Hampton Bay 165 474 manual

Glendale 52 in Ceiling F an Owner ’s Manual Glendale Ventilador de Techo de 1,32 m Manual del Propietario 165 474[...]

52” Glendale Ceiling Fan by Hampton Bay Date Purchased Store Purchased UL Model No. Serial No. V endor No. UPC Thank you for purchasing our ceiling fan. This product has been manufactured with the highest standards of safety and quality . T able of Contents Safety Rules . . . . . . . . . . . . . . . . . . . . 1 Unpacking Y our Fan . . . . . . . .[...]

Safety Rules – Read and Save These Instructions 1 To reduce the risk of electric shock, insure electricity has been turned off at the circuit breaker or fuse box before beginning. All wiring must be in accordance with the National Electrical Code “ANSI/NFPA 70-1999” and local electrical codes. Electrical installation should be performed by a [...]

2 Unpacking Your Fan Unpack your fan and check the contents. You should have the following items: AB C 1 2 4 6 8 9 7 5 3 D Set of blades (5) Canopy assembly Ball/downrod assembly Fan motor assembly Set of blade arms (5) 1. 2. 3. 4. 5. Light kit Glass shades (3) 13 Watt compact fluorescent bulbs (3) Pull chain and fobs (2) 6. 7. 8. 9. Blade Attachme[...]

3 Installing Your Fan Figures 1~3 are examples of different ways to mount the outlet box. Phillips screwdriver, straight slot screwdriver, step ladder and wire cutters. If there isn't an existing UL listed mounting box, then read the following instructions. Disconnect the power by removing fuses or turning off circuit breakers. Secure the outl[...]

4 4 REMEMBER to turn off the power. Follow the steps below to hang your fan properly. NOTE: This ceiling fan is supplied with two types of hanging assemblies; the standard ceiling installation using the downrod with ball and socket mounting, and the "close-to-ceiling" mounting. The "close-to-ceiling" mounting is recommended in r[...]

5 Option 2: Close-to-Ceiling Mounting WARNING FAILURE TO COMPLETELY TIGHTEN THE THREE SCREWS IN STEP 7 COULD RESULT IN FAN LOOSENING AND POSSIBLY FALLING. Figure 10 Motor Collar Screw and Lock Washer (3 of 6 Places) Remove the canopy ring from the canopy. (Figure 5) Remove the mounting bracket from the canopy by loosening the four screws on the top[...]

6 Installing Fan to the Electrical Box WARNING THE TAB AS SHOWN IN FIGURE 12 IS ONLY TO BALANCE THE FAN WHILE ATTACHING WIRING. FAILURE TO HANG AS SHOWN IN FIGURE 12 MAY RESULT IN TAB BREAKING CAUSING THE FAN TO FALL. TAB MUST PASS FROM INSIDE TO OUTSIDE OF CANOPY. WARNING WHEN USING THE STANDARD BALL/ DOWN- ROD MOUNTING. THE TAB IN THE RING MUST R[...]

7 Making the Electrical Connections WARNING CHECK TO SEE THAT ALL CONNECTIONS ARE TIGHT, INCLUDING GROUND, AND THAT NO BARE WIRE IS VISIBLE AT THE WIRE NUTS. EXCEPT FOR THE GROUND WIRE. WARNING ELECTRICAL DIAGRAMS ARE FOR REFER- ENCE ONLY. OPTIONAL USE OF ANY LIGHT KIT SHELL BE UL LISTED AND MARKED SUITABLE FOR USE WITH THIS FAN. Connect the fan mo[...]

8 Finishing the Fan Installation Standard Ceiling Mounting WARNING MAKE SURE THE TAB ON THE HANGING BRACKET PROPERLY SITS IN THE GROOVE IN THE HANGER BALL BEFORE ATTACHING THE CANOPY TO THE BRACKET BY TURNING THE HOUSING UNTIL IT DROPS INTO PLACE. WARNING LOCKING SLOTS OF CEILING CANOPY ARE PROVIDED ONLY AS AN AID TO MOUNTING. DO NOT LEAVE FAN ASSE[...]

9 Attaching the Fan Blades Attach blades to blade arms using three screws with fiber washers. (Fig. 17) Start a screw into the blade arm, do not tighten. Repeat for the 2 remaining screws and washers. Tighten each screw securely starting with the center screw. Make sure the blade is straight. Repeat steps for the remaining blades. Fasten the blade [...]

10 Blade Balancing Figure 19 Check that all blade and blade bracket screws are secure. Most fan wobble problems are caused when blade levels are unequal. Check this level by selecting a point on the ceiling above the tip of one of the blades. Measure from a point on the center of each blade to the point on the ceiling. Measure this distance as show[...]

11 Installing the Light kit CAUTION BEFORE STARTING INSTALLATION, DISCON- NECT THE POWER BY TURNING OFF THE CIRCUIT BREAKER OR REMOVING THE FUSE AT FUSE BOX. TURNING POWER OFF USING THE FAN SWITCH IS NOT SUFFICIENT TO PREVENT ELECTRIC SHOCK. NOTE LIGHT BULBS HAVE NO WARRANTY; CAN BE PURCHASED AT ANY HOME DEPOT STORE. While holding the light kit und[...]

12 Operating Your Fan Warm weather - (Counter Clockwise Direction) A downward air flow creates a cooling effect as shown in Figure 22. This allows you to set your air conditioner on a higher setting without affecting your comfort. Cool weather - (Clockwise Direction) An upward air flow moves warm air off the ceiling are as shown in Figure 23. This [...]

13 WARNING MAKE SURE THE POWER IS OFF AT THE ELECTRICAL PANEL BOX BEFORE YOU ATTEMPY ANY REPAIRS. REFER TO THE SECTION, “MAKING ELECTRICAL CONNECTIONS”. Because of the fan's natural movement, some connections may become loose. Check the support connections, brackets, and blade attachments twice a year. Make sure they are secure. (It is not[...]

14 Specifications FAN SIZE SPEED VOLTS AMPS WATTS RPM CFM N.W. G.W. C.F. 52” 120 8.5 kgs (18.7 Ibs) 9.2 kgs (20.2 Ibs) 1.71’ LOW MED. HIGH 0.21 0.38 0.51 12 35 63 65 115 160 1800 3700 5450 These are approximate measures. They do not include Amps and Wattage used by the light kit .[...]

15 The Hampton Bay warrants the fan motor to be free from defects in workmanship and material present at time of shipment from the factory for a period of lifetime after the date of purchase by the original purchaser. Hampton Bay also warrants that all other fan parts, excluding any glass or acrylic blades, to be free from defects in workmanship an[...]