Logitek Standard Elec. Cable Manufacturing C/A210 manual

INST ALLA TION AND OPERA TION MANUAL W ARNINGS • Hot! Do not touch! The glass and surfaces of this appliance will be hot during operation and will retain heat for a while after shutting off the appliance. Severe burns may result. • Carefully supervise children in the same room as appliance. Retain These Instructions For Future Reference A F ren[...]

2 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. C ontents t esting i nforma tion .........................................................................3 g eneral s afety P reCautions ................................................................3 D rafting ................................................................................[...]

3 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. t esting i nforma tion This manual describes the installation and operation of the Performer™ C/A210 non-catalytic wood heaters. These heaters meet the U.S. Environmental Protection Agency’ s emissions limits for wood heaters sold on or after July 1, 1990. This heater has been developed, t[...]

4 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. D rafting Y our wood stove is dependent upon a properly functioning chimney for optimum per formance. It is a high efficiency appliance that loses much less heat up the chimney than older applian ces and firep laces. For this reason it is important to match the stove to the chimney . The chi[...]

5 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Please be patient with the heat output of your stove for the first few weeks. The steel will go throu gh a curing process that eliminates moisture, which is deep in the steel and firebrick. This moisture will reduce initial heat output of your stove and may make it difficult to start. After[...]

6 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. B riCk i nst alla tion P erformer ™ C/a210 B riCk i nst allation CAUTION: Wear gloves during brick installation in case of sharp edges behind the stove. Note: Installation of the baffle bricks and insulating blanket is easier when you can still access the flue outlet, (before connecting th[...]

7 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Model F (1) G H J(2) M C/A210 18” 45 0m m 12-1/4” 31 1m m 19 ” 48 3m m 4-1/2” 1 14m m 42 -1 /8 ” 10 70 m m C/A210 w/ mantel and/or side shields u 18” 45 0m m 12-1/4” 31 1m m 19 ” 48 3m m 4-1/2” 1 14m m 34-1/8” 86 7m m * Reduced clearances may be available for A, B, C and D [...]

8 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. C himney r equirements The Performer™ C/A210 inserts are approved for use in masonry fireplaces built to UBC Chapter 37 or equivalent with a minimum 22” (559mm) opening at the front of the fireplace. These heaters are designed to be installed into an existing masonry fireplace (built to[...]

9 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. i nst alla tion P roCeDure - f aCtor y -B uil t Z ero C learanCe f irePlaCes Fireplace and Chimney Requirements The Performer™ C/A210 insert must only be installed in a zero clearance factor y-built fireplace using 6” (152mm) stainless steel pipe extending from the insert’ s flue into [...]

10 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Chimney Liner Installation Remove the existing chimney cap and install a stainless steel liner into the chimney (if a special section has been used or drilled to attach to the insert, it must be the bottom piece). The next piece should be a dripless slip joint, followed by the rest of the chi[...]

11 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. o Pera ting h ints 1. Burn only dr y , well-seasoned wood for maxi- mum heat output. In some states it is illegal to burn wet wood or anything other than clean, dry wood products. 2. Y our stove is designed to operate with the door closed! Operate only with the door shut tightly at all times [...]

12 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. s t arting anD m aint aining a f ire Be sure to clean the Nickel or Gold Plated door with Win- dex brand cleaner and a ver y soft cloth to remove any fingerprints and residues prior to the first fire. 1. NEVER USE FLAMMABLE LIQUIDS TO ST ART OR REKINDLE A SOLID FUEL FIRE!! 2. Fully open th[...]

13 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Keeping freshly loaded wood away from the window will also help. Load fresh logs in the rear of the firebox. Build-up tends to occur first on the right side of the window . This is caused by the swirling motion of the exhaust gases similar to water running down a drain. Keep fresh logs furt[...]

14 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. 4. Operate your stove as much as possible in the low to medium burn ranges. 5. Do not lower the draft setting so low as to compl etely extinguish the flames in the firebox. Check for at least some small flames 20 minutes after setting the draft control. 6. Do not continually operate your s[...]

15 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Exp eri men t with diff ere nt loa din g config ura tio ns to achi eve longer burns. T r y loading the wood from side to side and nesting it in the ashes to prevent airflow under and around the wood. Fresh wood should be loaded to the back of the firebox or to the sides. Hot coals or half [...]

16 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. t rouBleshooting Problem Solution POOR DRAFT : Extend chimney in length or have the chimney realigned to the proper size flue. Oversized chimneys normally have poor drafts. Remember , the stoves’ draft depend solely on the natural draft of the chimney (See Drafting section on page 4). If y[...]

17 D o ’ s anD D on ’ ts DO NOT : Install or operate this stove before reading this manual. DO NOT : Close the draft beyond the point at which the flames are completely extinguished. DO NOT : Open the stove door without fully opening the draft first. DO NOT : Burn driftwood or wood that has been in salt water . This includes some mill ends an[...]

The manufacturer reser ves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products. Consult your local distributor for fireplace code information. 1110 West T aft Avenue • Orange, CA 92865 Printed in U.S.A. © 2007 by Lennox Hearth Products P/N 775,2[...]