Smeg LS19-7 manual

INSTRUCTION MANUAL GUIDE FOR USING THE DISHWA SH ER AND THE WASHING PROGRAMS[...]

Contents 1 1. Safety and operati ng instructions ___________________________ 2 2. Installation an d hook-up ___________________________________ 5 3. Description of t he controls _________________________________ 9 4. Operating inst ructions ___________________________________ 17 5. Cleaning and maintenance _______________________________ 31 6. Trou[...]

Safety instructions 2 1. Safety and operating instructions THIS MANUAL FORMS AN INTEGRAL PART OF THE APPLI ANCE: IT MUST ALWAYS BE KEPT INTACT TOGETHER WITH THE DISHWASHER. BEFORE USING THE APPLIANCE, CAREFULL Y READ ALL THE INSTRUCTIONS CONTAINED IN THIS MANUAL. INSTALLATION MUST BE PERFORMED B Y A QUALIFIED TECHNICIAN, IN COMPLIANCE WITH THE REGU[...]

Safety instructions 3 OBSOLETE APPLIANCES MUST BE RENDERED UNUSABLE. CUT OFF THE MAINS POWER CORD AFTER UNPLUGGI NG IT FROM THE WALL OUTLET, AND MAKE SAFE ANY COMPONENTS WHICH MIGHT BE DANGEROUS FOR CHILDREN (LOCKS, DOORS, ETC.). THIS APPLIANCE IS MARKED ACCORDING TO THE EUROPEAN DIRECTIVE 2002/96/EC ON WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT ( W[...]

Safety instructions 4 LEANING OR SITTING ON THE DISHWASHER DOOR WHEN OPEN MA Y CAUSE THE APPLIANCE TO OVERTURN, PUTING PEOPLE AT RISK. NEVER LEAVE THE DISHWASHER DOOR OPEN; PEOPLE MIGHT TRIP OVER IT. DO NOT DRINK THE WATER RESIDUES WHICH MAY BE PRESENT INSIDE THE DISHES OR DISHWASHER AT THE END OF THE WASHING PROGRAM AND BEFORE THE DRYING CYCLE. KN[...]

Installation instructions 5 2. Inst allation and hook-up Remove the polystyrene bask et retainers. Position the appliance in the desired place of installation. The back or sides of the dish washer may be placed up a gainst walls or other furniture units. If the dishwasher is installed near a heat source, fit the special insulating panel to prevent [...]

Installation instructions 6 2.1 Water supply connection Preventing the risk of clogging or damage : if the water pipe is new or has not been used for a long t ime, before connecting to the water supply check that the water is clear and free of impu rities, to prevent damage t o the appliance. The dishwasher must always be connected to the water sys[...]

Installation instructions 7 2.2 Electrical connection and precaution s CHECK THAT THE VOLTAGE AND THE FREQUENCY OF THE MAINS MATCH THE RATINGS ON THE NAME PLATE OF THE APPLIANCE POSITIONED ON THE INNER EDGE OF THE DOOR. THE PLUG ON THE SUPPLY CORD AND THE CORRESPONDING SOCKET OUTLET MUST BE OF THE SAME TYPE AND MEET THE REGULATIONS IN FORCE. THE PL[...]

Installation instructions 8 FOR GREAT BRITAIN ONLY: THIS APPLIANCE MUST BE E ARTHED. Fuse replacemen t If the mains lead of this appl iance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use a n A.S .T .A. ap proved fuse to BS 1362 type and proceed as follo w s: 1. Remove the fuse cover A and fuse B . 2. Fit repla[...]

User instructions 9 3. Description of the controls 3.1 Front panel All the dishwasher's controls and in dicators are located on the front panel. Programming and option selection are on ly possible with the door closed . 1 WASHING PROGRAM SELECTOR 2 ON/OFF SELECT OR 3 START/PA USE BUTTON 4 PROGRAM DELA Y BUTTON 5 ½ LOAD WA SH BUTTON 6 "3/[...]

User instructions SETTING THE WASHING PROGRA M To select the most suitable washi ng program, refer to the table below which indicates the recommend ed washing according to dish type and the degree of soiling. Once the most suita ble washing program has been selected using the table pr ovided, turn the WAS HI NG PROGRAM SELECTOR (1) to set the progr[...]

