Chamberlain 2000SDR 1/2 HP manual

TM The Chamberlain Group, Inc. A DUCHOSSOIS ENTERPRISE 845 Larch Avenue Elmhurst, Illinois 60126-1196 For Residential Use Only Garage Door Opener Model 2000SDR 1/2 HP Model 1000SDR 1/3 HP Complies with UL 325 regulations effective January 1, 1993 ® ■ Please read this manual and the enclosed safety materials car efully! ■ Fasten the manual near[...]

Start by re viewing these important safety alert symbols: 2 Safety alert symbol re view ............................................2 Safety information and precautions ..............................3 T esting your garage door for binding & balance ..........3 Hardware supplied ........................................................3 Carton in[...]

3 An unbalanced garage door might not rever se when required and someone under the door could be seriously injured or killed. If your gara ge door binds, sticks or is out of balance, call for pr ofessional garage door service . Garage doors, door springs, cables, pulle ys, brackets, and their har dware are under extreme tension and can cause seriou[...]

4 Straight Door Arm Section Curved Door Arm Section Header Bracket UP CEILING MOUNT ONLY 2-Conductor Bell Wire White & White/Red Sprocket Coupling Light Lens Rail Brackets Trolley Safety Labels and Literature Remote Control Transmitter Visor Clip Rail Assembly Door Bracket Model 2000SDR Lighted Door Control Button Model 1000SDR SECURITY ✚ Sin[...]

Y ou may find it helpful to r efer back to this page as you proceed with the installation of your opener . Safety Reversing Sensor Horizontal and vertical reinforcement is needed for lightweight garage doors (fiberglass, steel, aluminum, door with glass panels, etc.). See page 20 for details. Support bracket & fastening hardware is required. Se[...]

ASSEMBL Y STEP 1 Fasten the Rail T o the P ower Unit 6 The Chamberlain Group, Inc. Screw Drive LM 114A1794 Attaching Rail Assembly & Coupling to Chassis 6/9/94 - 6/18/94 - 10/19/9 12/7/94 Rail Sprocket Rail Assembly Trolley Coupling Rail/Power Unit Bracket Lock Nuts 1/4"-20 Power Unit Sprocket Opener Chassis F[...]

ASSEMBL Y STEP 3 Attach the Rail Brackets 7 IMPORT ANT INST ALLA TION INSTRUCTIONS T o r educe the risk of severe injury or death to persons: 1. READ AND FOLLOW ALL INST ALLA TION INSTRUCTIONS 2. Install only on a properly balanced and lubricated garage door . An improperly balanced door may not reverse and could result in severe injury or death. R[...]

• Open your door to the highest point of trav el as shown. Dra w an inter- secting horizontal line on the header wall 3" abo ve the high point. This height will provide tra vel clearance for the top edge of the door . Header Wall Ceiling Sectional door with curved track One-piece door with horizontal track Track Highest Point of Travel Door [...]

Header Wall Vertical Centerline Vertical Centerline of Garage Door 2x4 Unfinished Ceiling Structural Supports 2x4 Header Support OPTIONAL CEILING MOUNT FOR HEADER BRACKET • Close the door and mark the inside vertical centerline of your garage door . Extend the line onto the header wall above door . If headroom clearance is minimal, you can instal[...]

Lag Screws 5/16"x9x1-5/8" Highest Point of Travel (of Garage Door) Vertical Center Line Header Wall Garage Door UP CEILING MOUNT ONLY Wall Mounting Holes Optional Wall Mounting Holes The nail hole is for positioning only. You must use lag screws to mount the header bracket. UP CEILING MOUNT ONLY Door Spring Header Bracket 2x4 Structural S[...]

Header Bracket Rail Bracket Foam Packaging Opener Carton or Temporary Support Header Wall Garage Door Rail Clevis Pin 5/16" x 2-3/4" Ring Fastener Clevis Pin 5/16"x2-3/4 " Ring Fastener Header Bracket Rail Bracket Rail • Position the opener on the garage floor below the header bracket. Use packing material as a protective base[...]

Without a properly working safety reversing sensor, persons (particularly children) could be injured or killed by a closing garage door. Read and follow all instructions. To protect small children, install the safety reversing sensor so that the beam will be no higher than 4"-6" above the garage floor. Disconnect power to the garage door [...]

