United States Stove B2350B manual

 Models B2350 and B2350B Wonderluxe THERMOSTAT CONTROLLED DUAL FUEL CIRCULATOR SERIES  If this heater is not properly installed, a house re may result. To reduce the risk of re, follow the installation instructions. Contact local building or re ofcials abou[...]

  TOOLS • Pencil • Measuring Tape or 6 foot rule • Tin Snips • Drill and 1/8” dia. bit • Gloves • Screwdriver (Blade type) • 5/16” Nut Driver or 5/16” Socket w/Ratchet MATERIALS • Chimney Connection- 6” Diameter Black Steel pipe (24 gauge minimum) [...]

8. CAST IRON PARTS MUST BE “SEASONED” TO AVOID CRACKING. BUILD ONLY SMALL FIRES ON FIRST USE. 9. To prevent injury, do not allow anyone to use this heater who is unfamiliar with the correct operat ion of the heater. Do not allow children to use or in any way operate this heater. CAUTION: DO NOT TOUCH THE HEATER UNTIL IT HAS COOLED. ALWAYS WEAR [...]

   AS A LOCATION IS SELECTED, KEEP THE FOLLOWING MIND: 1. The chimney connecti on should be as airtight as possible. The heater must have its own chimney ue. Do not connect this unit to a chimney ue serving another appliance. If there is no chimney near where you wish to place the heate[...]

 Two basic types of chimneys are approved for use with solid fuel: Factory-built and ma- sonry. Factory-built chimney must comply with UL 103 type “HT” standard. Do not expect your stove or furnace to create draft. Draft is not a function of the appliance. It is purely a function of the chim[...]

You r wo od stove may be ho ok ed up wit h a 6” factory built or masonry chimney. If you are using a factory built chimney, it must comply with UL 103 standard; therefore it must be a Type HT (2100°F). It is extremely important that it be installed according to the manufacturer’s specications. If you are using a masonry chimney, it is impor[...]

When a metal prefabricated chimney is used, the manufacturer’s installation instructions must be followed. You must also purchase (from the same manufac- turer) and install the ceiling support pack- age or wall pass-through and “T” sec- tion package, restops (where needed),   i[...]

  Many people may wish to convert an existing replace to heater use. Usually, safe con- nection of stovepipe to a masonry chimney requires more effort than connection to a prefabricated chimney. The replace must be closed and sealed at the damper in the ue. Good sealan[...]

 Masonry Chimneys have several positive attributes: If properly built, they are quite durable, and most homeowners consider them more attractive perhaps than a non- enclosed factory built chimney. And, if the chimney is located within the connes of the house (that is, not attached to an exterior wall)[...]

 continued... Ensure that a masonry chimney meets the minimum standards of the National Fire Protection Association (NFPA) by having it inspected by a professional. Make sure there are no cracks, loose mortar or oth- er signs of deterioration and blockage. Have the chimney cleaned before the stove is [...]

 Method A. 12” (304.8 mm) Clearance to Com- bustible Wall Member: Using a minimum thick- ness 3.5” (89 mm) brick and a 5/8” (15.9 mm) minimum wall thickness clay liner, construct a wall pass-through. [...]

MACHINE SCREW CABINET DOOR KNOB   The cabinet door knob is mounted on the inside of the cabinet door to facilitate shipping and must be removed and re- installed for proper usage. To get the cabinet door open, place your hand under the cabinet frame (right hand side of th[...]