English dropdown-ico

Matrix Appliances MW401 manual

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28

Go to page of

Similar user manuals

A good user manual

The rules should oblige the seller to give the purchaser an operating instrucion of Matrix Appliances MW401, along with an item. The lack of an instruction or false information given to customer shall constitute grounds to apply for a complaint because of nonconformity of goods with the contract. In accordance with the law, a customer can receive an instruction in non-paper form; lately graphic and electronic forms of the manuals, as well as instructional videos have been majorly used. A necessary precondition for this is the unmistakable, legible character of an instruction.

What is an instruction?

The term originates from the Latin word „instructio”, which means organizing. Therefore, in an instruction of Matrix Appliances MW401 one could find a process description. An instruction's purpose is to teach, to ease the start-up and an item's use or performance of certain activities. An instruction is a compilation of information about an item/a service, it is a clue.

Unfortunately, only a few customers devote their time to read an instruction of Matrix Appliances MW401. A good user manual introduces us to a number of additional functionalities of the purchased item, and also helps us to avoid the formation of most of the defects.

What should a perfect user manual contain?

First and foremost, an user manual of Matrix Appliances MW401 should contain:
- informations concerning technical data of Matrix Appliances MW401
- name of the manufacturer and a year of construction of the Matrix Appliances MW401 item
- rules of operation, control and maintenance of the Matrix Appliances MW401 item
- safety signs and mark certificates which confirm compatibility with appropriate standards

Why don't we read the manuals?

Usually it results from the lack of time and certainty about functionalities of purchased items. Unfortunately, networking and start-up of Matrix Appliances MW401 alone are not enough. An instruction contains a number of clues concerning respective functionalities, safety rules, maintenance methods (what means should be used), eventual defects of Matrix Appliances MW401, and methods of problem resolution. Eventually, when one still can't find the answer to his problems, he will be directed to the Matrix Appliances service. Lately animated manuals and instructional videos are quite popular among customers. These kinds of user manuals are effective; they assure that a customer will familiarize himself with the whole material, and won't skip complicated, technical information of Matrix Appliances MW401.

Why one should read the manuals?

It is mostly in the manuals where we will find the details concerning construction and possibility of the Matrix Appliances MW401 item, and its use of respective accessory, as well as information concerning all the functions and facilities.

After a successful purchase of an item one should find a moment and get to know with every part of an instruction. Currently the manuals are carefully prearranged and translated, so they could be fully understood by its users. The manuals will serve as an informational aid.

Table of contents for the manual

  • Page 1

    1 Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshir e • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www .cda.eu M W40 1 Int egr at ed Dishw asher Manual for Inst allation, Use and Maintenanc e[...]

  • Page 2

    2 Important The CD A Gr oup Ltd cannot be held r esponsible for injuries or losses caused by incorr ect use or installation of this pr oduct. Please note that CD A r eserve the right to in validat e the guarant ee supplied with this pr oduct following inc orr ect installation or misuse of the appliance. This appliance is not designed to be used by [...]

  • Page 3

    3 IMPOR T ANT INFORMA TION FOR CORRE CT DISPOSAL OF THE PRODUCT IN A CCORD ANCE WITH EC DIRE CTIVE 2002/96/EC. At the end of its w orking life, the pr oduct must be taken to a special local authority waste c ollection centr e or to a dealer pr oviding appliance r ecycling services. Disposing of a household appliance separ ately a voids possible neg[...]

  • Page 4

    4 • When the dishwasher is not in use, w e rec comend that you turn off the water supply at the supply t ap and disconnect the main supply . • If you ar e leaving the dishw asher for an ext ended period you should lea ve the door slightly open to pr event the formation of unpleasant smells. • The plastic housing on the water inlet pipe c onta[...]

  • Page 5

    5 C ontr ol P anel P ow er button (1) T o switc h the dishw asher on or off, pr ess the power but ton (1). When you switc h on the dishwasher , the end of pr ogramme light will illuminat e, and two dashes will appear on the displa y. Pr ogr amme displa y (2) The pr ogramme displa y shows the selected pr ogramme and the r emaining time to run. If th[...]

  • Page 6

    6 Salt and rinse aid w arning lights and end of pr ogr amme light (5) When the dishwasher salt or rinse aid begins t o run out, the warning light will illuminate to advise that it needs r efilling. When the pr ogramme is c omplete, the dishw asher will emit five beeps and the end of pr ogramme indicat or light will illuminate. St arting a pr ogr [...]

  • Page 7

    7 Changing a pr ogr amme It is possible to c hange the pr ogramme if nec essary once the pr ogramme has started. • First open the door slightly t o r educe the risk of wat er spillage. •  Pr ess the pr ogramme selection but ton until the r equired pr ogramme is shown on the display . •  Then close the door . The dishw asher wil[...]

  • Page 8

    8 Det er gent T o fill the det er gent compartment 1 . Push the latc h to open the compartment. 2. Add the r equir ed amount of deter gent. The main deter gent compartment “b” (figur e 2) has lines to allow f or specific amounts of deter gent. These are marked at either 1 5 cm 3 or 25 cm 3 , to be used depending on how dirty the dishes ar e.[...]

  • Page 9

    9 Deter gent T o fill the det ergent compartment 1. Push the latch as shown in figur e 1 . 2. Add the r equired amount of det ergent. The main deter gent compartment “b” (figure 2) has lines t o allow for specific amounts of detergent. These ar e marked at either 1 5 cm 3 or 25 cm 3 , to be used depending on how dirty the dishes are. If you[...]