Installation Step 4 Install the Safety Reversing Sensor (Receiving and Sending Eyes) FLOOR MOUNT (Right Side) WALL MOUNT (Right Side) DOOR TRACK MOUNT (Right Side) Indicator light Lens Lip Sensor Brack et Door T rac k Sensor Brack et Optional Extension Bracket (See Accessories) Lens Indicator light Attach with concrete anchors (not provided) Inside[...]

14 Installation Step 4 (Continued) Install the Safety Reversing Sensor Invisible Light Beam Protection Area Sensor Sensor Bell Wire Foam Packaging Carton 2. Run wires along channels to power unit and pull taut. 1. Run wires from sensors to end of rail at the door header. Cross & twist here to help contain wires in channels on top of rail. 3. Th[...]

Installation Step 5 P osition the Opener Follo w instructions which apply to y our door type as illustrated. T o pre vent dama g e to steel, alumin um, fiber glass or glass panel door s, do not rest the opener on the door without using a 2x4. SECTIONAL Door or ONE-PIECE Door with T rack A 2x4 laid flat is con venient f or setting an ideal door - to[...]

Installation Step 6 Hang the Opener T wo repr esentative installations are shown. Y ours may be different. Hanging brackets should be angled, Figure 1, to provide rigid support. On finished ceilings, Figure 2, attach a sturdy metal bracket to structural supports before installing the opener . The bracket and fastening har dwar e ar e not supplied. [...]

Installation Step 7 Install the Door Control and Connect all Wiring 17 DO NO T CONNECT T O LIVE ELECTRICAL WIRING. CONNECT ONL Y T O 24 V OL T LO W V OL T AGE WIRES. CONNECTION T O LIVE WIRES OR HIGHER V OL T AGE MA Y CA USE SERIOUS INJUR Y FROM SHOCK, BURN OR ELECTR OCUTION. Children operating or playing with a garage door opener can injure themse[...]

T o reduce the risk of electric shock, your garage door opener has a grounding type plug with a third grounding pin. This plug will only fit into a grounding type outlet. If the plug doesn't fit into the outlet you have, contact a qualified electrician to install the proper outlet. If permanent wiring is requir ed by your local code, refer to [...]

Installation Step 10 Install the Lights and Lens Installation Step 1 1 Attach the Manual Release Rope and Handle Do not use the red handle to pull the door open or closed. The rope knot could become untied and you could fall. Use the manual release only to disengage the trolley and, if possible, only when the door is closed. Garage doors are heavy.[...]

Installation Step 12 Fasten Door Bracket Follow instructions which apply to your door type as illustrated below or on page 21. T o prevent dama ge to steel, aluminum, fiberglass or glass panel doors, al ways reinfor ce the inside of the door both vertically and horizontally with an angle ir on. A horizontal brace should be long enough to be secured[...]

Horizontal and vertical reinforcement is needed for lightweight garage doors (fiberglass, aluminum, steel, door with glass panel, etc.). (Not Provided) Header Wall Vertical Centerline of Garage Door Finished Ceiling Optional Placement of Door Bracket Header Bracket Door Bracket 2x4 Support For a door with no exposed framing or for the optional inst[...]

Installation Step 13 Connect Door Arm to T rolle y F ollow instructions which apply to your door type as illustrated below and on page 23. Make sur e garage door is fully closed. Pull the emergency release handle to disconnect the outer tr olley from the inner trolley . Slide the outer trolley back (away from the door) about 2" as sho wn in Fi[...]

All ONE-PIECE Doors Assemble the Door Arm: • Fasten the straight and curved door arm sections together to the longest possible length (with a 2 or 3 hole overlap). • W ith the door closed, connect the straight door arm section to the door bracket with the 5/16"x1-1/4" clevis pin. • Secure with a ring fastener . Nuts 5/16"-18 Lo[...]

Adjustment Step 1 Adjust the UP and DOWN Limits Do not make any limit adjustments until the safety reversing sensors ar e completely installed. 24 Limit adjustment settings regulate the points at which the door will stop when moving up or down. The door will stop in the up direction if anything interferes with door travel. The door will r everse in[...]

