English dropdown-ico

Frigidaire 0804 manual

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24

Go to page of

Similar user manuals

A good user manual

The rules should oblige the seller to give the purchaser an operating instrucion of Frigidaire 0804, along with an item. The lack of an instruction or false information given to customer shall constitute grounds to apply for a complaint because of nonconformity of goods with the contract. In accordance with the law, a customer can receive an instruction in non-paper form; lately graphic and electronic forms of the manuals, as well as instructional videos have been majorly used. A necessary precondition for this is the unmistakable, legible character of an instruction.

What is an instruction?

The term originates from the Latin word „instructio”, which means organizing. Therefore, in an instruction of Frigidaire 0804 one could find a process description. An instruction's purpose is to teach, to ease the start-up and an item's use or performance of certain activities. An instruction is a compilation of information about an item/a service, it is a clue.

Unfortunately, only a few customers devote their time to read an instruction of Frigidaire 0804. A good user manual introduces us to a number of additional functionalities of the purchased item, and also helps us to avoid the formation of most of the defects.

What should a perfect user manual contain?

First and foremost, an user manual of Frigidaire 0804 should contain:
- informations concerning technical data of Frigidaire 0804
- name of the manufacturer and a year of construction of the Frigidaire 0804 item
- rules of operation, control and maintenance of the Frigidaire 0804 item
- safety signs and mark certificates which confirm compatibility with appropriate standards

Why don't we read the manuals?

Usually it results from the lack of time and certainty about functionalities of purchased items. Unfortunately, networking and start-up of Frigidaire 0804 alone are not enough. An instruction contains a number of clues concerning respective functionalities, safety rules, maintenance methods (what means should be used), eventual defects of Frigidaire 0804, and methods of problem resolution. Eventually, when one still can't find the answer to his problems, he will be directed to the Frigidaire service. Lately animated manuals and instructional videos are quite popular among customers. These kinds of user manuals are effective; they assure that a customer will familiarize himself with the whole material, and won't skip complicated, technical information of Frigidaire 0804.

Why one should read the manuals?

It is mostly in the manuals where we will find the details concerning construction and possibility of the Frigidaire 0804 item, and its use of respective accessory, as well as information concerning all the functions and facilities.

After a successful purchase of an item one should find a moment and get to know with every part of an instruction. Currently the manuals are carefully prearranged and translated, so they could be fully understood by its users. The manuals will serve as an informational aid.

Table of contents for the manual

  • Page 1

    1 www .frigidaire.com P/N 134940 5 00A (0804) Inst allation Instructions Gas & Electric Dryer Instructions d’inst allation Sécheuse à gaz ou électrique[...]

  • Page 2

    2 CONTENTS Pre-Installation Requirements..........................................................................................................................................2 Electrical Requirements..................................................................................................................................................3[...]

  • Page 3

    3 GAS Dryer CIRCUIT - Individual 15 amp. branch circuit fused with a 15 amp. maximum time delay fuse or circuit breaker . POWER SUPPL Y - 3 wire, 120 volt single phase, 60 Hz, Alternating Current. POWER SUPPL Y CORD - The dryer is equipped with a 120 volt 3-wire power cord. NEMA 10-30R NEMA 14-30R ELECTRICAL REQUIREMENTS ELECTRIC Dryer CIRCUIT - In[...]

  • Page 4

    4 SAME AS OTHER SIDE SAME AS OTHER SIDE SAME AS OTHER SIDE SAME AS OTHER SIDE SAME AS OTHER SIDE (9.5 cm) (9.5 cm) (9.5 cm) (9.5 cm) (9.5 cm) 4 3/8" 4 3/8" 4 3/8" 4 3/8" 4 3/8" 5 7/8" 5 7/8" 5 7/8" 5 7/8" 5 7/8" 13 1/2" 13 1/2" 13 1/2" 13 1/2" 13 1/2" 3 3/4" 3 3/4"[...]

