Weslo WLTL421010 manual

Serial Number Decal Model No. WLTL421040 Serial No. CAUTION Read all precautions and instruc - tions in this manual before using this equipment. Save this manual for future reference. QUESTIONS? If you have questions, or if there are missing parts, we will guar- antee complete satisfaction through direct assistance from our factory. TO A VOI D DELA[...]

T ABLE OF CONTENTS IMPORTANT PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 BEFORE YOU BEGIN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 ASSEMBLY . . . . .[...]

1. It is the responsibility of the owner to ensure that all users of this treadmill are adequately informed of all warnings and precautions. 2. Use the treadmill only as described in this manual. 3. Place the treadmill on a level surface, with at least eight feet of clearance behind it and two feet on each side. Do not place the treadmill on any su[...]

4 22. When folding or moving the treadmill, make sure that the storage latch is fully closed. 23. Never drop or insert any object into any opening. 24. DANGER: Always unplug the power cord immediately after use, before cleaning the treadmill, and before performing the main- tenance and adjustment procedures de- scribed in this manual. Never remove [...]

5 Thank you for selecting the WESLO ® CARDIO PACER TM treadmill. The CARDIO PACER treadmill combines advanced technology with innovative design to let you enjoy an excellent form of cardi ovascula r ex- ercise in the convenience and privacy of your home. And when you’re not exercising, the innovative CAR- DIO P ACER treadm ill can be folded up, [...]

15 15 28 29 29 24 24 24 24 12 12 19 19 19 19 1 1. Make sure that the power cord is unplugged. Orient the Base (28) so the holes for the four Base Pads (19) are on top. Open part bag A. Attach the four Base Pads to the Base with the four 3/4" Tek Screws (24). Attach the two Wheels (15) to the Base (28) with two 2" Bolts (12) and two Wheel [...]

7 3. Raise the Uprights (6, 17) to the vertical position. Place the Frame (55) between the Uprights as shown. Feed the Wire Harness (22) into the large round hole in the lower end of the Right Upright (6) and out of the indi- cated hole. Note: It may be helpful to use needlenose pli- ers to pull the end of the Wire Harness out of the hole. 22 22 6 [...]

8 5. Hold a Handrail (32) near the Right Upright (6). Feed the Wire Harness (22) into the hole near the lower end of the Handrail and out of the hole near the upper end of the Handrail. Note: It may be helpful to use needlenose pliers to pull the end of the Wire Harness out of the hole. 5 32 22 22 6 6. Open part bag C. Hold the Handrail (32) with t[...]

58 17 Knob Spring Collar Pin 10. Press the Latch Housing (58) into the Left Upright (17). Remove the knob from the pin. Make sure that the collar and the spring are on the pin as shown. Insert the pin into the Latch Housing, and tighten the knob back onto the pin. See step 2. Lower the Uprights (6, 17). Tighten the four 3” Bolts (30). Raise the U[...]

10 OPERA TION AND ADJUSTMENT THE PRE-LUBRICATED WALKING BELT Your treadmill features a walking belt coated with high- performance lubricant. IMPORTANT: Never apply sil- icone spray or other substances to the walking belt or the walking platform. Such substances will deteriorate the walking belt and cause excessive wear. HOW TO PLUG IN THE POWER COR[...]

1 1 DIAGRAM OF THE CONSOLE Clip Key Speed Control Monitor Displays with the nega tive (–) ends of the batteries touching the springs. Close the battery cover, push up on the tab, and then push the tab forward as shown. Make sure that the tab locks into place. STEP-BY-STEP CONSOLE OPERATION Before operating the console, make sure that the power co[...]

12 Insert the key fully into the console. Inserting the key will not turn on the displays. The displays will turn on when the ON/RESET button is pressed or when the walking belt is started. Note: If batteries were just installed, the displays will already be on. Reset the speed control and start the walking belt. Turn the speed control to the RESET[...]

13 HOW TO CHANGE THE INCLINE OF THE TREADMILL To vary the intensity of your exercise, you can change the incline of the treadmill. There are four incline lev- els. Before changing the incline, remove the key and UNPLUG THE POWER CORD. Next, fold the treadmill to the storage position (see HOW TO FOLD THE TREADMILL FOR STORAGE on page 14). To change [...]

14 HOW T O FOLD AND MOVE THE TREADMILL HOW TO FOLD THE TREADMILL FOR STORAGE Unplug the power cord. CAUTION: You must be able to safely lift 20 kg (45 lbs.) to raise, lower, or move the treadmill. 1. Hold the treadmill with your hands in the locations shown at the right. CAUTION: To decrease the possibility of in- jury, bend your legs and keep your[...]

15 HOW TO LOWER THE TREADMILL FOR USE 1. Hold the upper end of the treadmill with your right hand as shown. Using your left hand, pull the latch knob to the left and hold it. Pivot the treadmill down until the frame is past the latch pin. Slowly release the latch knob. 2. Hold the treadmill firmly with both hands, and lower the treadmill to the flo[...]

16 MAINTENANCE AND TROUBLESHOOTING Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please call our Customer Service Department toll- free at 1-866-699-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays). P[...]

17 PROBLEM: The walking belt slows when walked on SOLUTION: a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 10. b. If the walking belt is overtightened, treadmill perfor- mance may decrease and the walking belt may be- come damaged. Remove the key and UNPLUG THE POWER CORD . Using the allen wrench[...]

18 CONDITIONING GUIDELINES The following guidelines will help you to plan your ex- ercise program. For more detailed exercise informa- tion, obtain a reputable book or consult your physician. EXERCISE INTENSITY Whether your goal is to burn fat or to strengthen your cardiovascular system, the key to achieving the desired results is to exercise with [...]

19 WORKOUT GUIDELINES Each workout should include the following three parts: A Warm-up Start each workout with 5 to 10 minutes of stretching and light exercise. A proper warm-up increases your body temperature, heart rate, and circulation in prepa- ration for exercise. Training Zone Exercise After warming up, increase the intensity of your exer- ci[...]

P ART LIST—Model No. WL TL421040 R0904A Key No. Qty. Description 1 1 Console 2 1 Speed Control 3 1 Key/Clip 4 1 Choke 5 6 Electronics Screw 6 1 Right Upright 7 13 3/4" Screw 8 1 Battery Cover 9 1 Motor Tension Bolt 10 2 6 1/2" Bolt 11 2 1-lb. Weight 12 8 2" Bolt 13 1 Left Frame Spacer 14 2 3-lb. Weight 15 2 Wheel 16 1 Right Frame S[...]

16 10 22 10 13 28 24 19 29 12 12 15 29 64 15 30 30 64 1 1 69 14 3 19 24 24 19 19 24 17 42 6 42 18 22 63 63 7 7 7 7 7 8 1 2 80 79* 12 42 12 42 37 58 37 78* 32 32 20 20 71 21 21 21 27 74 24 51 66 67 24 57 55 52 56 52 34 54 26 49 53 50 27 26 75 66 51 67 46 24 48 72 33 33 68 68 36 43* 44 45 29 52 24 25 23 24 38 76 41 24 24 61 5 60 62 73 35 5 71 21 21 2[...]

Part No. 218358 R0904A Printed in USA © 2004 ICON IP, Inc. ORDERING REPLACEMENT P ARTS To order replacement parts, call our Customer Service Department toll-free at 1-866-699-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays). When ordering parts, please be prepared to give the following information: • The MODEL [...]