ADV ANCED LIGHTING 515-[...]

15 V ER RA Z A N O ™ STATE/C IT Y ZIP SE RV IC E CE NTE R N AM E PHO N E T YP E OHIO CANTON 44706 APPLIANCE PAR TS CO. 330-453-8077 ISO CLEVELAND 44109 WESTSIDE LIGHTING CTR. 216-459-1970 FFS COLUMBUS 43231 THE LAMP LIGHTER 614-891-7940 FFS COLUMBUS 43235 CERTIFIED SYSTEMS 614-799-0878 IHO DA YTON 45419 LARKIN ELECTRIC CO. 937-294-4115 IHO DA YTO[...]