BTC BCE5232IB инструкция обслуживания

Dual Digital Storage Drive CD-RW 5232IB User’s Manual[...]

DANGER INVISIBLE LASER RADIATION WHEN O PEN AVOID DIRECT EXPOSURE TO BEAM VORSICHT INSICHTBARE LASERSTRAHLUNG WENN ABDECKUNG GEÖFFNET NICHT DEM STRAHL AUSSETSEN ATTENTION RADIATIO N DU FAISCEAU LASER INVISIBLE EN CAS D’OUVERTURE. EVITER TOUTE EXPOSITION AUX RAYO NS. Copyright Statement It is a criminal offence, under applicabl e copyright law s,[...]

FCC Compliance Statement This device complies with Part 15 of the FCC Ru les. Operation is subject to the following two condit ions: 1. this device ma y not cause harmful i nterference, and 2. this device must accept any interferen ce received, including interference that may cause undesired operat ion. FCC Warning Statement This equipm ent has bee[...]

Table of Contents INTRODUCTION 1 S YSTEM R EQUIREMENTS 2 P ACKAGE C ONTENTS 2 INSTALLATION 3 H OST I NTERFACE C ONNECTIONS 3 H ARDWARE I NSTALLATION 4 D RIVER I NSTALLATION 6 For the CD-RW Drive 6 For the Card Reader 6 S OFTWARE I NSTALLATION 9 Windows Environment 9 CONNECTION & OPERATION 10 F RONT P ANEL 10 R EAR V IEW 12 TECHNICAL DATA 14[...]

CD-RW 5232IB 1 INTRODUCTION Thank you for the purchase of CD-RW 5232IB, a perfect and compact dual digital storage drive with the combinati on of an IDE CD-ReWritable drive and a USB-connected card reader. CD-RW 5232IB backs up all writing modes and different CD formats. It supports maximum 52x speed writing ability on CD-R discs, 32x speed on CD-R[...]

CD-RW 5232IB 2 System Requirements For IBM compatible PCs, the syst em requirements recommended are as follows: ♦ Pentium II 350MHz above with at least 64MB of memory ♦ Fast and sufficient hard disk space (minimum 200MB for installation, 1GB or more is recommended.) ♦ IDE host interface supporting ATAPI MMC command & USB host interface (i[...]

CD-RW 5232IB 3 INSTALLATION Host Interface Connections Most current motherboards have two IDE ports (primary and secondary) which can connect two IDE cables. Tw o IDE cables allow you to connect up to four devices, but it is reco mmended that you separate IDE ports for your hard disk and your CD-ReWritable dr ive. This will ensure that your hard di[...]

CD-RW 5232IB 4 Hardware Installation 1. Turn off the power to the computer system. 2. Disconnect the power cord and all cables from the back of your computer, and then remove the cover of the computer. 3. Insert the drive into one of the vacant 5.25" drive bays and secure it with screws to your PC. 4. Connect one end of the 40-pin IDE cable to[...]

CD-RW 5232IB 5 6. Connect the USB cable at the ba ck of the drive to the USB header on the computer’s motherboard. The red wire of the cable needs to be plugged into Pin 1 on the board.  This drive supports USB 2.0 and if you connect to USB 1.1 connector, only tran sfer rate of USB 1.1 will be a vailable. USB RED WIRE IDE RED WIRE MOTHER BOARD[...]

CD-RW 5232IB 6 Driver Installation For the CD-RW Drive For the CD-RW drive itself of CD-RW 5232IB, it is an IDE device supporting Plug & Play, and Windows 98SE/ME/2000/XP can automatically detect the drive and load the appropriate driver. For the Card Reader Windows 98SE/2000 If you run Window 98SE or 2000, please install the provided driver: 1[...]

CD-RW 5232IB 7[...]

CD-RW 5232IB 8 Windows ME/XP Since Windows ME and XP already have USB Mass Storage support, the card reader can be detected and wo rk fine without installing driver. However, we recommend that you in stall the provided driver to have more explicit operation status of the card reader, as described below.  For Windows XP users, please upgrade to S[...]

CD-RW 5232IB 9 Software Installation The bundled mastering software gives you the complete solution for making audio/data CDs. With the user-f riendly interface, it guides you through the creation and backup of f iles/photos/video/music from your computer to a recordable compact disc. Combining of the card reader capabilities, no matter you are a n[...]

CD-RW 5232IB 10 CONNECTION & OPERATION Front Panel 1. A-Type USB Extension Port This USB port is Plug-and-Play R eady. Just plug your USB device and the computer will detect automatically. 2. Close/Eject Button This button opens and closes the disc tray. If the tray is closed, pressing the button will eject it. 3. LED Indicator (the CD-RW drive[...]

CD-RW 5232IB 11 5. Emergency Eject Hole When the Close/Eject button doesn’t work properly and the disc tray can’t be opened, you can insert a paper clip or a small rod into this hole for manual ejection. Please make sure to power off the system before you do that. 6. Slot for Memory Stick (MS)/Memory Stick Pro (MS Pro) 7. Slot for Secure Digita[...]

CD-RW 5232IB 12 Rear View 23 4 5 6 1. Digital Audio Output Connector If your sound card has a digital audio IEC958 format connector, you can connect it to this digital audio output connector with a 2-pin audio cable. 2. Analog Audio Output Connector This connector allows you to connec t the drive to your sound card with a 4-pin audio cable. 3. Devi[...]

CD-RW 5232IB 13 6. USB Cable Connect the USB cable to the U SB connector on the motherboard. The red wire of the cable needs to be plugged into Pin 1 on the board.[...]

CD-RW 5232IB 14 TECHNICAL DATA Interface CD-RW Drive: EIDE Card Reader: USB 2.0 Form factor 5.25" Half Height Writing speed CD-R: 8X/16X/24X/32X /40X/48X/52X CD-RW: 4X/10X/12X/16X /20X/24X/32X Writing modes TAO (Track at once), DAO (Disc At Once), SAO (Session at once), Multi-session, Packet Writing Digital Media CompactFlash, MicroDrive, Memo[...]

CD-RW 5232IB 15 Access time 90ms at ⅓ stroke(52X CD-ROM) 180ms at full stroke(52X CD-ROM) 99ms at ⅓ stroke (32X CD-RW) 200ms at full stroke (32X CD-RW) Disc loading Tray (motorised), Dust Sealed Audio output level Line out = 0.6 ± 10%Vrms Power 5 VDC & 12VDC Card Reader power directly from computer power supply through USB connection Dimen[...]

CD-RW 5232IB 16 Environment Temperature Operating 5°C to 45°C Non-operating -20°C to 45°C Humidity Operating 8% ~ 80%RH Non-operating 5% ~ 95%RH[...]

[...]

3100552210 Version 1.0 Jan. 2004[...]