Jura Capresso X95 manual

IMPRESSA X90/ X95 Instructions for use 3/03 Art. Nr. 63721[...]

Legend:  DISPLAY: serves as information.  DISPLAY: please follow the instructions shown. = Note = Important = Tip Jura Impressa X90/X95 English ............................................................................................................. 6 – 22 Jura Elektroapparate AG, CH-4626 Niederbuchsiten, Internet http://www.juraworld.c[...]

Fig. 1 Fig. 4 Fig. 2 Fig. 9 Fig. 3 Fig. 7 Fig. 13 A B Fig. 8 1 2 3 Fig. 10 Fig. 11 Fig. 12 Fig. 6 Fig. 5[...]

7 8 9 17 18 12 13 14 15 16 19 10 11 20 22 21 6 5 4 3 21 23 D C B A E F G H[...]

Instructions for use 1 Drip tray / residual water container 2 Drip tray cover 3 Cover for programming keys 4 Coffee key for 2 large cups 5 Coffee key for 1 large cup 6 Coffee key for 2 small cups 7 Coffee key for 1 small cup 8 Key for special coffee 9 ON/OFF switch 10 Rinsing key 11 Display dialogue system 12 Water tank with carrying handle 13 Cove[...]

6 T able of contents 1. Description ........................................................ page 7 2. Safety instructions .............................................. page 7 2.1 Warnings ................................................... page 7 2.2 Safety precautions ........................................ page 7 3. Check before use ..........[...]

7 Important information for the user Thank you for choosing this Jura product. Please study these instructions carefully before using your new machine and keep them in a safe place for easy reference in the future. Should you require further information or should particular pro- blems occur that are not dealt with in these operating instructions in[...]

8  If using acidic decalcifying agents be sure to immediately re- move any splashes and drops from delicate surfaces, especially natural stone and wooden surfaces, or take corresponding pre- cautions. 3. Check before use 3.1 Checking mains voltage The machine is set for the correct voltage before leaving our factory. Ensure that your mains volta[...]

9  Place a container under the coffee-spout (15) and press rinsing key .  UNIT RINSING  COFFEE READY 4.2 Cup illumination The cup illumination puts your coffee in a good light, making it a treat for the eyes. When you switch on the machine or press any key, the cup illumi- nation is activated for 3 minutes. To switch on the cup illuminati-[...]

10 7. Use of Claris filter cartridges Under proper implementation of Claris filter cartridges, decalcifying of the machine becomes unnecessary. For further information, please read the brochure “Claris. Tough to calcium deposits, gentle to your coffee machine“. 7.1 Placing filter  Pull up cartridge mounting. Pressing lightly, place the filte[...]

11  UNIT RINSING  COFFEE READY  Put 1, respectively 2 cups under the coffee-spout and press the required key. The pre-brew system (I.P.B.A.S. © ) moistens the coffee powder, briefly interrupts the flow and then starts the real brewing process. You can interrupt the flow of coffee at any time by simply pressing any of the coffee keys. To o[...]

12  Place a cup under the steam/frothing nozzle (20) and immerse the frothing aid in the milk to be frothed or the liquid to be heated.  Press steam portion draw-off key .  STEAM PORTION  You can stop the draw-off operation at any time by pressing the steam draw-off key .  COFFEE READY 11. Connecting the Profi-Auto-Cappuccino/ Caffè[...]

13 13. Programming Before leaving our factory, the machine is adjusted to enable you to obtain coffee without any additional programming. In order to adapt the result to your personal taste, various settings can be pro- grammed individually. The programming keys are located behind the front cover (3). The following settings can be programmed:  P[...]

14  By pressing the button, you can select the next phase, or press the button in order to leave the programming. 13.4 Programming steam portion  STEAM PORTION  Press key .  PORTION /....20 SEC.  By pressing key or you can programme time in seconds (drawing off time of 3 – 250 sec.)  Press key .  STEAM PORTION  By pressing[...]

15 ECONOMY MODE OFF means that the stand-by-status for steam is set to 20 minutes and the heating for the cup warming tray is on. After 10 minutes the warning lamp goes out. By pressing the steam key anew, the machine returns to stand-by-status for drawing off steam. 13.9 Programming timer clock A programming of the timer clock is necessary if an a[...]

16 13.14 Program key By using key you can set back the following settings (powder quantity, coffee temperature, water quantity, steam portion, tea portion) to their original standard settings.  COFFEE READY  Press key until you can hear an acoustic signal. If a mistake occurs while programming one of the above settings, just press key and the[...]

17 14.6 Clean machine  CLEAN UNIT After coffee, etc., has been drawn off 220 times or after 180 rinsing programs have been run, the machine must be cleaned. You can continue to draw off coffee and hot water / steam. However we recommend that you clean the machine (as described in chapter 15) within the next few days.  CLEAN NOW An acoustic si[...]

18  Switch on your machine by pressing ON/OFF key  Press key until you can hear an acoustic signal.  EMPTY TRAY (FILL WATER might show as well) Put a sufficiently large container under the coffee-spout (15) in order to prevent cleaning liquid from running into the drip tray.  ADD TABLET (Fig. 9) / PRESS CLEANING  UNIT CLEANING / PLEA[...]

19  FILL WATER  Place a container under the pivoting nozzle (20).  OPEN TAP  PRESS CALC  UNIT DECALCIFIYING / PLEASE WAIT  Place a container under the height-adjustable tea-spout (22).  PRESS CALC  UNIT DECALCIFIYING / PLEASE WAIT  CLOSE TAP  UNIT DECALCIFIYING / PLEASE WAIT  Inside the machine the water is conducte[...]

20 19. Messages Cause Action FILL WATER Water tank is empty Top up with water Water level indicator in tank is jammed Empty tank, rinse out, fill up and replace Tank is calcified, water level indicator is stuck Remove tank, decalcify, rinse well, fill up with water and replace FILL BEANS Bean container is empty Top up with beans Message still displ[...]

21 Cause Action CLEAN UNIT You have drawn off coffee 220 times or run Clean as described in chapter 14.6 the rinsing program 180 times Message still displayed, although machine Run cleaning program again; this time do not cleaned add cleaning tablet UNIT CALCED The espresso/coffee machine sector needs Run decalcifying program as described in decalc[...]

22 Problem Cause Action Not enough froth while – Frothing nozzle blocked – Clean frothing nozzle frothing up milk – Clean Auto-Cappuccino – Clean Profi Auto-Cappuccino/Caffè Latte – as described in chapter 11.2 If the above mentioned problems and/or messages still persist, please contact your dealer or get in touch directly with Jura Ele[...]