  • Page 5

    5 CLOSET DOOR 60 sq. inches (387.1 sq. cm) 60 sq. inches (387.1 sq. cm) 0" (0 cm) 0" (0 cm) 0" (0 cm) 1" (2.54 cm) LOCA TION OF YOUR DRYER DO NOT INST ALL YOUR DRYER: 1. In an area exposed to dripping water or outside weather conditions. 2. In an area where it will come in contact with curtains, drapes, or anything that will obs[...]

  • Page 6

    6 28. 25” to fr on t of cabi ne t 28. 75” to cl ear kn obs 29. 5” to clear door h andle 49” to clear open doo r 13. 5” 40. 75” Cen ter lin e height for rear, right, left vents 4. 37 5” Side exha us ts 27. 0” 38” Gas su pp ly pi pe on r ear of unit 2. 375” Elect ri cal sup p ly on re ar of uni t 71. 75” 27.0” 36.0” 48.5” [...]

  • Page 7

    7 REMOVE 4 SCREWS (ONE FROM EACH HINGE FIRST) UNP UNP UNP UNP UNP ACKING ACKING ACKING ACKING ACKING 1. Using the four shipping carton corner posts (two on each side), carefully lay the dryer on its left side and remove the foam shipping base. T o prevent damage, do not use the contr ol panel as a means to pick up or move the dryer . 2. Return the [...]

  • Page 8

    Figure 1 1.Open door and rem ove four (4) plugs in the door opening opposite the hinges. Retai n all parts for uses later, unless otherwise noted. (Figure 1) Note: Use care in removing plugs in not scratching paint o n the front panel. Figure 2 2. Begin removing th e four (4) screws that attach the hinge to the front panel. (Figure 2) Fo r best res[...]

  • Page 9

    Figure 7 8. Remove lens locating screw. (Figure 7) Figure 8 9. Disengaging several of the retention tabs an d pull lens away from the trans ition ring. (Figure 8) Figure 9 Figure 10 10. Remove two (2) transition ring plugs and reinstall on previous handle side. (Figures 9 and 10) 11. Reassemble lens to transition ring wi th holes to install handle [...]

  • Page 10

    10 ELECTRICAL INST ALLA TION ELECTRIC Dryer The following are specific requirements for proper and safe electrical installation of your dryer . Failure to follow these instructions can create electrical shock and/ or a fire hazard. This appliance MUST be properly grounded. Electrical shock can result if the dryer is not properly grounded. Follow th[...]

  • Page 11

    11 4. Thread a U.L. approved 30 amp power cord, NEMA 14-30 type ST or SRDT through the strain relief. 5. Attach the green power cord ground wire to the cabinet with the green gr ound screw . 6. Attach the white (neutral) power cord conductor from the power cord and the neutral ground wire from the dryer harness to the silver-colored center terminal[...]

  • Page 12

    12 GAS CONNECTION 1. Remove the shipping cap from gas pipe at the rear of the dryer . NOTE: DO NOT connect the dryer to L.P . gas service without converting the gas valve. An L.P . conversion kit must be installed by a qualified gas technician. 2.Connect a 1/2 inch (1.27 cm) I.D. semi-rigid or approved pipe from gas supply line to the 3/8 inch (0.9[...]

  • Page 13

    13 L ’installation et le service de la Sécheuse de vêtements doivent être effectués par un installateur qualifié, l’agence de service ou le fournisseur de gaz. Installez la Sécheuse de vêtement selon les instructions du fabricant et les codes locaux. A vant de commencer , lire attentivement le présent document. Cela simplifiera l’inst[...]

  • Page 14

    14 ÉV ACUA TION DE L ’AIR Utiliser uniquement une conduite en métal rigide ou flexible de 10,2 cm (4 po) de diamètre (minimum) ainsi qu’une grille de sortie approuvée pourvue de clapets qui s’ouvrent lorsque la sécheuse fonctionne. Quand la sécheuse s’arrête, les clapets se ferment automatiquement pour éviter les courants d’air et[...]

  • Page 15

    15 Pour les installations dont le circuit d'évacuation n'est pas décrit dans les tableaux, il faut utiliser la méthode suivante si le circuit d'évacuation n'est pas acceptable: 1 . Brancher un manomètre digital ou à tube incliné entre la sécheuse et le raccord d'évacuation de la sécheuse. 2. Régler la minuterie d[...]

