Sanyo KS0951 manuale d’uso

INSTRUCTION MANUAL Split System Air Conditioner COOL/DRY Model KS0951 KS1251 KS1852 Save These Instructions! Pub . OI-8526418033000 5 ©SANY O 200 2 Printe d o n Recycle d Paper[...]

Features This air conditioner is equipped with cooling and drying functions. Details on these functions are provided below; refer to these descriptions when using the air conditioner . • Microprocessor Controlled Operation The interior compartment of the remote control unit contains several features to facilitate automatic operation, each logical[...]

Contents Page Features .................................................................................................................. 2 Product Information .............................................................................................. 3 Alert Symbols ...............................................................................[...]

Installation Location • We recommend that this air conditioner be installed properly by qualified installation technicians in accordance with the Installation Instructions provided with the unit. • Before installation, check that the voltage of the electric supply in your home or office is the same as the voltage shown on the nameplate. • Do [...]

Names of Parts NOTE This illustration is based on the external appearance of a standard model. Consequently , the shape may differ from that of the air conditioner which you have selected. This air conditioner consists of an indoor unit and an outdoor unit. Y ou can control the air conditioner with the remote control unit. Air Intakes Air from the [...]

Unit Display and Operation Selector Remote control receiver This section picks up infrared signals from the remote control unit (transmitter). Operation selector ON position This position is for operating the air conditioner with the wireless remote control unit. Set the selector normally in this position. OFF position Switch the selector to the OF[...]

Remote Control Unit (Display) (1) Operation mode MILD DRY................................ COOL ....................................... (2) Fan speed AUTO ....................................... HIGH ........................................ MEDIUM .................................. LOW ......................................... (3) T emperature setti[...]

8 OI-330-08EG Remot e Contr ol Unit Sensor T ransmit ter Display NIGHT SETBA CK button 1 HR. TIMER butt on MODE select or butt on FLAP but ton ADDRESS switch (Cov er closed) ON/OFF operation but t on T emperatur e setting but tons F AN SPEED selector but ton TIMER SELECT but ton TIMER AND PRESENT TIME set ting butt ons PROGRAM but ton A CL butt on [...]

9 OI-330-9EG Remote Contr ol Unit (continued) Progr am butt on For details, see “Setting the Timer” . Press this but ton to select the mode you want to program. TIMER SELECT but ton No display : The timer does not operate. : The air conditioner stops at the set time. : The air conditioner starts at the set time. : The air conditioner stops and [...]

Using the Remote Control Unit How to Install Batteries NOTE • The batteries last about six months, depending on how much you use the remote control unit. Replace the batteries when the remote control unit ' s display fails to indicate, or when the remote control cannot be used to change the air conditioner ' s settings. • Use two fres[...]

11 OI-330-1 1EG Using the Remote Contr ol Unit (continued) Mounting the Remote Contr ol Unit When attac hing t o wall 1) Confirm the indoor unit beeps when the ON/OFF but ton is pressed at the w all location where the remote control unit is to be attac hed, then attac h the holder to the w all. 2) When taking out the remote control unit, pull it fr[...]

Set the FAN SPEED selector button to the setting you want. If the fan speed is set to (Automatic), the fan speed switches automatically, according to the difference between the actual room temperature and the temperature setting. Operation with the Remote Control Unit 1. Manual Operation NOTE Check that the circuit breaker on the power panel is tur[...]

Operation with the Remote Control Unit (continued) NOTE • This appliance has a built-in three minutes time delay circuit to ensure reliable operation. When the operation button is pressed, the compressor will start running within three minutes. In the event of power failure, the unit will stop. When the power is restored, the unit will restart au[...]

Operation with the Remote Control Unit (continued) 3. Night Setback Mode The Night Setback Mode is used for saving energy . Press the NIGHT SETBACK button while the air conditioner is operating. The mark appears in the display . T o cancel the night setback function, press the NIGHT SETBACK button again. In Cooling and DRY Mode: ( and ) When the ni[...]

Special Remarks ` `DRY' ' ( ) Operation How it works? • Once the room temperature reaches the level that was set, the unit repeats the cycle of turning on and off automatically . • During DRY operation, the fan speed is automatically set to LOW or VERY LOW ; the fan speed then switches back and forth between LOW (for 20 seconds) and V[...]

16 OI-330-16E G S et ting the T imer 1 . Ho w to set the pr esent time (Example) T o set to 9:1 0 pm. Operation Indication 1 . Press the P rogram but ton ( ) three times. 2. • Press the HH but ton until PM 9 is displayed. • Press the MM but ton until 1 0 is displayed. The time indication alone blinks. The display will automatically stop blinkin[...]

17 OI-330-17E G Set ting the Timer (continued) 3 . How t o set the ON time (Example) T o star t operation at 7:1 0 am. Operation Indication 1 . Press the P rogram but ton ( ) twice. 2. • Press the HH but ton until AM 7 is displayed. • Press the MM but ton until 1 0 is displayed. 3. Press the ON/OFF but ton to star t the air conditioner . 4. Pre[...]

18 OI-330-18E G S et ting the 1 -Hour OFF T imer 1 . 1 -Hour OFF Timer This function causes the unit t o operat e for one hour and then st op, reg ardless of whether the unit is on or of f when this butt on is pr essed. The indicator in the display indicates that this function is operating. Set ting procedur e: Reg ardless of whether the unit is op[...]

Adjusting the Airflow Direction 1. Horizontal The horizontal airflow can be adjusted by moving the vertical vanes with your hands to the left or right. CAUTION When the humidity is high, the vertical vanes should be in the front position during the cooling or drying operation. If the vertical vanes are positioned all the way to the right or left, c[...]

Operation without the Remote Control Unit If you have lost the remote control unit or it has trouble, follow the steps below . 1. When the air conditioner is not running If you want to turn on the air conditioner , switch the operation selector to the OFF position, and then to the ON position. NOTE The set temperature and fan speed are automaticall[...]

Care and Cleaning (continued) Anti-mold filter The anti-mold filter behind the air intake grille should be checked and cleaned at least once every two weeks. How to remove the anti-mold filter 1. Grasp both ends of the air intake grille and pull it out and up. 2. Push the anti-mold filter up slightly , and then pull it down. Cleaning Use a vacuum c[...]

Care and Cleaning (continued) Air cleaning filter (not provided) The air cleaning filter removes dust and dirt from the air , and reduces odors and smoke from tobacco. NOTE KS0951/KS1251 The air cleaning filter is not provided with the air conditioner and must be purchased separately . The first time that you buy the air clean filter , it is necess[...]

Care and Cleaning (continued) Removing and remounting the air intake grille • With the air intake grille open all the way , grip both arms with your hands and pull toward you to remove. T o remount, hold the air intake grille roughly horizontal and push it in until the arm shafts fit into the indentations in the main unit, then fit the grille int[...]

T roubleshooting If your air conditioner does not work properly , first check the following points before requesting service. If it still does not work properly , contact your dealer or service center . T rouble Possible Cause Remedy Air conditioner does not run at all. 1. Power failure. 1. Restore power . 2. Leakage circuit breaker tripped. 2. Con[...]