AllTrade 835533 manual

Model #835533 A I R C O M P R E S S O R 11 Gallon / 3 Peak HP 0000000 If you encounter any problems or dif ficulties, Do not return your compressor to the stor e! Please contact our toll-free customer service department at: 1-800-423-3598 • 1-310-522-9008 (Califor nia Only) • www .alltradetools.com[...]

It is the owner and/or operator’ s responsibility to study all WARNINGS, operating, and maintenance instructions contained on the product label and instruction manual prior to operation of this unit. The owner/operator shall r etain product instructions for future refer ence. The owner and/or operator is responsible for maintenance, maintaining a[...]

Duty Cycle: This air compressor pump is capable of running continuously . However , in order to prolong the life of your air compressor , it is recommended that a 50% to 75% average duty cycle be maintained. Duty cycle r efers to the per centage of time a compressor can safely run within a given amount of time expr essed as a ratio. Example: Oil lu[...]

INTRODUCTION This oil lubricated air compressor is designed for Household Use Only and is not intended for commer cial applications. It is well suited for do-it- yourselfers with a variety of automotive and home uses. This instruction manual is intended for your benefit. Please read and follow the safety , installation, maintenance and tr oubleshoo[...]

SAFETY WARNINGS READ ALL SAFETY W ARNINGS BEFORE USING AIR COMPRESSOR. GENERAL SAFETY WARNINGS: • Keep work area clean. Messy areas and cluttered workbenches invite personal injury and/or property damage. • Keep children and visitors away . All childr en should be kept away fr om the work ar ea. DO NOT let children handle the compr essor or ext[...]

DRAIN LIQUID FROM AIR T ANK DAIL Y • Use the drain valve located on the bottom of the lower air tank to drain. Failur e to properly drain liquid from the tank will cause rust from moisture buildup, which weakens the tank and could lead to a violent tank explosion. Periodically inspect the tanks for unsafe conditions such as corrosion, cracked wel[...]

RISK OF FALLING Portable air compressors can fall from a table, workbench, or roof causing damage to the compressor and could r esult in serious injury or death to the operator . Always operate air compressor in a stable and secure position to prevent accidental movement of the unit. Never operate air compressor on a roof or other elevated position[...]

IMPROPER INST ALLA TION OF THE GROUNDING PLUG CAN RESUL T IN A RISK OF ELECTRIC SHOCK. IF REP AIR OR REPLACEMENT OF THE CORD IS NECESSARY , DO NOT CONNECT THE GROUNDING WIRE TO EITHER FLA T BLADE TERMINAL. THE WIRE WITH GREEN INSULA TION WITH OR WITHOUT YELLOW STRIPES IS THE GROUNDING WIRE. THIS PRODUCT IS FOR USE ON A NOMINAL 120-VOL T CIRCUIT AND[...]

7 COMPRESSOR FEA TURES 6 3 5 7 1 0 1 1 8 4 9 1 2[...]

COMPRESSOR FEA TURES OIL LUBRICA TION: Oil lubricated direct drive pump with cast-iron cylinder for durability . OIL FILL SIGHT GLASS: Located on the face of the crankcase, the oil fill sight glass provides a convenient way to check the oil fill level within the pump. The oil level must be checked prior to each use to ensure proper fill level. DO N[...]

ASSEMBL Y INSTRUCTIONS THE COMPRESSOR IS SHIPPED WITHOUT OIL IN THE CRANKCASE. ADD OIL AS INDICA TED BELOW . STEP 1 – PUMP LUBRICA TION This air compressor features an oil lubricated pump that requires the use of SAE 30 weight non-detergent air compressor oil . Adding Compressor Oil: 1. Place air compr essor on a flat, level surface. 2. Remove pl[...]

OPERA TION INITIAL SETUP / BREAK-IN PROCEDURE: Do not attach air hose, air tools or other air accessories to the air outlet until break-in procedur e has been successfully completed. 1. Read and understand the entir e instruction manual, including all safety war nings before setting up air compressor . 2. Place air compr essor on a flat, level surf[...]

SHUTDOWN AND STORAGE: NOTE: NEVER stop the air compressor by unplugging it fr om the power outlet as this may result in damage to the compressor . 1. T urn the switch to the OFF position 2. Disconnect the power cord from the power outlet by grabbing the plug (not the cord). Loop around handle for storage. 3. T urn the pressure regulator knob fully [...]

CHECKING SAFETY RELIEF V AL VE: SAFETY RELIEF V AL VE MUST BE REPLACED IF IT CANNOT BE ACTUA TED OR IT LEAKS AIR AFTER THE RING IS RELEASED. 1. The air compressor must be turned OFF . 2. Disconnect compr essor fr om the power sour ce. 3. Open tank drain to bleed off all air pressure before attempting any maintenance or r epair . 4. Allow compressor[...]

13 TROUBLESHOOTING GUIDE Problem Encountered Possible Cause Possible Solution The compressor does not start or restart: Power cord not plugged in. Plug cord into grounded outlet. Motor/Pressur e switch in OFF position Move switch to AUTO position. Motor thermal overload switch has tripped. T urn air compressor off, wait until the motor is cool, the[...]

14 TROUBLESHOOTING GUIDE Problem Encountered Possible Cause Possible Solution Air continues to leak at motor/pressur e switch release valve while motor is running: Defective motor/pressure switch. Replace. Check valve stuck in open position. Replace check valve. DANGER — Do not disassemble the check valve with tank pressurized. Open tank petcock [...]

P ARTS LIST 15 NO. P ART NO. DESCRIPTION QTY NO. P ART NO. DESCRIPTION QTY 1 835533-1 Bolt M6x40 4 55 835533-55 Bolt M10 2 2 835533-2 Cylinder Head 1 56 835533-56 Foot 1 3 835533-3 Air Filter 1 57 835533-57 Nut 1 4 835533-4 Cylinder Head Gasket 1 58 835533-58 Power Cord 1 5 835533-5 V alve Plate 1 59 835533-59 Internal Wire 1 6 835533-6 V alve Plat[...]

16 P ARTS DIAGRAM[...]

ONE YEAR LIMITED W ARRANTY ALL TRADE TOOLS LLC AIR COMPRESSORS Express and Exclusive Limited W arranty to Original Retail Buyer Alltrade T ools LLC (hereinafter “Alltrade”) expressly warrants to the original retail purchaser of the accompanying air compressor and no one else all parts of the product (except those parts r eferred to below which [...]

Alltrade will not be liable for the following: labor charges, loss or damage resulting from impr oper operation, maintenance or repairs made by other persons; pre-delivery services such as assembly , oil or lubricants, and adjustment; maintenance services that are normally required to maintain the air compr essor . The use of other than genuine All[...]

WEAR SAFETY GLASSES WARNING ¥ ADVERTENCIA USE GAFAS DE SEGURIDAD ALLTRADE TOOLS LLC 1431 VIA PLATA LONG BEACH, CA 90810-1462 www.alltradetools.com ©COPYRIGHT 2006, ALLTRADE TOOLS LLC REV.1[...]