User instructions 11 PROGRA M PROGRAM SEQUENCE DURATION CONSUMPTION INFORMA TION DISPLAY PRE- WAS H WAS H COLD RINSE HOT RINSE DRYING MINUTES (2) WA TER LITRES (1) POWER Kwh (2) SOAK P1 COLD _ 1 _ NO 15' 6 0,01 DISH WARMER P2 _ _ _ 68°C YES 40' 3,5 0,70 QUICK P3 _ 38°C 1 58°C NO 45' 13 0,85 LIGHT P4 _ 45°C 1 68°C YES 70’ 12 1,[...]

User instructions 3.3 Washing programs The dishwasher is equ ipped with a control panel a nd an INFORMATION DISPLAY (8) , described in chapter " 1. Descri ption of the c ontrols", from which it is possible to carr y out all the power switch-on, s w itch-off and programming operations. Before starting a washing pro g ram make sure that: ?[...]

User instructions 13 HALF-LOAD FUNCTION (available in all programs except the soak program) This function is recommended for loads of up to 7 p lace-settings , and cuts down on the use of water and electricity. It can be selected using the HALF LOAD button (5) and there are three different options: 1) pressing the button just once se lects the to p[...]

User instructions 14 PROGRAM (available in all programs excep t the s that the dishwasher how the number of hours of delay with which the (8) shows the set washing program duration in hours and minutes . DELAYING THE soak program) The PROGRA M DELAY button (4) can be pressed to delay the start of the washing program by up to 12 hours . This mean ca[...]

User instructions 15 "3/1" OPTION BUTTON (available in all programs except the soak program) By pressing the button (6) you activate the " 3/1 " option, confirmed w hen the relative light comes on. T his opt ion has been studied for the use of dishwashing po w der or tablets with int egrated substances in place of regenerating s[...]

User instructions STARTING THE DISHWASHER After correctly carrying out all the preceding op erations, to start the dishwasher simply press the START/PAUSE button (3) for a few seconds, until the start cycle acoustic dev ice sounds. The INFORM A TION DISPLAY (8) will sho w the duration of the program in minutes. The duration time is on ly approximat[...]

User instructions 17 4. Operating instructions Once the dishwasher h as been correctly installed, prepare for us e as follows: • Adjust the water softening system; • Add the regenerating salt; • Add the rinse aid and detergent. 4.1 Using the water softening system The amount of scale contain ed in the water (water hardness inde x) can cause w[...]

User instructions • Do not use table salt as it contains insoluble substances which, over time, may damage the water softening system. • When necessary, refill the r ege nerating salt container before starting the washing program . In this way, the exce ss saline solution will be immediately remove d by the water; the prolonged presence of salt[...]

User instructions 19 WATER HARDNESS TABLE WATER HARDNESS German Degrees (°dH) French Degree s (°dF) SETTING 0 - 4 0 - 7 Setting N. 1 NO SALT 5 - 15 8 - 25 Setting N. 1 16 - 23 26 - 40 Setting N. 2 24 - 31 41 - 60 Setting N. 3 32 - 47 61 - 80 Setting N. 4 48 - 58 81 - 100 Setting N. 5 Contact your local w ater board for informati on on the hardnes[...]

User instructions ADDING THE RINSE AID The rinse aid he lps the dishes dry faster and prevents the formation of scale deposits and staining; it is automatic all y added to the water during the final rinse c ycle, from the container situated on the inner side of the door. To add rinse aid: • Open the door. • Rotate the container cap anticlockwis[...]

User instructions 21 ADDING THE DETERGENT To open the detergent dispenser cap, l ightly press the button P . Add the detergent and clos e the cap carefully. During the washing cycle, the disp enser will be opened automatically. • When a program with ho t prewash is sele cted (see p rogram table), extra detergent must be placed in the cavity G/H ([...]

User instructions • "3/1" Products If you wish to use detergents which already contain salt and rinse aid, check whether your dis hwasher is fitted with the " 3/1 option button " on the " Controls description " page and then ref er to the section which explains how to use this funct ion. If the button is not provided[...]

User instructions 23 WARNING! • Make sure that the dishes are secu rely in place so that they cannot tip over or obstruct the rotati on of the spray arms during the washing cycle. • Do not place very small obj ects in the baskets as these could fall and obstruct the spray arms or the wash pump. • Containers such as cups, bowls, glasses and po[...]

User instructions 4.4 Using the baskets The dishwasher has a capacit y of 14 place-settings , including serving dishes. LOWER BASKET The lower basket receives the full force o f the lower spray arm, and should therefore be use d for the “t oughest” items with a heavier degree of soiling. All types and c ombinations of loads are permitted, provi[...]