  • Page 10

    10 3. Replac e the cap and the lower bask et. When the salt warning light on the contr ol panel illuminates, you should r efill the salt compartment with salt only – do not add wat er to the salt compartment after the fir st use. Important: Y ou should run a pr ewash pr ogramme immediately aft er adding dishwasher salt to pr event any damage to[...]

  • Page 11

    11 6. Check the number of marks on the strip t o see the level of wat er har dness. If the har dness of the water y ou use is above 63 dE or if y ou ar e using well water; y ou ar e r ecommended t o contact y our local water boar d to confirm the water har dness level and to use filt er and water r efinement devices. Please not e: The level o f [...]

  • Page 12

    12 Rinse Aid T o fill the rinse aid compartment 1. Open the rinse aid compartment by turning and r emoving the cap as shown in figur e 4. 2. Fill the rinse aid compartment until the rinse aid indicator goes dark, as shown in figur e 5 (where a indicates the c ompartment is empty , and “b” indicates the compartment is full). 3. Replace the ca[...]

  • Page 13

    13 Dishw asher Bask ets T o adjust the height of the upper basket: 1 . Open the basket r etaining clips, as shown in figur e 9, but turning them to the side. 2. Remov e the upper basket, and r elocate the alternate set of wheels on the runner , as shown in figur e 1 0, pushing the basket bac k into place. 3. Close the basket r etaining clips. The[...]

  • Page 14

    14 S tandar d loading and T est Data Capacity •  Upper and lower bask ets: 1 2 place settings. •  The upper basket should be adjusted t o high position. •  Cups should be placed on to the dish rac k pins. Deter gent / Rinse aid •  5 + 25 cm3, in accor dance with EN50242-DIN 44990 IEC 436 (international norms) / Rinse[...]

  • Page 15

    15 Pr ogr amme Listing The values and times pr ovided above ha ve been obtained under laborat ory conditions accor ding to r elevant standar ds. Actual r esults obtained can vary depending on the conditions of the dishwasher’s use and envir onment. (mains supply voltage, water pr essur e, water input temper atur e and envir onment temper atur e).[...]

  • Page 16

    16 fig. 1 4 fig. 1 3 Car e and Maint enance Befor e beginning any car e or maintenance, you should alwa ys disconnect the appliance fr om the electricity supply , and also turn off the water supply . Door seals Wipe the dish washer door seals r egularly with a damp cloth to r emove any r esidues. Filter s Y ou should clean the filter s at least [...]

  • Page 17

    17 Please not e: Never run a pr ogr amme without the filter s in place. Incorr ect fitting of the filt ers ma y reduc e w ash performanc e and pot entially damage your appliance. Spr a y arms Y ou should clean the spr ay arms at least onc e a month. 1 . R emove the low er basket 2. Pull the lower spr ay arm upwar ds to r emove it. 3. T o r emove[...]

  • Page 18

    18 F ailur e C odes and T r oubleshoo ting The pr ogramme indicat ors also serv e as a diagnostic display t o help in the event of a pr oblem with the appliance. Error C ode Error description Advice Intensiv e Expr ess Eco Pr ewash Inadequate water supply. Make sur e the water inlet tap is fully open. Close the water tap, separ ate the water inlet [...]

  • Page 19

    19 F ailur e C odes and T r oubleshoo ting Problem P ossible cause The progr amme will not start Check the plug, fuse and circuit br eakers of the mains supply. The water tap is turned off. The dishwasher door is not fully closed. The water inlet filter or the mac hine filters are bloc ked. W ater remains inside the dishw asher at the end of a pr[...]

  • Page 20

    20 Electrical inf ormation W arning! This appliance must be earthed. The mains lead of this appliance has been fitt ed with a BS 1 363A 1 3 amp fused plug. T o change a fuse in this type of plug, follow the st eps below: 1 . R emove the fuse cov er and fuse. 2. Fit r eplacement 1 3A fuse, AS T A appr oved to BS 1 362 type, into the fuse cover . 3.[...]

  • Page 21

    21 As the colour s of the wir es in the mains lead of this appliance ma y not corr espond with the colour ed markings identifying the terminals in your plug, proceed as f ollows:- •  The wir e which is c olour ed GREEN and YELL O W must be connected to the terminal whic h is marked with lett er (E) or by the Earth symbol or colour ed GREEN [...]

  • Page 22

    22 Installation •  Do not install this appliance if it is damaged in any wa y. Installing a damaged appliance ma y invalidat e the warr anty. •  The water supply t ap should be located in an adjacent cupboar d so that it can be accessed aft er installation. •  Ensur e the appliance is level by adjusting the feet as nec[...]

  • Page 23

    23 • T o pr event siphoning, ensure that the w ater outlet is not pushed too far into the wast e standpipe. The low est part of the wat er outlet should be level with the bott om basket of the dish washer . •  When connecting to the sink, ensur e that the waste pipe runs higher than the level of the sink bowl to pr event siphoning. •[...]

  • Page 24

    24 fig. 20 Fitting the int egr at ed appliance door Wher e non-standar d integrat ed appliance doors ar e supplied, additional fitting instructions ar e r equir ed to ensur e compatibility with this pr oduct. The machine is supplied with a fit ting template and these instructions should be follow ed as normal. Howev er , the fitting templat e n[...]

  • Page 25

    25[...]

  • Page 26

    26[...]

  • Page 27

    27[...]

  • Page 28

    28 Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshir e • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www .cda.eu Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshir e • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www .cda.[...]