Zanussi ZQS 6124 manual

REFRIGERA TOR ZQS 6124 INSTRUCTION BOOKLET 2222 683-38[...]

2 It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transf erred to another owner , or should you mo ve house and leave the appliance, alwa ys ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the ap[...]

Instructions for the User Important Safety Instructions . . . . . . . . . . . . . . . .2 Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 Before use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 Setting the temperature . . . . . . . . . . . . . . . . . . . . . .4 Fresh food refrigeration . . . . . . . . [...]

Operation The door shelves T o permit storage of food packages of various sizes the half tray can be adjusted in horizontal. T o do this proceed as figure. For more thorough cleaning, the top door shelf and the bottle shelf can be removed by pulling them in the director of the arrows, then refitting them in position. 4 Fresh food refrigeration T o [...]

5 The -st ar comp artment This compartment is suitable for freezing fresh food, for the storage of commercially frozen food and for ice cube making. Freezing fresh food T o freeze fresh foods it is not necessary to change the setting of the thermostat knob. However , for a quicker freezing operation, turn the thermostat knob to the coldest setting;[...]

Because of consumer demand, preservatives have been removed from many pre-prepared foods. This together with the changes in shopping habits to a once-a-week shop, mean that safe handling and storage of food is even more important than ever . The following tips should help you to ensure that the food in your home is in as perfect condition as possib[...]

7 Defrosting The refrigerator automatically defrosts every time the compressor stops. The water is discharged, via the pipe, into a tray located below the appliance, where it evaporates. Important T o avoid defrost water overflowing and dripping onto the food in the fridge, periodically clean the water discharge hole (F) situated under the salad dr[...]

When the appliance is not in use When the appliance is not in use for long periods, disconnect from the electricity supply , empty all foods and clean the appliance, leaving the door ajar to prevent unpleasant smells. 8 Maintenance and Cleaning W arning Before any maintenance or cleaning work is carried out, DISCONNECT the appliance from the ELECTR[...]

9 Something not W orking? Before contacting your local Service Force Centre check the following points. IMPORT ANT : If you call out an engineer to a fault listed below , or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. Symptom Solution No power to appliance The light does[...]

10 Service and Sp are Parts In the event of your appliance requiring service, or if you wish to purchase spare part s, please contact your local Service Force Centre by telephoning:- 08705 929929 Y our telephone call will be automatically routed to the Service Force Centre covering your post code area. For the address of your local Service Force Ce[...]

11 St andard guarantee conditions We, Zanussi, undertake that if within 12 months of the date of purchase this Zanussi appliance or any p art thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour , materials or carriage on condition that: • [...]

Positioning The appliance should only be installed at a location where the ambient temperature corresponds to the climate classification indicated on the rating plate, which is located on the inside right of the appliance. The following table shows which ambient temperature is correct for each climate classification. SN +10°C to +32°C ST +18°C t[...]

13 Door reversal T o reverse the opening direction of the door , proceed as shown in the figures: Attention After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitt[...]

14 Inner door reversal 180°[...]

15 If you fit your own plug, the colours of the wires in the mains lead of your appliance, may not correspond with the markings identifying the terminals in your plug, proceed as follows: Connect the Green and the Y ellow (earth) wire to the terminal in the plug which is marked with the letter «E» or the earth symbol , or coloured green and yello[...]

Building-in instructions 16 Before carrying out any work, remove the plug from the power socket. Grid prep aration Left door opening: Remove the left side (A) of the grid cutting it from the rear (see figure). Right door opening: Remove the right side (B) of the grid cutting it from the rear (see figure). T o position the grid on the appliance proc[...]

B 4 1 5. Screw appliance into place and retain the cabinet with screws (I) through the securing brackets into the worktop or adjacent woodwork as necessary . 4. The joint cover (B) is to be assembled after having installed the appliance in the recess. 2. Push the appliance into place. The plug socket necessary for connection of the appliance to the[...]

18 7 ab c C cli c k cli c k 8 b = = 9 I c Möbeltür Innenseite a Upper part of kitchen furniture panel I 27,5 cm 27,5 cm 55 cm 10 F 1 2 3 45 ° 11 = = 10 12 1 2[...]

Fitting the plinth Important For the efficient operation of the appliance, it is important that the original ventilation grid is used. • For an opening height dimension A=820 mm and a plinth height dimension a=100 mm, the plinth may be fitted without adjustments. The same applies to an opening height dimension B=890 mm and a plinth height dimensi[...]

© Electrolux plc 2008 www .electrolux.com www .zanussi-electrolux.co .uk[...]