Minuteman UPS MBK-E SERIES manual

User's Manual MBK-E SERIES[...]

1 © Copyright Para Systems, Inc., 2003 MBK-E Series User's Manual 1 . Introduction 2 2 . Controls and Indicators 5 3. Installation 7 4. Operation 9 5 . T roubleshooting 1 1 6 . Replacing the Battery 12 7 . Obtaining Service 15 8 . Specifications 16 9 . Configurable Parameters & Settings 17 10. Limited Product W arranty 18 1 1. Declaration[...]

2 IMPORT ANT SAFETY INSTRUCTIONS SA VE THESE INSTRUCTIONS ! English Thank you for purchasing a MINUTEMAN power protection product. It has been designed and manufactured to provide many years of trouble free service. Please read this manual before installing your MBK-E Series UPS, models MBK550E, MBK750E, as it provides important information that sh[...]

3 CAUTION! T o reduce the risk of electrical shock in conditions where the load equipment grounding cannot be verified, disconnect the UPS from the AC wall outlet before installing a computer interface cable. Reconnect the power cord only after all signaling connections are made. CAUTION! Connect the UPS to a two pole, three wire grounding AC wall [...]

4 English Para Systems Life Support Policy As a general policy , Para Systems Inc. (Para Systems) does not recommend the use of any of its products in life support applications where failure or mal- function of the Para Systems product can be reasonably expected to cause failure of the life support device or to significantly affect its safety or ef[...]

5 On-Line On-Battery Boost English On-Line/On-Battery/Boost LED Overload LED Weak/Bad Battery LED On/Off/T est Button Fault LED Press and release the ON/OFF/T est Button after 1 beep to turn the UPS ON or OFF (see section 4). The On-Line/On-Battery and Boost (green) LED illuminates in a steady state when the UPS is on and supplying AC power to the [...]

6 REAR P ANEL English 5 4 3 2 1 9 8 6 7 1. The Information/Rating Label. 2. The Battery Backup and Surge output power receptacles are NEMA 5-15R type. 3. The USB Communications Interface Port is for UPS monitoring and control. 4. The Surge ONL Y output power receptacles are NEMA 5-15R type. 5. The Dipswitches are for setting the Inverter output vol[...]

7 INST ALLA TION PLACEMENT The MBK-E series is intended to be install in a temperature controlled environ- ment that is free of conductive contaminants. Select a location which will pro- vide good air circulation for the UPS at all times. Avoid locations near heating devices, water or excessive humidity , or where the UPS is exposed to direct sunli[...]

8 English DO NOT plug Power Strips or Surge Protection Devices into the ”Battery Backup” Receptacles on the UPS. Plugging Power Strips or Surge Protection Devices into the “Battery Backup” Receptacles may cause internal damage to the UPS, the Power Strip, or the Surge Protection Device. W ARNING! CHARGING THE BA TTER Y The MBK-E Series UPS [...]

9 English TURNING THE UNIT ON/OFF ON / OFF / T est Button SELF TEST Press and release the ON/OFF/T est Button after one beep to turn the UPS ON and supply power to the load. The load is immediately powered while the UPS runs a two-second self test. Press and release the ON/OFF/T est Button after one beep to turn the UPS OFF . The UPS will continue [...]

10 English COMMUNICA TIONS PORT The MBK-E series comes standard with a USB communication port. NOTE: See the SentryII CD for the Power Monitoring Software installation. See the USB Driver CD for the USB installation. ALARMS ON BA TTER Y When the UPS is operating on the batteries, the On-Battery LED will blink and the audible alarm will sound once e[...]

11 English Possible Cause Symptom What T o Do Press and release the On/Off/ T est button to start UPS On/Off/T est button not pushed UPS will not turn on Reset circuit breaker by pressing the plunger back in. If the AC circuit breaker trips after UPS starts up, reduce the load on the UPS UPS operates in battery mode only , even though there is norm[...]

12 English REPLACING THE BA TTER Y The MBK-E Series UPS has an easy to replace hot-swappable batteries. Please read all of the W ARNING and CAUTIONS before attempting to service the batteries. NOTE: If there is a power interruption while replacing the hot-swappable batteries, with the UPS on, the load will not be backed up. W ARNING! This Uninterru[...]

13 English BA TTER Y REPLACEMENT PROCEDURE PLEASE READ THE CAUTIONS AND W ARNINGS BEFORE A TTEMPTING TO REPLACE THE BA TTERIES Hot-swappable batteries mean that the batteries can be replaced without powering down the whole UPS system. NOTE: If there is a power interruption while replacing the hot-swappable batteries, with the UPS on, the load will [...]

14 English 9. Disconnect the positive (red) wire from the battery positve terminal. 10. Disconnect the battery negative (black) wire from the battery negative terminal. NOTE: Use CAUTION, do not touch the battery positive wire to the battery negative wire. 1 1. Remove the battery bracket retaining screw and slide the battery bracket upwards. 12. Us[...]

15 English IF THE UPS REQUIRES SERVICE 1.Use the TROUBLESHOOTING section to eliminate obvious causes. 2.V erify there are no circuit breakers tripped. A tripped circuit breaker is the most common problem. 3.Call your dealer for assistance. If you cannot reach your dealer , or if they cannot resolve the problem call or fax MINUTEMAN T echnical Suppo[...]

16 English Default 120V AC (User selectable at 120/127V AC) 2-4 years, depending on discharge cycles and ambient temp 550V A/330W 750V A/450W 500 J 0 ns (instantaneous) normal mode; <5 ns common mode <5% Normal and common mode EMI/RFI suppression 1-12V7Ah 2-12V7Ah Audible noise at 1 m (3 ft.) Electromagnetic immunity <45 dBA Runtime: Full [...]

17 English (These items may require optional software or hardware) Function Factory Default Description User Choices Set inverter output voltage Set audible alarm state Enable/ Disable auto restart Battery life in days Battery install date UPS ID MBK-E Date of manufacture 1826 Enabled Enabled 120V AC Up to 64 characters to define the UPS Date of ba[...]

18 English Para Systems Inc. (Para Systems) warrants this equipment, when properly applied and operated within specified conditions, against faulty materials (ex- cluding batteries) or workmanship for a period of three years from the date of purchase. Para Systems Inc. (Para Systems) warrants the batteries for a period of two years from the date of[...]

19 English EXCEPT AS PROVIDED ABOVE, IN NO EVENT WILL P ARA SYSTEMS BE LIABLE FOR DIRECT , INDIRECT , SPECIAL, INCIDENT AL, OR CONSEQUEN- TIAL DAMAGES ARISING OUT OF THE USE OF THIS PRODUCT , EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. Specifically , Para Sys- tems is not liable for any costs, such as lost profits or revenue, loss of equip- [...]

20 DECLARA TION OF CONFORMITY Application of Council Directive(s): 89/336/EEC, 73/23/EEC Standard(s) to which Conformity is declared: EN50091-1-1, EN50091-2 Manufacturer’s Name: Para Systems, Inc. (MINUTEMAN UPS) Manufacturer’s Address: 1455 LeMay Drive Carrollton, T exas 75007 USA T ype of Equipment: Uninterruptible Power Supplies (UPS) Model [...]

21 Notes: English[...]

22 English Notes:[...]

23 Page do not print[...]

Para Systems, Inc. 1455 Lemay Dr . Carrollton, TX 75007 Phone: 1-972-446-7363 Fax: 1-972-446-901 1 Internet: minutemanups.com UPS Sizing: sizemyups.com PN - 34000227 Rev . 0[...]