Milwaukee LSVFSD-LP manual

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20

Go to page of

A good user manual

The rules should oblige the seller to give the purchaser an operating instrucion of Milwaukee LSVFSD-LP, along with an item. The lack of an instruction or false information given to customer shall constitute grounds to apply for a complaint because of nonconformity of goods with the contract. In accordance with the law, a customer can receive an instruction in non-paper form; lately graphic and electronic forms of the manuals, as well as instructional videos have been majorly used. A necessary precondition for this is the unmistakable, legible character of an instruction.

What is an instruction?

The term originates from the Latin word „instructio”, which means organizing. Therefore, in an instruction of Milwaukee LSVFSD-LP one could find a process description. An instruction's purpose is to teach, to ease the start-up and an item's use or performance of certain activities. An instruction is a compilation of information about an item/a service, it is a clue.

Unfortunately, only a few customers devote their time to read an instruction of Milwaukee LSVFSD-LP. A good user manual introduces us to a number of additional functionalities of the purchased item, and also helps us to avoid the formation of most of the defects.

What should a perfect user manual contain?

First and foremost, an user manual of Milwaukee LSVFSD-LP should contain:
- informations concerning technical data of Milwaukee LSVFSD-LP
- name of the manufacturer and a year of construction of the Milwaukee LSVFSD-LP item
- rules of operation, control and maintenance of the Milwaukee LSVFSD-LP item
- safety signs and mark certificates which confirm compatibility with appropriate standards

Why don't we read the manuals?

Usually it results from the lack of time and certainty about functionalities of purchased items. Unfortunately, networking and start-up of Milwaukee LSVFSD-LP alone are not enough. An instruction contains a number of clues concerning respective functionalities, safety rules, maintenance methods (what means should be used), eventual defects of Milwaukee LSVFSD-LP, and methods of problem resolution. Eventually, when one still can't find the answer to his problems, he will be directed to the Milwaukee service. Lately animated manuals and instructional videos are quite popular among customers. These kinds of user manuals are effective; they assure that a customer will familiarize himself with the whole material, and won't skip complicated, technical information of Milwaukee LSVFSD-LP.

Why one should read the manuals?

It is mostly in the manuals where we will find the details concerning construction and possibility of the Milwaukee LSVFSD-LP item, and its use of respective accessory, as well as information concerning all the functions and facilities.

After a successful purchase of an item one should find a moment and get to know with every part of an instruction. Currently the manuals are carefully prearranged and translated, so they could be fully understood by its users. The manuals will serve as an informational aid.

Table of contents for the manual

  • Page 1

    Report No.1 16-L-49-5 I N S T A L L A T I O N A N D O P E R A T I O N I N S T R U C T I O N S Do not store or use gasoline or other flammable vapors or liquids in the vicinity of this or any other appliance. WHA T TO DO IF YOU SMELL GAS: • Do not light any appliance. • Do not touch any electrical switch; do not use any phone in your building. [...]

  • Page 2

    2 IM PO R T A N T SA FET Y AN D W AR NIN G IN FO RM A TI O N REA D T HIS MA NUA L I N I TS ENT IRE TY AND UN DER - ST AND THE SE R ULE S T O F OLL OW FOR SA FET Y . W ARNINGS If t he in for mat ion in t hi s ma nua l i s n ot f ol- lo we d exa ctl y , a fir e or exp los ion ma y re su lt ca us in g p rop ert y d ama ge , pe rs ona l i nju r y or l[...]

  • Page 3

    3 NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE. These Gas Log Appliances incorporate unitized ceramic fiber logs which provides some glow realistically when the appliance is operating. The gas log sets covered in this document are heater rated units. These units are equipped with a millivolt gas valve. The control knob is set to the desired [...]

  • Page 4

    4 Adhere to all local codes or in their absence the latest edition of The National Fuel Gas Code ANSI Z223.1 or NFP A 54-latest edition which can be obtained from The American National Standards Institute, Inc. (1430 Broadway , New Y ork, NY , 10018) or National Fire Protection Association, Inc. (Batterymarch Park, Quincy , MA, 02269). State or loc[...]

  • Page 5

    5 This heater shall not be installed in a confined space or unusually tight construction unless provisions are provided for adequate combustion and v entilati on air . The heat er may be located in u nusuall y tight c onstruc - tion provide d the space is unconfined, or if confined, is provide d with two permanent openings communicating directly[...]

  • Page 6

    6 Not e: Illustrations shown in this manual reflect “typical” installations with nominal dimensions and are for reference only . Actual installations may vary due to individual design preferences. However , always main- tain minimum clearances to combustible materials and do not violate any specific installation requirements. Refer to Figures[...]

  • Page 7

    NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE. 7 Figure 3 Step 2. Ceiling Clearance: The ceiling must be at least 42" from the top of the appliance opening ( Figure 2 ) . Step 3. Noncombu stible materials (minimum requiremen ts): T o install the appl ianc e wit hout wood mant els, she lves or ot her combus tibl e pro jec- tions directly a[...]

