English dropdown-ico

Cannon CANTFS-03-LP manual

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24

Go to page of

Similar user manuals

A good user manual

The rules should oblige the seller to give the purchaser an operating instrucion of Cannon CANTFS-03-LP, along with an item. The lack of an instruction or false information given to customer shall constitute grounds to apply for a complaint because of nonconformity of goods with the contract. In accordance with the law, a customer can receive an instruction in non-paper form; lately graphic and electronic forms of the manuals, as well as instructional videos have been majorly used. A necessary precondition for this is the unmistakable, legible character of an instruction.

What is an instruction?

The term originates from the Latin word „instructio”, which means organizing. Therefore, in an instruction of Cannon CANTFS-03-LP one could find a process description. An instruction's purpose is to teach, to ease the start-up and an item's use or performance of certain activities. An instruction is a compilation of information about an item/a service, it is a clue.

Unfortunately, only a few customers devote their time to read an instruction of Cannon CANTFS-03-LP. A good user manual introduces us to a number of additional functionalities of the purchased item, and also helps us to avoid the formation of most of the defects.

What should a perfect user manual contain?

First and foremost, an user manual of Cannon CANTFS-03-LP should contain:
- informations concerning technical data of Cannon CANTFS-03-LP
- name of the manufacturer and a year of construction of the Cannon CANTFS-03-LP item
- rules of operation, control and maintenance of the Cannon CANTFS-03-LP item
- safety signs and mark certificates which confirm compatibility with appropriate standards

Why don't we read the manuals?

Usually it results from the lack of time and certainty about functionalities of purchased items. Unfortunately, networking and start-up of Cannon CANTFS-03-LP alone are not enough. An instruction contains a number of clues concerning respective functionalities, safety rules, maintenance methods (what means should be used), eventual defects of Cannon CANTFS-03-LP, and methods of problem resolution. Eventually, when one still can't find the answer to his problems, he will be directed to the Cannon service. Lately animated manuals and instructional videos are quite popular among customers. These kinds of user manuals are effective; they assure that a customer will familiarize himself with the whole material, and won't skip complicated, technical information of Cannon CANTFS-03-LP.

Why one should read the manuals?

It is mostly in the manuals where we will find the details concerning construction and possibility of the Cannon CANTFS-03-LP item, and its use of respective accessory, as well as information concerning all the functions and facilities.

After a successful purchase of an item one should find a moment and get to know with every part of an instruction. Currently the manuals are carefully prearranged and translated, so they could be fully understood by its users. The manuals will serve as an informational aid.

Table of contents for the manual

  • Page 1

    C annon This heater is approved for use with Natural and Propane gases. Please leave instructions with the owner USER INSTRUCTIONS INST ALLA TION INSTRUCTIONS SERVICE INSTRUCTIONS FREEST ANDING MODELS CANTFS-03-NG CANTFS-03-LP Part No: F2902 Revision (C) - 2008 Cannon CANTERBUR Y[...]

  • Page 2

    2 Contents Contents 2 W arranty 3 ❍ Distributor Safety warnings 4-5 ❍ What to do if you smell gas ❍ W ar nings ❍ Standards User instructions 6-8 ❍ Operating instructions ❍ Flame characteristics ❍ Cleaning Heater specifications 9 Installation instructions 10-15 ❍ Clearances ❍ Installation ❍ Gas connection ❍ Log installation ❍[...]

  • Page 3

    3 The Cannon appliance is warranted against defects in materials and work- manship for a period of one, (1) year from its date of original purchase, for residential use in Australia. W arranty ser vice, which includes par ts and labour for the replacement or repair of defective parts, is available through the CANNON distributor . (Details below or [...]

  • Page 4

    4 Please read this manual before installing and using the heater . What to do if you smell gas 1. T urn OFF the main gas supply . 2. Extinguish any open flame. 3. Open windows. 4. Do not touch electrical switches. 5. Do not use your telephone. 6. Call your gas supplier immediately from a neighbour’ s phone. W arnings 1. Improper installation, adj[...]

  • Page 5

    5 7. Do not spray aerosols in the vicinity of this appliance while it is in operation. Do not place articles on or against this appliance. Do not use or store flammable materials near this appliance. 8. This heater is not intended for use in a marine environment. 9. If removed, the glass window must be put back onto the unit prior to operating the [...]

  • Page 6

    6 Operating instructions 1. Plug the power cord into the wall socket and turn on the power to the heater , see figure 1. Use of an extension cord is not recommended. 2. For control lay-out refer to figure 2 3. T o tur n heater on press switch to POWER ON position. There is a 5 second delay before the burner ignites. At this setting the burner is on[...]

  • Page 7

    7 5. T o increase the fan speed to MED, press switch for MED setting. Refer figure 5. 6. T o increase the fan speed to HIGH, press switch for HIGH setting. Refer figure 6. 7. T o turn the burner to LOW setting, press switch for LOW setting. Refer figure 7. On low burner setting it is more efficient to operate the fan speed on LOW . 8. If the burner[...]

  • Page 8

    8 Flame characteristics The heater flame should be stable, no lifting from the burner and the logs should glow after approximately 15 minutes operation on HIGH setting. The heater is a fuel effect unit and is designed to operate with luminous flames and may exhibit slight carbon deposits on the logs. If there is any excess carbon build-up on the lo[...]