User instructions 25 In the front there are one or two supports (depe nding on the mode ls) for small plates (B) . To use them, they have to be turned towards the front of the dishwasher. LOADING THE LOWER BASKET Carefully load flat plates, soup plates, dessert and serving dishes, positioning them vertically. Pots, pans and their covers m ust be lo[...]

User instructions 26 CUTLERY BASKET Cutlery must be placed with the tips fac ing downward . Long items of cutler y (ladles, wooden spoo ns, kitchen knives, etc.), which might interfere with the upper spr ay arm must be placed in the upper basket , ensuring that knife tips do not proj ect from the basket. The cutlery basket featur es an exclusi ve s[...]

User instructions 27 UPPER BASKET It is recommended to load the upper bask et with small- or medium-sized items such as glass es, small plates, tea or coffee cups, shall ow bowls and light objec ts made from heat resistant plastic. If the upper basket is used in the lowermost pos ition , it can als o be loa ded with ser ving dishes, provided they a[...]

User instructions Depending on the models, the basket ma y be equipped w ith some or all of the following accessories: - Supports for cups or long ob jects (ladles, spoons…), on the left; can be tipped to the vertical position when not in use. - Long-stemmed glass holder, on t he left; to use, simply lift and fix onto the hooks provided. - Cutler[...]

User instructions 29 ADJUSTING THE UPPER BA SKET Version A : the upp er basket can be adjuste d in two positions , according to the user’s needs and according to the h eight of the dishes in the lower basket. Proceed as follo ws: • pull out the right-hand basket guide ; • remove the stop, first releasing it as shown in the diagram ; • push [...]

User instructions Version C: the top basket can be set in three different positions on both sides. The rack must be level on both sides. To raise the basket lift it, pulling on the fr ont edge (1) , to the first or second catch depending on the height required. To lower it, pull the release lever (2) . This is also possible w ith the basket load ed[...]

User instructions 31 5. Cleaning and maintenance Before carrying out any work, a lways unplug the appliance from the electrical supply or switch off the all-pole disconnection dev ice. 5.1 General warnings and recommendations Avoid the use of acidic or abrasi ve detergents. Clean the outer surfaces and door-linin g of the dishwasher regularly using[...]

User instructions CLEANING THE FILTER UNIT • It is advisable to periodic ally inspect the centre filter C and, if necessary, to clean it. To remove the filter, grip th e tabs, turn them anticlockwise and lift upwards; • push the centre filter D from the underside to remove it from the micro-filter: • separ ate the two parts which make up the [...]

User instructions 33 BEFORE STARTING THE DISHWASHER AFTER PROLONGED DISUSE: • Check that there are no deposits of sludge or rust inside t he water pipe: if there are, allow the water to run from the water s upp ly tap for a few minutes. • Plug the power cord back into the socket. • Reconnect the water intake h o se and open the tap again. TRO[...]

User instructions If the dishes fail to dry or remain dull, check that: • there is rinse aid inside the special c ontainer; • the rinse aid dispenser setting is correct; • the detergent used is of good quality and has not lost its effectiveness (for example, throu gh incorre ct storage, with the box left open). If the dishes show signs of str[...]

User instructions 35 6. T roubleshooting The dishwasher is equ ipped with a self-diagnostics s ystem that is capable of detecting and sign alli ng a number of possible faults. In the event of a f ault or malfunction, before calling th e After-sa les service centre , w e suggest that you first consult the troubleshooting guide below. If the problem [...]

User instructions FAULT DESCRIPTION E5 The dishwasher fails to draw water. Check that: • the water supply tap is open; • the filter in the water intake ho se is not clog ged; • the water intake hose is not kinked or bent; Turn the dishwasher off and then on agai n, then press the START/PAUSE button (3) again. If the problem is resolved the wa[...]

Tü r montieren , Türfeder n vo r Einbau einstellen. Ante s dainstalação , mont ea port ae regul ea tensã odasmolaslaterais. Monta r l a puert ay regula r los muella s laterale s ante s d e l a instalación. WICHTIG: ATENÇÃO: IMPORTANTE: 115 125 135 145 155 115 125 135 145 155 3/4” 3/4” 1/2” SW32 MIN 40cm Cuø10 NOTA : N.B. : REMARQUE: [...]