English dropdown-ico

Winegard RT8035S manual

1
2
3
4
5
6
7
8
9
10
11
12

Go to page of

Similar user manuals

A good user manual

The rules should oblige the seller to give the purchaser an operating instrucion of Winegard RT8035S, along with an item. The lack of an instruction or false information given to customer shall constitute grounds to apply for a complaint because of nonconformity of goods with the contract. In accordance with the law, a customer can receive an instruction in non-paper form; lately graphic and electronic forms of the manuals, as well as instructional videos have been majorly used. A necessary precondition for this is the unmistakable, legible character of an instruction.

What is an instruction?

The term originates from the Latin word „instructio”, which means organizing. Therefore, in an instruction of Winegard RT8035S one could find a process description. An instruction's purpose is to teach, to ease the start-up and an item's use or performance of certain activities. An instruction is a compilation of information about an item/a service, it is a clue.

Unfortunately, only a few customers devote their time to read an instruction of Winegard RT8035S. A good user manual introduces us to a number of additional functionalities of the purchased item, and also helps us to avoid the formation of most of the defects.

What should a perfect user manual contain?

First and foremost, an user manual of Winegard RT8035S should contain:
- informations concerning technical data of Winegard RT8035S
- name of the manufacturer and a year of construction of the Winegard RT8035S item
- rules of operation, control and maintenance of the Winegard RT8035S item
- safety signs and mark certificates which confirm compatibility with appropriate standards

Why don't we read the manuals?

Usually it results from the lack of time and certainty about functionalities of purchased items. Unfortunately, networking and start-up of Winegard RT8035S alone are not enough. An instruction contains a number of clues concerning respective functionalities, safety rules, maintenance methods (what means should be used), eventual defects of Winegard RT8035S, and methods of problem resolution. Eventually, when one still can't find the answer to his problems, he will be directed to the Winegard service. Lately animated manuals and instructional videos are quite popular among customers. These kinds of user manuals are effective; they assure that a customer will familiarize himself with the whole material, and won't skip complicated, technical information of Winegard RT8035S.

Why one should read the manuals?

It is mostly in the manuals where we will find the details concerning construction and possibility of the Winegard RT8035S item, and its use of respective accessory, as well as information concerning all the functions and facilities.

After a successful purchase of an item one should find a moment and get to know with every part of an instruction. Currently the manuals are carefully prearranged and translated, so they could be fully understood by its users. The manuals will serve as an informational aid.

Table of contents for the manual

  • Page 1

    1 RoadT rip ® Minimax TM Stationary Automatic Satellite TV Antenna Model RT8000S (white dome) Model RT8035S (black dome) WINEG ARD ® Winegard Company • 3000 Kirkwood St. • Burlington, IA 52601-2000 800/788-4417 • F AX 319/758-5854 • www .winegard.com Printed in U.S.A. © Winegard Company 2009 2452185 REV3 1/10 Made in the U.S.A. PRODUCT R[...]

  • Page 2

    2 Parts Included • T ools Needed • Unpacking the Unit 1 Dome 1 base with electronics, dish, dual LNBF *Aftermarket versions also include all mounting hardware and cabling required for a single receiver installation P ARTS INCLUDED*: USE 2 PEOPLE when removing the unit from the carton. ! DO NOT P AINT DOME! Painting dome will cause signal degrad[...]

  • Page 3

    3 DISH NETWORK HYBRID 1 2 3 4 5 6 7 8 0 = UP 1 = DOWN KEY BELL TV 1 2 3 4 5 6 7 8 FIGURE 1 4. After selecting location for unit (see Step 2), place the unit on the centerline of the vehicle. 5. Position base so that cables exit toward the rear of vehicle. The distance from the edge of the roof to the rear cor- ner of any foot should be at least 12?[...]

  • Page 4

    4 7. Clean roof area where the base feet will be attached to the roof. Do not erase your marks! 8. Put approved sealant in the areas marked for the base feet. Place base feet on top of the sealant and screw down with the (3) #10 screws for each foot. 9. After all base feet are secured to roof, put sealant around edge of feet and over screws. 6. Pla[...]

  • Page 5

    5 STEPS 2 & 3 TWO GROUND WIRES 1 FROM VEHICLE 1 BLACK WIRE FROM SA TELLITE DISH STEPS 4 & 5 RED POWER WIRE FROM DISH STEPS 6 &7 +12 V FROM VEHICLE ON/OFF ROCKER SWITCH WITH LIGHT ( Shown in OFF position. ) FIGURE 7 Connecting TWO receivers 1. Connect the coax cable coming from the antenna to the “SA TELLITE IN” input on the primary [...]

  • Page 6

    6 Basic RoadT rip Minimax Antenna Wiring TV RECEIVER 120V POWER SA T IN POWER 12VDC RoadT rip Minimax ANTENNA COAX COAX DIRECTV must be set to the “two” satellite, oval dish setting. In some cases, the two satellite option may not be available. When this happens, use the three satellite option. Refer to your receiver manual for more information[...]

  • Page 7

    7 If a switch other than SW64 appears, or you have an X in one of the boxes below the satellites, repeat Check Switch Steps. 5. Y our system is now set up to toggle between satellites. It will automatically move to the correct satellite when a channel is selected with your remote control. NOTE: Once these steps are completed, you won’t have to pe[...]

  • Page 8

    8 The RoadT rip Minimax antenna does not attempt to nd a satellite or it never moves. The dish never stops on any of the signals that it sees. 1. Check +12 V wires at unit to verify the quick disconnect is locked into the socket. 2. Make sure the RoadT rip Minimax antenna is plugged in. PROBLEM SOLUTION 1. Make sure that your receiver is set up [...]

  • Page 9

    9 Appendix A Satellite Coverage Maps and Receiver Compatibility A.1 DISH NETWORK PROGRAMMING The RoadT rip Minimax antenna will operate with most DISH Network receivers. Winegard does not recommend using receivers with hard drives not recommended by the manufactuer for mobile applications. Winegard recommends using a standard DISH Network receiver [...]

  • Page 10

    10 DISH Network satellite 129 ° coverage area (Dotted area indicates coverage).* DISH Network satellite 61.5 ° coverage area (Dotted area indicates coverage).* *Coverage maps are for reference only and do not guarantee coverage. *Coverage maps are for reference only and do not guarantee coverage. DISH NETWORK ® EASTERN ARC DISH NETWORK 72° SA T[...]

  • Page 11

    11 A.2 DIRECTV PROGRAMMING The RoadT rip Minimax antenna will operate with most DIRECTV receivers. The antenna will locate and continually track satellites 101° and 1 19°. However , the RoadTrip Minimax is not compatible with the DIRECTV 1 10° satellite or the KA band satellites 99° and 103°. Winegard does not recommend using receivers with ha[...]

  • Page 12

    12 Features and specications • One button operation • Supports up to 2 single or 1 dual receiver . • Depending on receiver type and location, you can access satellites DISH Network 129°, 1 19°, 1 10° or 61.5° DIRECTV 1 19° or 101° BELL TV 91° or 82° • Depending on programming, can access DISH NETWORK’s East Coast local feeds. ?[...]