Enviro EG-40 manual

SHERWOOD INDUSTRIES IS AN ENVIRONMENTALLY RESPONSIBLE COMPANY THIS MANUAL IS PRINTED ON RECYCLED PAPER By SHERWOOD INDUSTRIES EG-40 Fireplace Insert Vented Room Heater OWNERS MANUAL Installation And Operating Instructions For Model:- EG-40 FPI. BV. WHAT TO DO IF YOU SMELL GAS • Open windows/Extinguish any open flame • Do not try to light any ap[...]

SAFETY PRECAUTIONS FOR SAFE INSTALLATION AND OPERATION OF YOUR "ENVIROGAS" ROOM HEATER, PLEASE, CAREFULLY READ THE FOLLOWING INFORMATION: • All "ENVIROGAS" gas-fired appliances must be installed in accordance with these instructions. Carefully read all the instructions in th is manual first. Consult the building authority havi[...]

TABLE OF CONTENTS 1 Code Appr ovals ..................................................................................................... 3 2 Specific ations ......................................................................................................... 3 3 Assembly and Insta llation Instru ction ..........................................[...]

3. ASSEMBL Y AND INST ALLA TION INSTRUCTIONS PREPARATION FOR INSTALLATION • Remove the packaging from the appliance, surround panels and log set, check to make sure there is no damage. Carefully check the glass door. Do not use the unit if it is damaged. In the event damage is found please report it to both the courier and your dealer as soon as [...]

4.DECIDING WHERE TO LOCATE YOUR STOVE DIMENSIONS: A. Mantle pillar to stove 10"/ 25 cm B. Stove to 8" wide mantle 12"/ 31 cm Stove must sit on a non-combustible surface, the width and depth of the insert Maintain sufficient clearances for operation, service and maintenance OTHER DIMENSIONS A. Depth of unit into fireplace 17"/ 43[...]

VENT TERMINAL CLEARANCES A= Clearance above grade, verandah, porch, deck, or [balcony (*12 inches (30 cm) minimum] B= Clearance to window or door that may be opened [*12 inches (30 cm) minimum] C= Clearance to permanently closed window [minimum 12 inches (30 cm) recommended to prevent condensation on window] D= Vertical clearance to ventilated soff[...]

5. VENTING WARNING; THIS APPLIANCE HAS BEEN DESIGNED TO OPERATE BY DRAWING COMBUSTION AIR AND DILUTION AIR FROM THE ROOM. IT IS ALSO DESIGNED TO DRAW ROOM AIR FOR PROPER HEAT CIRCULATION FROM THE SIDES OF THE UNIT. BLOCKING OR MODIFYING THE LOUVERS IN ANY WAY CAN CREATE HAZARDOUS SITUATIONS, EITHER THROUG H POOR VENTING OR BY OVERHEATING. IT IS IMP[...]

6. INSTALLATION OF LOG SET and EMBERS INSTALLING THE GLOWING EMBERS A bag of ceramic fiber embers is provided for use on the front burner ember tray. CAUTION: Use only the type of ember material supplied with this appliance. Due to the irregular size of the ember material there may be more than required. Use only a single layer. Do not pile embers.[...]

7.OPERATING INSTRUCTIONS FOR YOUR SAFETY READ BEFORE OPERATING WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIO NS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE , PERSONAL INJURY OR LOSS OF LIFE. A) This appliance is equipped with a pilot, which must be lit by hand by following thes e instructions exactly. B) BEFORE LIGHTING smell a[...]

8. ROUTINE MAINTENANCE Periodically check to ensure that the "B-Vent" venting system is clear and that a negative draft is present when the unit is operating. Periodically check the pilot and burner flames CLEANING OF GLASS Do not clean glass w hen hot It will be necessary to clean the ceramic glass periodically. During a cold start up co[...]

9. TROUBLE SHOOTING Problem Cause Solution Spark will not light the pilot after repeated pressing of spark ignitor Defective ignitor Check connections to ignitor -If ignitor connections are good but there is no spark- replace ignitor Miss aligned spark electrode -Check for spark arcing from the electrode to pilot if not adjust by loosening screws o[...]

10. GAS LINE CONNECTION ORIFICE SIZES, PRESSURE AND BTU’S NATURAL GAS PROPANE GAS FRONT BURNER #48 (1.93 mm) #55 (1.32 mm) REAR BURNER #41 (2.49 mm) #54 (1.40 mm) Manifold pressure. 3.8” w c (.95 kpa) 11” w c(2.74 kpa) Min. Manifold pressures. 1.1” w c (.27 kpa) 2.7” w c(.67 kpa) Supply Pressure. 7.0” w c (1.74 kpa) 12” w c (2.98 kpa)[...]

11. ELECTRICAL REQUIREMENTS The ENVIROGAS EG-40 FPI. BV. will operate without an external electrical pow er supply. This model has a Millivolt gas control which uses the pilot flame to generate enough electricity to operate the main burners. The appliance when installed, must be electric ally connected and grounded in accordance with local codes or[...]

12. PARTS AND ACCESSORIES Service Parts available from y our local Envirogas Dealer Burner Control Assembly Natural Gas Pilot Assembly Propane Pilot Assembly Door Bolt Relief Door Gasket Regulating Valve Piezo Igniter Burner Switch B-vent Spill switch 300 ° F(149 ° C) MR. Orifice Blank Convection Blower Light Bulb Holder Light Switch (momentary) [...]

• There is a separate air shutter for each burner. • Remove one screw from the cove r plate located below the ash shelf. Loosen the other screw (do not remove) sw ing the cover plate out of the way and tighten screw dow n to hold it in place. • With along screwdriver rotate spring clips to open or close the shutter to the desired setting. •[...]

16 13. WARRANTY Sherwood Industries Ltd. offers a *Lifetime Warranty on this gas product. The lifetime warranty covers the appliance for a period of seven years from the date of in stallation. This warranty applies only to the original owner in the original location Covered under the lifetime warranty are Cabinet Sides , Tops, Pedestals, Surround P[...]

14. INSTALLATION DATA SHEET The installer for warranty purposes and future reference must record the following information. Model: EG 40 FPI Name of Owner: __________________________________________ Address: __________________________________________ __________________________________________ __________________________________________ Phone:_______[...]