  • Page 8

    8 NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE. Any outside air ducts and/or ash dumps in the fireplace shall be perma- nently closed at time of appliance installation. A qualified gas appliance installer must install this dual-listed appli - ance. Check gas type: The gas supply must be the same as stated on the applia nce’ s rating pl at[...]

  • Page 9

    NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE. 9 The appliance gas inlet connection is 3/8" NPT at the regulator/valve, located on the left side facing the appliance. If a right side connection is requ ired, the co nnect ion pi pe may be piped under the rea r of th e appl iance to end at the left hand side for connection to the inlet. Whe[...]

  • Page 10

    10 NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE. LOG PLACEMENT INSTRUCTIONS 1. Place rear ember bed as shown in Figure 11 . Figure 11 - Install Rear Ember Bed 2. Place rear log onto the two rear grate locating pins as shown in Figure 12 (the locating pins are outlined in Figure 11 ). 3. Place middle log onto left middle grate locating pin and[...]

  • Page 11

    11 NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE. 7. Place the right top log onto rear log locating pin and the right front log locating pin as shown in Figure 17 . Right T op Log Locating Pins 8. Pla ce Left T op T w ig (24" and 30" mo dels only) onto cor res pon ding notch on rear log as shown in Figure 18A . The front of the Left [...]

  • Page 12

    12 NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE. T op Burner Air Shutter Adjustment Procedure 1. If y ou h ave blue flame or the top burn er is no t ca rryi ng over and b urni ng on all por ts, the air shutter may need to be adjusted to 1/8" ga p for bot h Na tura l an d Pr opan e ga s. 2. Check to see if the air shutte r is set to 1/8&[...]

  • Page 13

    NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE. 13 An expan ded vie w of the app lian ce with numbe red par ts a nd a part s li st can be f ound on Page 19 . All part s sho uld b e ord ered throu gh yo ur di stri buto r or deal er. Par ts w ill be s hipp ed a t pr evai ling pri ces at t ime of o rder . When ordering repair parts, always give th[...]

  • Page 14

    NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE. 14 Standard Remote Control System (Model RCL) The Model RCL (Standard) Remote Control System, features a simplistic on/off control function for the fireplace. This model includes a hand-held transmitter , a remote receiver with wall-mount cover plate and all hardware required to install the unit.[...]

  • Page 15

    NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE. 15 ACCESSORY COMPONENTS (CONTINUED) * Fo r us e wit h ga s tra in m odels LSV FSD-N G an d LSV FSD- LP on ly 18" Gas Log Set 24" Gas Log Set Charred Ember Kit* Cat. No. Model No. Description H689 4 LSVF SD-C EK Char red Ember Kit Charred Ember Kit An optional 2-piece Charred Ember Kit is[...]

  • Page 16

    NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE. 16 * For the purpose of input adjustment. PILOT (O.D.S.) ASSEMBLY THERMOPI LE WHITE WHITE WHITE RED MILLIVOL T V AL VE ON/OFF SWITCH PILOT PIEZO IGNITER IGNITION WIRE OFF ON OPTIONAL REMOTE CONTROL (MILLIVOL T) Vented/Unvented Gas Log Appliance T echnical Chart For Millivolt Log Set Model No. BTU/[...]

  • Page 17

    17 4. Depress gas control knob slightly and turn clockwise to “OFF .” Do not force. 5. Close lower control compartment. LIGHTING INSTRUCTIONS – MILLIVOL T WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTL Y , A FIRE OR EXPLOSION MA Y RESUL T CAUSING PROPERTY DAMAGE, PERSONAL INJUR Y OR LOSS OF LIFE. FOR YOUR SAFETY READ BEFORE LIGHTING [...]

  • Page 18

    18 VENTED/UNVENTED TROUBLESHOOTING GUIDE OBSERVED PROBLEM POSSIBLE CAUSE REMEDY 1. When igniter button is pressed, there is no spark at ODS/pilot. A. Igniter electrode positioned wrong. Replace igniter . B. Igniter electrode broken. Replace igniter . C. Igniter electrode not connected to igniter cable. Reconnect igniter cable. D. Igniter cable pinc[...]

  • Page 19

    19 NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE. REPLACEMENT P ARTS LIST (MILLIVOL T) - SHADOWDANCE™ SERIES Replacement Parts List (Millivolt) - Shadowdance™ Series, Models LSVFSD-NG and LSVFSD-LP (18" and 24") No. Description Catalog Number 1. Valve, Millivolt (Natural) H1203 Valve, Millivolt (Propane, L.P .G.) H4278 2. Ember B[...]

  • Page 20

    FPO Lennox Hearth Products reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products. Consult your local distributor for fireplace code information. Printed in U.S.A. © 2007 by Lennox Hearth Products P/N 850,051M REV . B 11/2007 1110 West T aft[...]