Adjustment Step 2 Adjust the Force Too much force on the door will interfere with the proper operation of the safety reverse system. The door might not reverse properly when required and could seriously injure or kill someone under it. Do not increase the force beyond the minimum amount required to close the door. Do not use the force adjustments t[...]

Adjustment Step 4 T est the Safety Reverse System T est • Place a one-inch board (or a 2x4 laid flat) on the floor , centered under the garage door . • Operate the door in the down direction. The door must reverse on striking the obstruction. Adjustment If the door stops on the obstruction, it is not traveling far enough in the down direction. [...]

The Remote Control T ransmitter The opener must learn the code of any ne w remote control. Page 29 e xplains how to program your recei ver and ho w to erase all codes if required. Self service of your recei ver and remote controls is not recommended. If service is needed, call the toll-free number listed on the back page. The T ransmitter Battery T[...]

28 Activate the opener with any of the following: • The Remote Contr ol T ransmitter . Hold push button down until the door starts to move. • The Door Contr ol. Hold push bar or button down until the door starts to move. • The Outside Keylock or Keyless Entry . (See Accessories) When the opener is activated with the safety reversing sensor in[...]

Children operating or playing with a garage door opener can injure themselves or others. The garage door could close and cause serious injury or death. Do not allow children to operate the door control(s) or remote control transmitter(s). A moving garage door could injure or kill someone under it. Activate the opener only when you can see the door [...]

1. Does the opener have electric power? Plug a lamp into the outlet. If it doesn't light, check the fuse box or the circuit breaker . (Some outlets are controlled by a wall switch.) 2. Have you disabled all door locks? Review installation instruction warnings on Page 7. 3. Is there a build-up of ice or snow under the door? The door may be froz[...]

Having a Pr oblem? (continued) Situation Probab le Cause & Solution T he door r e v er ses f or no apparent reason and opener lights don't blink: T he door r e v er ses f or no apparent reason and opener lights blink for 5 seconds after reversing: 1. Is something obstructing the door? Pull the manual release handle. Operate the door manual[...]

10 UP CEILING MOUNT ONLY 11 14 3 NOTICE 8 7 9 2 4 5 4 6 1 LOCK LIGHT 12 13 1 The Chamberlain Group, Inc. LM Screw Drive #114A1794 8 4 5 2 3 7 6 Rail Assembly Parts Installation Parts 32 KEY PART NO. NO. DESCRIPTION 1 41A4795 Hardware bag (Includes sprocket coupling) 2 12B569-1 Left rail bracket 3 12B569-2 Right rail bracket 4 81C168 Rack 5 41C4677 [...]

Repair Parts 33 w ew Drive 94 DN UP Brown Wire (Down) Contact LIMIT SWITCH ASSY. Grey Wire Yellow Wire (Up) Contact Center Limit Contact Drive Gear 2 1 4 5 7 13 17 16 9 12 8 14 15 10 6 11 3 8c 8a 8b 8d Power Unit Parts KEY P ART NO. NO. DESCRIPTION 1 31D426 Drive shaft cover 2 41B4245 Line cord 3 30B363 Capacitor – 1/2 HP 30B387 Capacitor – 1/3[...]

LOCK LIGHT 34 Accessories A vailable For Y our Opener Model 971LM Model 974LM Model 970LM Model 1702LM SECURITY ✚ Single-Function Remote Control Includes visor clip. SECURITY ✚ 2-Channel Remote Control Includes visor clip. SECURITY ✚ 3-Channel Remote Control Includes visor clip. SECURITY ✚ 4-Channel Remote Control Includes visor clip. SECUR[...]

Index Access Door/Outside Quick Release Accessory .........................................................................................................31, 34 Electrical Safety W arnings ......................................................................................................................................7, 18, 27 Garage Door T es[...]

© 1999, The Chamberlain Group, Inc. 114A2094D All Rights Reserved Printed in Mexico LIFT -MASTER SERVICE IS ON CALL OUR LARGE SERVICE ORGANIZATION SPANS AMERICA INSTALLATION AND SERVICE INFORMATION IS AS NEAR AS YOUR TELEPHONE SIX DAYS A WEEK. SIMPLY DIAL OUR TOLL FREE NUMBER: 1-800-528-2817 HOURS: (Mountain Standard Time) 6:00 A.M. TO 6:00 P.M. M[...]