2Wire AVX-7300 инструкция обслуживания

7 Inch Wide A V System Display Operation Manual A VX-7300 ENGLISH[...]

i Selecting fine audio equipment such as the unit you’ ve just purchased is only the start of your musical enjoyment. No w it’ s time to consider how you can maximize the fun and e xcitement your equipment offers. This manufacturer and the Electronic Industries Association’ s Consumer Electronics Group want you to get the most out of your equ[...]

ii For U.S. and Canadian Models About This Product Video System of a Connected Component This product is compatible with the NTSC system. When connecting other components to this product, be sure components are compatible with the same video systems. If it is not, images will not be correctly reproduced. Precaution: • This product is incompatible[...]

iii Before Using IMPORT ANT SAFEGUARDS PLEASE READ ALL OF THESE INSTRUCTIONS REGARDING YOUR DISPLA Y AND RET AIN THEM FOR FUTURE REFERENCE 1. Read this manual fully and carefully before operating your display . 2. Keep this manual handy for future reference. 3. Pay close attention to all warnings in this manual and follo w the instructions carefull[...]

5 Before Using[...]

Contents 1 Dear Customer .............................................. i For U.S. and Canadian Models .................... ii - About This Product - Important - Precaution IMPOR T ANT SAFEGUARDS ........................ iii - PLEASE READ ALL OF THESE INSTR UCTIONS REGARDING YOUR DISPLA Y AND RET AIN THEM FOR FUTURE REFERENCE Before Using .........[...]

2 Before Using This Product About This Product [For European models] Video System of a Connected Component [For models except U.S. and Canadian models] This product is NTSC/P AL system compatible. When connecting other components to this product, be sure components are compatible with the same video systems. If it is not, images will not be correct[...]

3 Before Using T o Ensure Safe Driving WARNING • T o avoid the risk of accident and the potential viola tion of applicable laws, this product is not for use with a video screen that is visible to the dri ver . • In some countries or states the viewing of images on a display inside a v ehicle ev en by persons other than the driver may be ille ga[...]

4 Before Using In Case of T rouble Should this product fail to operate properly , contact your dealer or nearest authorized Pioneer Service Station. Preventing the Battery from Becoming Exhausted When using this product, be sure your car engine is running. If you use this product when your engine is not running, the battery will become exhausted. R[...]

5 Before Using Detaching and Replacing the Front Panel Theft Protection The front panel of this product is detachable to discourage theft. When the front panel is detached, this product will not be operable as the front panel contains the Signal receptor and OPEN/CLOSE button that are necessary for opera- tion. Detaching the Front Panel • Eject t[...]

6 Before Using Key Finder The following diagram sho ws the display when it is deployed. Display V .SOURCE b utton WIDE button RGB button RESET button OPEN/CLOSE button ANGLE buttons[...]

7 Operation of the Display • T urn y our vehicle ’ s engine ON. The display will be automatically deployed by the automatic close/open mode. If the display is not automatically deployed, press the OPEN/CLOSE b utton. Note: • The automatic close/open mode will operate the display as follows. * When the ignition switch is turned OFF while the d[...]

8 Operation of the Display The angle of this product ’ s screen continues changing as long as you keep pressing the ANGLE button. • Adjust the screen to an easily viewable angle. Precaution: • If you can hear the display knocking against your vehicle ’ s console or dashboard, press the ANGLE button on the ( – ) side to mo ve the screen a [...]

9 Operation of the Display • T urn the v ehicle ’ s engine OFF . The display will be automatically closed by the automatic close/open mode. If the display does not close automatically , press the OPEN/CLOSE button. Note: • When closing the display , check to make sure that it has closed completely . If the display has stopped halfway , leavin[...]

10 Operation of the Display Y ou can select a desired mode for enlar ging a 4:3 picture to a 16:9 one. • Select the desired mode in the f ollowing order: Full (FULL) = Just (JUST) = Cinema (CINEMA) = Zoom (ZOOM) = Normal (NORMAL) Full (FULL) A 4:3 picture is enlarged in the horizontal direction only , enabling you to enjoy a 4:3 TV picture (norma[...]

11 Operation of the Display This product is equipped with two illumination colors, green and red. Y ou can select the desired illumination color . • Switch to the desired illumination color . Repeat the preceding operation to switch to the previous color . Hold for 2 seconds Switching the Illumination Color (For European models)[...]

12 Operation of the Display 7 Switching to RGB Y ou can watch videos from a component connected to this produt ’ s RGB input. • Switch to RGB. Repeat the preceding operation to switch to the previous video source. Note: • If you select the “ AV M ” video select setting in the display setting menu, video is locked to RGB. (See page 14.) 7 [...]

13 Setting the Display Entering the Display Setting Menu Perform display and picture setting with this menu. Enter the Display Setting Menu. Select the desired mode in the f ollowing order: VSEL SET = A UTO OPEN = BRIGHT = COLOR* = HUE* = DIMMER T o cancel the Display Setting Menu, press the WIDE b utton again for 2 seconds. Note: • After enterin[...]

14 Setting the Display Switching the Video Select Setting Y ou can change the video select setting. Press the WIDE button and select the video select mode (VSEL SET) in the Display Setting Menu. Switch to the desired video select setting in the f ollowing order: AU T O = MANU AL = AV M 7 AUTO When the Head Unit source is switched to a component (e.[...]

15 Setting the Display Adjusting the Bright Y ou can adjust the bright of the picture. Press the WIDE button and select the Bright mode (BRIGHT) in the Display Setting Menu. Adjust the Bright. Note: • The density of the display black can be adjusted within the range of “– 24 ” to “ +24. ” • The adjustment values are recorded separatel[...]

16 Setting the Display Adjusting the Hue Y ou can adjust the hue of the picture. Press the WIDE button and select the Hue mode (HUE) in the Display Setting Menu. Adjust the Hue. Note: • The display changes within a range from “– 24 ” to “ +24 ” as the distinction of the picture changes from reddish to greenish. • The adjustment values[...]

17 CAUTION • If moisture or f oreign matter should get inside the product, tur n OFF the power immediately and consult y our dealer or the nearest autho- rized PIONEER Service Station. Using the pr oduct in this condition may result in a f ire or electric shock, or other failure. • If y ou notice smoke, a strange noise or smell, or any other ab[...]

About the Liquid Crystal Display (LCD) Screen • If the display is near the vent of an air conditioner when it is deployed, mak e sure that air from the air conditioner is not blowing on it. Heat from the heater may break the LCD screen, and cool air from the cooler may cause moisture to form inside the display resulting in possible damage. Also, [...]

19 Appendix Appendix Specifications General Power source .... 14.4 V DC (10.8 – 15.1 V allowable) Grounding system .................................. Negativ e type Max. current consumption ...................................... 4 A Dimensions (DIN) (chassis) ...... 180 (W) × 50 (H) × 160 (D) mm [7-1/8 (W) × 2 (H) × 6-1/4 (D) in] (nose) .....[...]

20 Appendix[...]

[...]

[...]

PIONEER CORPORA TION 4-1, MEGURO 1-CHOME, MEGURO-KU, T OKYO 153-8654, JAP AN PIONEER ELECTRONICS (USA) INC. P .O. Box 1760, Long Beach, California 90801, U.S.A. TEL: (800) 421-1404 PIONEER EUROPE NV Haven 1087, Keetberglaan 1, B-9120 Melsele, Belgium TEL: (0) 3/570.05.1 1 PIONEER ELECTRONICS AUSTRALIA PTY . L TD. 178-184 Boundary Road, Braeside, Vi[...]