Char-Broil 10201600 manual

Product Guide Model 10201600 T ools needed for assembly: Pliers Adjustable wrenches FOR OUTDOOR USE ONL Y CA UTION: Read and follow all safety statements, assembly instructions, and use and care directions before attempting to assemble and cook. INST ALLER/ASSEMBLER: Leave this manual with consumer . CONSUMER: Keep this manual for future reference.[...]

D ANGER Safety Symbols The symbols and boxes shown below explain what each heading means. Read and follow all of the messages found throughout the manual. DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury . WARNING W ARNING: Indicates a potentially hazardous situation which, if not avo[...]

1. Brush all interior surfaces including grills and grates with vegetable cooking oil. 2. Build a small fire on the fire grate, being sure not to lay coals against the walls. 3. Close door . (Position butterfly damper and smokestack damper approximately at one quarter open.) This burn should be sustained for at least two hours, the longer the bette[...]

THE HEA T OF THE COALS seconds you can hold the palm of your hand 4 inches above the coals temperature range (Fº) visual cues HOT COALS 2 400 to 450 barely covered with gray ash; deep red glow MODERA TEL Y HOT 375 to 450 thin coating of gray ash; deep red glow MODERA TEL Y HOT COALS 4 325 to 375 significant coating of gray ash; red glow MODERA TEL[...]

GRILL MAINTENANCE Frequency of cleanup is determined by how much your smoker is used. Make sure coals are completely extinguished before cleaning inside of smoker . Inside surfaces may be cleaned with a strong solution of detergent and water applied with a scrub brush. Thoroughly rinse with water and allow to air dry before using again. HELPFUL HIN[...]

LIMITED W ARRANTY 6 SCOPE OF COVERAGE PERIOD OF COVERAGE TYPE OF F AILURE COVERAGE PERFORA TION, MANUF ACTURING, AND MA TERIAL DEFECTS ONL Y All Parts 90 days from date of purchase* This warranty only applies to units purchased from an authorized retailer . Manufacturer warrants to the original consumer -purchaser only that this product shall be fr[...]

Key Qty Description A 1 Axle B 1 Pull Handle C 3 Wire Fire Grate D 1 Firebox Door Latch E 2 Large Cast Iron Cooking Grate F 1 Small Cast Iron Cooking Grate G 1 Smoke Chamber Assembly H 1 Firebox Assembly I 1 Smokestack Assembly J 2 Short Leg Assembly Key Qty Description N 1 Butterfly Damper Assembly O 2 Handle Rod P 2 Handle Barrel Spring --- 1 Har[...]

2 1 ASSEMBL Y 8 FIRST , GET A HELPER! This unit is heavy and requires a second person for lifting and moving. NEXT , pick a suitable location to work. Open the carton and slit the corners so that the carton lays flat. This will give you a protective surface during assembly . Remove the carton packing material and the parts from inside the firebox a[...]

3 4 9 Attach short legs to remaining leg sockets near firebox using 3/8-16x3/4” hex-head bolts . Do not fully tighten. T ighten bolt just enough to keep leg from sliding off of socket . With unit still in position from previous steps, insert long legs over leg sockets closest to the floor . Secure each leg to socket using a 3/8-16x3/4” hex-head[...]

5 6 10 Insert hitch pin through the hole at one end of the axle. Slide a 7/16" flat washer onto the axle, then a wheel, then another 7/16" flat washer . Slide the axle through the bushings on the bottom of the short legs. At the end of the axle add a 7/16" flat washer , wheel, another 7/16" flat washer and finally the hitch pin [...]

8 7 1 1 Insert a Hitch Pin into the hole at one end of an axle rod. Hold handle between handle brackets on smoke chamber door and slide rod through brackets and handle. Insert another Hitch Pin at opposite end of handle rod. Repeat these steps to assemble handle to firebox door . Handle bracket Handle bracket Hitch pin Handle Hitch pin Axle Rod Hit[...]

10 9 12 Attach the smokestack to the left side of the smoke chamber by sliding smokestack into receiver tube. Secure smokestack in vertical position using one hexhead bolt. 3/8-16x1” Slide the pull handle into the bushings on the left side of the smoke chamber . Pull Handle 3/8-16x1” hex-head bolt Qty . 1 Smoke Stack 3/8-16x1” hex-head bolt[...]

1 1 12 13 Attach front shelf to smoke chamber by sliding ends of shelf frame into bushing on front of smoke chamber . Front Shelf Place one fire grate in the bottom of the firebox and the two remaining fire grates in the bottom of the smoke chamber . Place the smaller cooking grate onto grate supports in the firebox and the two larger cooking grate[...]

14 NOTES[...]

[...]

20 REGTEMP REV00[...]