  • Page 16

    16 0 cm (0 po) 0 cm (0 po) 0 cm (0 po) 0 cm (0 po) 0 cm (0 po) 2,54 cm 2,54 cm 2,54 cm 2,54 cm 2,54 cm (1 po) (1 po) (1 po) (1 po) (1 po) 0 cm (0 po) 0 cm (0 po) 0 cm (0 po) 0 cm (0 po) 0 cm (0 po) 0 cm (0 po) 0 cm (0 po) 0 cm (0 po) 0 cm (0 po) 0 cm (0 po) PORTE DU PLACARD PORTE DU PLACARD PORTE DU PLACARD PORTE DU PLACARD PORTE DU PLACARD 387,1 c[...]

  • Page 17

    17 28.25” to front of c a bin et 28.75” to cle a r knobs 29.5” to cle ar door handle 49” to cl ear open door 13.5” 40.75” Center li ne height for rear, right, le ft vents 4.375” Side exhausts 27.0” 38” Gas supply pipe on rear of uni t 2.375” Electrical supply on rear of uni t 71. 75” 27.0” 36.0” 48.5” To clear open door [...]

  • Page 18

    18 (91,5 cm) (91,5 cm) (91,5 cm) (91,5 cm) (91,5 cm) DÉPOSER LES 4 VIS (UNE DE CHAQUE CHARNIÈRE D’ABORD) INST ALLA TION DANS UNE MAISON MOBILE 1. L ’évacuation d’air de la sécheuse DOIT se faire à l’extérieur de la maison (à l'éxterieur et non pas au-dessous de la maison mobile) à l'aide de conduit en métal non inflammab[...]

  • Page 19

    Figure 1 1. Ouvrez la Porte et enlevez les 4 bouchons d' en fa ce où on trouve la charnière. Conservez toutes les pièce s po ur l es utiliser postérieurement, à moins qu 'on ne spécifie le contraire. (Figure 1). Note: Ayez des soins en enlev ant les bouchons, pour ne pas abi mer la peinture dans le Panneau Frontal. Figure 2 2. Déte[...]

  • Page 20

    Figure 7 8. Enlevez la vis qui fixe la lentille. (Figure 7). F igure 8 9. en séparant plusieu rs d es languettes de retenue et retirez la lentille loin de l'anneau de transition. (Figure 8). Figure 9 Figure 10 10. Enlevez deux (2) bouchons de l'ann e au de transition et reinstallez au côté précédent de la poign ée. (Figures 9 et 10)[...]

  • Page 21

    21 MISE À LA TERRE Sécheuses ÉLECTRIQUES non-Canadiennes Le branchement inadéquat du conducteur de mise à la terre pourrait présenter un risque choc électrique. En cas de doute quant à la mise à la terre adéquate de l’appareil, contacter un électricien agréé. Pour brancher et mettre à la terre la sécheuse à l’aide d’un cordon [...]

  • Page 22

    22 BRANCHEMENT ÉLECTRIQUE D’UNE INST ALLA TION À 4 FILS Sécheuses ÉLECTRIQUES non-Canadiennes 1 . Retirer les vis qui retiennent le couvercle du panneau de branchement ainsi que le support de montage du détendeur situés dans le coin supérieur à l’arrière de la sécheuse. 2. Poser un détendeur approuvé par U.L. dans le trou du support[...]

  • Page 23

    23 INST ALLA TION 1. BRANCHEMENT DU GAZ (Sécheuses à gaz seulement) a . Retirer le couvercle qui recouvre le tuyau de gaz à l’arrière de la sécheuse. RE MA RQ UE : NE PAS brancher la sécheuse sur une alimentation au propane sans avoir posé un nécessaire de conversion. Ce nécessaire (n° de pièce 134285300) doit être installé par un te[...]

  • Page 24

    11 Notes ______________________________________________________________ ______________________________________________________________ ______________________________________________________________ ______________________________________________________________ ______________________________________________________________ __________________________[...]