AEG HG654320NM инструкция обслуживания

HG654320NM IE GB EN GAS HOB USER MANUAL[...]

FOR PERFECT RESULTS Thank you for choosing th is AEG product. We have created it to give you impe ccable performance for many years, with innovative techno logies that help make life simpler – features you mi ght not find on ordinary appliances. Please spend a fe w minutes reading to get the very best from it. ACCESSORIES AND CONSUMABLES In the A[...]

CONTENTS 4 Safety information 6 Installation 12 Product description 13 Operation 14 Helpful hints and tips 15 Care and cleaning 16 What to do if… 17 Technical data 18 Environment concerns The following symbols are used in this user manual : Important information concerning your personal safety and information on how to avoid damaging the applianc[...]

SAFETY INFORMATIO N WARNING! These instructions are only valid in the countries whose symbols appear on this booklet's cover. For your safety and correct operation of the appliance, read this manual carefully before installation and use. Always keep these instructions with the appliance even if you move or sell it. Users must fully know the op[...]

• Pots must not enter the control zone. • Do not use not stable cookware to prevent from tilt and accident. • Do not put flammable products or items that are wet with flammable products, and/or fusible objects (made of plastic or aluminium) and/or fabrics in, near or on the appliance. There is the risk of explosion or fire. • Use only the a[...]

• This appliance is not connected to a combustion products evacuation device. It must b e installed and connected in accordance with current installation regulations. Particular attention must be given to the relevant requirements regarding ventilation. • The use of a gas cooking appliance cause heat and moisture in the room in which it is inst[...]

Important safety requirements This hob must be installed in accordance with the Gas Safety (Installation and Use) Regula- tions (Current Edition) and the IEE Wiring Regulations (Current Edition). For appliances installed in the Republic of Ireland please refer to NSAI - Domestic Gas Instal- lation I.S. 813 Current Editions and the ETCI Rul es for E[...]

1 2 3 1 End of shaft with nut 2 Washer 3 Elbow Connection to the gas supply should be with either rigid or semi - rigid pipe, i.e. steel or cop- per. The connection should be suitable for connecting to R 1/2 (1/2 BSP male thread). When the final connection has been made, it is essential that a thorough leak test is carried out on the hob and instal[...]

1. Light the burner. 2. Turn the knob on the minimum position. 3. Remove the knob. 4. With a thin screwdriver, adjust the by - pass screw position. 1 1 The by - pass screw – If you change from natural gas 20 mbar to liquid gas, fully tighten the adjustment screw in. – If you change from liquid gas to natural gas 20 mbar, undo the by - pass scre[...]

This hob is designed to be connected to a 230 V 50 Hz AC electrical supply . Before switching on, make sure the electri city supply voltage is the same as that indicated on the hob rating plate. The rating plate is located on the bottom of the hob. The hob is supplied with a 3 core flexible supply cord incorporating a 3 amp plug fitted. In the even[...]

Replacement of the connection cable To replace the connection cable use only H05V2V2 - F T90 or equivalent type. Make sure that the cable section is applicable to the voltage and the working temperature. The yellow / green earth wire must be approximately 2 cm longer than the brown (or black) phase wire. Building In min. 55 mm min. 650 mm 560 mm mi[...]

b) Space for connections Kitchen unit with oven The hob recess dimensions must obey the indication and the kitchen unit must be equipped with vents to let a continuous supply of air. The electrical connection of the hob and the oven must be installed separately for safety reasons and to let easy remove oven fr om the unit. 50 cm 2 360 cm 2 180 cm 2[...]

OPERATION Ignition of the burner WARNING! Be very careful when you use open fire in kitchen environment. Manufacturer decline any responsibility in case misuse of the flame Always light the burner before you put cookware. To light the burner: 1. Turn the control knob counterclockwise to the maximum position ( ) and push it down. 2. Keep the control[...]

If the burner accidentally goes out, turn the control knob to the off position and try to light the burner again after minimum 1 minute. The spark generator can start automatically when you switch on the mains, after installa- tion or a power cut. It is normal. Turning the burner off To put the flame out, turn the knob to the symbol . WARNING! Alwa[...]

CARE AND CLEANING WARNING! Switch the appliance off and let it cool down before you clean it. Disconnect the appliance from the electrical supply, before carrying out any cleaning or maintenance wo rk. WARNING! For safety reasons, do not clean the appliance with steam cleaners or high - pressure clean- ers. WARNING! Do not use abrasive cleaners, st[...]

Cleaning of the spar k plug This feature is obtained through a ceramic ignition candle with a metal electrode. Keep these components well clean to prevent difficult lighting and check that the burner crown holes are not obstructed. Periodic maintenance Periodically speak your local Service Force Centre to check the conditions of the gas supply pipe[...]

Labels supplied with the accessories bag Stick the adhesive labels as indicated below: MOD. PROD.NO. SER.NO DA T A MOD. PROD.NO. SER.NO DA T A MODEL MODEL MOD. PROD.NO. SER.NO. 03 IT MADE IN IT AL Y TYPE 230V -50Hz IP20 0049 1 2 3 1 Stick it on Guarantee Card and send this part 2 Stick it on Guarantee Card and keep this part 3 Stick it on instructi[...]

TOTAL POWER: G20 (2H) 20 mbar = 8 kW G30 (3+) 28 - 30 mbar = 567 g/h G31 (3+) 37 mbar = 557 g/h Electric supply: 230 V ~ 50 Hz 3 core flexible cable with non rewireable plug fitted with a 3 amp cartridge fuse Gas connection: G 1/2 " Category: II2H3+ Gas supply: G20 (2H) 20 mbar Appliance class: 3 By - pass diameters Burner Ø By - pass in 1/10[...]

please contact your local council, your household waste disposal service or the shop where you purchased the product. Packaging material The packaging materials are friendly to the environment and can be recycled. The plastic components are identified by marking: >PE<,>PS<, etc. Discard the packaging materials as household waste at the [...]

www.aeg.com/shop 397201801 - B - 052011[...]