Dacor DYF428IWS manual

Part No. 107201 Rev . A/W10539432 Discover y ™ Built-In Refrigerator 42 and 48 Inch Models: DYF42BIWS, DYF48BIWS Installation Instructions[...]

© 2012 Dacor , all rights reserved. All specifications subject to change without notice. Dacor assumes no liability for changes to specifications. T able of Contents Customer Ser vice Infor mation If you have questions or problems with installation, contact your Dacor ® dealer or the Dacor Customer Service T eam. For repairs to Dacor appliances u[...]

1 Refrigerator Safety W ARNING Tip Over Hazard Refrigerator is top heavy and tips easily when not completely installed. Keep doors taped closed until refrigerator is completely installed. Use two or more people to move and install refrigerator. Failure to do so can result in death or serious injury. Important information to know about disposal of r[...]

2 Location Requirements Y our Dacor refrigerator can be recessed in an opening between cabinets or installed at the end of a cabinet run using a side panel to enclose the refrigerator . IMPORT ANT :  Observe all governing codes and ordinances.  It is recommended that you do not install the refrigerator near an oven, radiator , or other heat s[...]

3 Electrical Requirements Before you move your refrigerator into its final location, it is important to make sure you have the proper electrical connection. Recommended Grounding Method A 1 15 V olt, 60 Hz., AC only 15 or 20 Amp. fused, grounded electrical supply is required. It is recommended that a separate circuit serving only your refrigerator [...]

4 Installation Requirements If the water pressure to the reverse osmosis system is less than 40 to 60 psi (276 to 414 kPa):  Check to see whether the sediment filter in the reverse osmosis system is blocked. Replace the filter if necessary .  Allow the storage tank on the reverse osmosis system to refill after heavy usage.  If your refrige[...]

5 Product Dimensions Side View:  The depth from the front of the top grille to the back of the refrigerator cabinet is 25 ³⁄ 8 ” (64.5 cm).  The power cord is 84” (213.3 cm) long.  Height dimensions are shown with leveling legs extended ¹⁄ 8 ” (3.2 mm) below the rollers. * When the leveling legs are fully extended to 1¼” (3.[...]

6 130 ˚ 130 ˚ 90 ˚ 90 ˚ 110 ˚ 110 ˚ 51 3 ⁄ 8 " (130.5 cm) 44 " (111.8 cm) 19 1 ⁄ 4 " (48.9 cm) 14 3 ⁄ 8 " (36.5 cm) 39" (99.1 cm) 43 7 ⁄ 8 " (111.4 cm) Door Swing Dimensions The location must permit both doors to open to a minimum of 90°. Allow 4½” (1 1.4 cm) minimum space between the side of the refr[...]

7 Custom Side Panels Custom side panels may be needed when not enough space is available to have cabinets on both sides of the refrigerator or when the refrigerator is placed at the end of a cabinet run. Y ou may choose an inset, flush or recessed inset panel installation. Refrigerator and Side T rim Dimensions The width and height of a side panel [...]

8 Unpack Refrigerator IMPORT ANT :  If you receive a damaged product, immediately contact your dealer or builder . Do not install or use a damaged appliance.  Do not remove the film on the outside until the refrigerator is in its operating position.  All four leveling legs must contact the floor to support and stabilize the full weight of [...]

9 Install Anti-T ip Boards IMPORT ANT :  T o avoid tipping during use, the solid soffit must be within 1” (2.5 cm) maximum above the refrigerator . If the solid soffit is higher than 1” (2.5 cm) or one is not available, then the refrigerator must be braced.  It is recommended that board(s) be installed before the refrigerator is installed[...]

10 Installation Instructions Connect W ater Supply (cont.) Connecting to Refrigerator Parts Supplied: ¼” to ¼” (6.4 mm to 6.4 mm) male to male coupling. NOTE: The flexible codes approved water supply line can connect to the supply valve through the floor or through the side cabinets, as indicated by the gray boxes above. 1. Unplug the refrige[...]

11 W ARNING Tip Over Hazard Refrigerator is top heavy and tips easily when not completely installed. Keep doors taped closed until refrigerator is completely installed. Use two or more people to move and install refrigerator. Failure to do so can result in death or serious injury. 3. Continue adjusting all of the leveling legs to raise the refriger[...]

12 5. After adjusting, check the doors to make sure they are even at the top and bottom. If the doors are not even, continue to turn the bushing to adjust the door height. 6. Replace the locking plate. 7. T urn the bushing slightly to align the hinge and locking plate screw holes. 8. Replace the door stop screw or screws and tighten. 9. Make a fina[...]

13 5. Using the two screws, attach the base grille assembly to the refrigerator as shown. NOTE: Drive in the right side screw first. 4. T rim the skirt by scoring the proper “V” groove with a utility knife. Break the skirt at the score line. 3. Snap the skirt onto the base grille. Install Side Panel(s) If the built-in area depth is 25” (63.5 [...]

14 Complete Installation 1. T urn the water supply line valve to the “Open” position. 2. T urn the refrigerator switch to the ON position. See Power On/ Off Switch in the use and care manual for instructions. W ait a few minutes. Check the water line connections for leaks. 3. Remove all boxes, parts packages and packing materials from the inter[...]

[...]

Dacor ● 14425 Clark Avenue, City of Industry , CA 91745 ● Phone: (800) 793-0093 ● Fax: (626) 403-3130 ● www .dacor .com[...]