  • Page 9

    9 Gas type: Natural or Propane gas, as indicated on data label. Gas consumption: 26 M J/hr input. Energy output: 21.45 MJ/hr (5.96 kW). Energy star rating: 4 stars. Heater type: Approved to AS4553/AG 103. Operating pressure: Natural gas: 0.75 kPa. (at the burner) Propane gas: 2.65 kPa. Gas regulator: Integral part of controller . Min. inlet pressur[...]

  • Page 10

    10 Overall dimensions: Refer fig. 8. 1. This appliance is to be installed by a licensed ser vice person only . 2. This appliance shall be installed in accordance with the manufacturer’ s installation instructions, local gas fitting regulations, municipal building codes, electrical wiring regulations, and AS5601 the Australian Stand- ard for gas i[...]

  • Page 11

    11 Gas connection 10. Connect incoming gas supply pipe to 1 / 2 ” compression fitting at rear of appliance. For inlet position see figure 13. Log installation 11. The burner is contained within the burner chamber . Refer figure 14. 12. Carefully unpack the log set. Logs are numbered as follows: No 1 - Left front log No 2 - left back log No 3 - Ri[...]

  • Page 12

    12 Position the four individually numbered logs in the following order on the burner head as shown in figures 15 - 18. The male locating pins in the burner head must engage with corresponding holes in the indi- vidual logs. a) Place log No.1 onto the 2 front left pins on the burner head, ensuring that the charring faces the front. Refer figure 15. [...]

  • Page 13

    12 Position the four individually numbered logs in the following order on the burner head as shown in figures 15 - 18. The male locating pins in the burner head must engage with corresponding holes in the indi- vidual logs. a) Place log No.1 onto the 2 front left pins on the burner head, ensuring that the charring faces the front. Refer figure 15. [...]

  • Page 14

    11 Gas connection 10. Connect incoming gas supply pipe to 1 / 2 ” compression fitting at rear of appliance. For inlet position see figure 13. Log installation 11. The burner is contained within the burner chamber . Refer figure 14. 12. Carefully unpack the log set. Logs are numbered as follows: No 1 - Left front log No 2 - left back log No 3 - Ri[...]

  • Page 15

    10 Overall dimensions: Refer fig. 8. 1. This appliance is to be installed by a licensed ser vice person only . 2. This appliance shall be installed in accordance with the manufacturer’ s installation instructions, local gas fitting regulations, municipal building codes, electrical wiring regulations, and AS5601 the Australian Stand- ard for gas i[...]

  • Page 16

    9 Gas type: Natural or Propane gas, as indicated on data label. Gas consumption: 26 M J/hr input. Energy output: 21.45 MJ/hr (5.96 kW). Energy star rating: 4 stars. Heater type: Approved to AS4553/AG 103. Operating pressure: Natural gas: 0.75 kPa. (at the burner) Propane gas: 2.65 kPa. Gas regulator: Integral part of controller . Min. inlet pressur[...]

  • Page 17

    8 Flame characteristics The heater flame should be stable, no lifting from the burner and the logs should glow after approximately 15 minutes operation on HIGH setting. The heater is a fuel effect unit and is designed to operate with luminous flames and may exhibit slight carbon deposits on the logs. If there is any excess carbon build-up on the lo[...]

  • Page 18

    7 5. T o increase the fan speed to MED, press switch for MED setting. Refer figure 5. 6. T o increase the fan speed to HIGH, press switch for HIGH setting. Refer figure 6. 7. T o turn the burner to LOW setting, press switch for LOW setting. Refer figure 7. On low burner setting it is more efficient to operate the fan speed on LOW . 8. If the burner[...]

  • Page 19

    6 Operating instructions 1. Plug the power cord into the wall socket and turn on the power to the heater , see figure 1. Use of an extension cord is not recommended. 2. For control lay-out refer to figure 2 3. T o tur n heater on press switch to POWER ON position. There is a 5 second delay before the burner ignites. At this setting the burner is on[...]

  • Page 20

    5 7. Do not spray aerosols in the vicinity of this appliance while it is in operation. Do not place articles on or against this appliance. Do not use or store flammable materials near this appliance. 8. This heater is not intended for use in a marine environment. 9. If removed, the glass window must be put back onto the unit prior to operating the [...]

  • Page 21

    4 Please read this manual before installing and using the heater . What to do if you smell gas 1. T urn OFF the main gas supply . 2. Extinguish any open flame. 3. Open windows. 4. Do not touch electrical switches. 5. Do not use your telephone. 6. Call your gas supplier immediately from a neighbour’ s phone. W arnings 1. Improper installation, adj[...]

  • Page 22

    3 The Cannon appliance is warranted against defects in materials and work- manship for a period of one, (1) year from its date of original purchase, for residential use in Australia. W arranty ser vice, which includes par ts and labour for the replacement or repair of defective parts, is available through the CANNON distributor . (Details below or [...]

  • Page 23

    2 Contents Contents 2 W arranty 3 ❍ Distributor Safety warnings 4-5 ❍ What to do if you smell gas ❍ W ar nings ❍ Standards User instructions 6-8 ❍ Operating instructions ❍ Flame characteristics ❍ Cleaning Heater specifications 9 Installation instructions 10-15 ❍ Clearances ❍ Installation ❍ Gas connection ❍ Log installation ❍[...]

  • Page 24

    C annon This heater is approved for use with Natural and Propane gases. Please leave instructions with the owner USER INSTRUCTIONS INST ALLA TION INSTRUCTIONS SERVICE INSTRUCTIONS FREEST ANDING MODELS CANTFS-03-NG CANTFS-03-LP Part No: F2902 Revision (C) - 2008 Cannon CANTERBUR Y[...]