Porter-Cable CPLC7060V manuale d’uso

Part No. D23269-049-2 ® Single Stage Oillube Compr essor Instruction manual T o learn more about Porter -Cable visit our website at: http://www .porter -cable.com The Model and Serial No. plate is located on the frame. Record these numbers in the spaces below and retain for futur e refer ence. Model No. T ype Serial No. ESP AÑOL: PÁGINA 25 FRAN?[...]

2 - ENG D23269 indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury . This manual contains information that is important for you to know and understand. This informa- tion relates to pr otecting YOUR SAFETY and PREVENTING EQUIPMENT PROBLEMS . T o help you recognize this information, we use the sy[...]

3 - ENG D23269 RISK OF BURSTING SA VE THESE INSTRUCTIONS IMPROPER OPERA TION OR MAINTENANCE OF THIS PRODUCT COULD RESUL T IN SERIOUS INJURY AND PROPERTY DAMAGE. READ AND UNDERST AND ALL WARNINGS AND OPERA TING INSTRUC- TIONS BEFORE USING THIS EQUIPMENT . RISK OF EXPLOSION OR FIRE AIR T ANK : THE FOLLOWING CONDITIONS COULD LEAD TO A WEAKENING OF THE[...]

4 - ENG D23269 RISK FROM FL YING OBJECTS IMPORT ANT SAFETY INSTRUCTIONS (cont’d) WHA T CAN HAPPEN HOW TO PREVENT IT AIR OBT AINED DIRECTL Y FROM THE COMPRES- SOR SHOULD NEVER BE USED TO SUPPL Y AIR FOR HUMAN CONSUMPTION. IN ORDER TO USE AIR PRODUCED BY THIS COMPRESSOR FOR BREA THING, SUIT ABLE FIL TERS AND IN-LINE SAFETY EQUIPMENT MUST BE PROPERL[...]

5 - ENG D23269 RISK FROM MOVING P ARTS RISK OF BURNS RISK OF F ALLING IMPORT ANT SAFETY INSTRUCTIONS (cont’d) WHA T CAN HAPPEN HOW TO PREVENT IT WHA T CAN HAPPEN HOW TO PREVENT IT WHA T CAN HAPPEN HOW TO PREVENT IT MOVING P ARTS SUCH AS THE PULLEY , FL Y- WHEEL AND BEL T CAN CAUSE SERIOUS INJUR Y IF THEY COME INTO CONT ACT WITH YOU OR YOUR CLOTHI[...]

6 - ENG D23269 GLOSSAR Y SPECIFICA TIONS Model No. CPLC7060V Horsepower Peak 7.0 V oltage/Hertz/Phase 240V/60/1 Minimum Branch Circuit Requir ement 15 Amp * Fuse T ype Time Delay Air T ank Capacity (Gallon) 60 ASME, V ertical Approximate Cut-in Pr essure 110 PSIG Approximate Cut-out Pr essure 135 PSIG SCFM @ 40 PSIG 12.1 SCFM @ 90 PSIG 9.7 Become f[...]

7 - ENG D23269 T o Add Oil T o Pump Compressors ar e shipped without oil. A small amount of oil may be present in the pump upon r eceipt of the air compressor . This is due to plant testing and does not mean the pump contains oil. Do not attempt to operate this air compressor without first adding oil to the crankcase. Serious damage can result from[...]

8 - ENG D23269 INST ALLA TION Location of the Air Compressor • Locate the air compressor in a clean, dry , and well ventilated area. • Located the air compressor at least 12" away fr om the wall or other obstruc- tions that will interfere with the flow of air . • Locate the air compressor as close to the main power supply as possible to [...]

9 - ENG D23269 Wiring Instructions Improper electrical installation of this pr oduct may void its warranty and your fire insurance. Have cir cuit wiring performed by qualified personnel such as a licensed electri- cians who is familiar with the current national electrical code and any prevailing local electrical codes. RISK OF ELECTRICAL SHOCK. Imp[...]

10 - ENG D23269 Air Distribution System Plastic or PVC pipe is not designed for use with compressed air . Regar dless of its indicated pres- sure rating, plastic pipe can burst fr om air pressur e. Use only metal pipe for air distribution lines. The next figure r epresents a typical air distribution system. The following ar e tips to remember when [...]

11 - ENG D23269 OPERA TION Know Y our Air Compressor READ THIS OWNER’S MANUAL AND SAFETY RULES BEFORE OPERA TING YOUR UNIT . Compar e the illustrations with your unit to familiarize yourself with the loca- tion of various controls and adjustments. Save this manual for futur e refer ence. Description of Operation Become familiar with these control[...]

12 - ENG D23269 Air Intake Filter (not shown) This filter is designed to clean air coming into the pump. This filter must always be clean and ventilation openings free fr om obstruc- tions. See "Maintenance". How to Use Y our Unit How to Stop: 1. Set the On/Auto/Off lever to “OFF”. Before Starting Break-in Pr ocedure Serious damage ma[...]

13 - ENG D23269 MAINTENANCE Customer Responsibilities Daily or after each use Before each use Check Safety V alve Drain T ank Oil Leaks Check Oil Change Oil Unusual Noise and/or Vibration Air Filter Drive Belt Condition Motor Pulley/Flywheel alignment Air compressor pump intake and exhaust valves Inspect air lines and fit- tings for leaks ● ● ?[...]

14 - ENG D23269 T o Drain T ank 1. Set the On/Auto/Off lever to “OFF”. 2. Close the globe valve. 3. Remove the air tool or accessory . 4. Open the globe valve and allow the air to slowly bleed from the air tank until tank pressur e is approximately 20 psi. 5. Close the globe valve. 6. Drain water from air tank by opening drain valve (counter -c[...]

15 - ENG D23269 Motor Pulley/Flywheel Alignment NOTE: Once the motor pulley has been moved from its factory set location, the grooves of the flywheel and pulley must be aligned to within 1/16" to pr event excessive belt wear . The air compressor flywheel and motor pulley must be in-line (in the same plane) within 1/16" to assure belt r et[...]

16 - ENG D23269 SERVICE AND ADJUSTMENTS Unit cycles automatically when power is on. When doing Maintenance, you may be exposed to voltage sources, com- pressed air or moving parts. Personal injuries can occur . Before performing any Maintenance or r epair , unplug the compressor and bleed of f all air pressur e. ALL MAINTENANCE AND REP AIR OPERA TI[...]

17 - ENG D23269 T o Replace Belt Serious injury or damage may occur if parts of the body or loose items get caught in moving parts. Never operate the unit with the belt guard r emoved. The belt guard should be removed only when the compr esor is unplugged. 1. Unplug compressor . 2. Remove the front of the belt guar d by disengaging the snaps. Inser[...]

18 - ENG D23269 STORAGE Before you stor e the air compressor , make sur e you do the following: 1. Review the "Maintenance" section on the preceding pages and perform sched- uled maintenance as necessary . 2. Set the On/Auto/Off lever to “OFF”. 3. Close the globe valve. 4. Remove the air tool or accessory . 5. Open the globe valve and[...]

19 - ENG D23269 TROUBLESHOOTING Performing repairs may expose voltage sour ces, moving parts or compressed air sour ces, moving parts or compressed air sources. Personal injury may occur . Prior to attempting any r epairs, unplug the air compressor and bleed of f all air tank air pressur e. PROBLEM CAUSE CORRECTION Pressur e switch does not shut of[...]

20 - ENG D23269 PROBLEM CAUSE CORRECTION Possible defect in safe- ty valve. Operate safety valve manually by pulling on ring. If valve still leaks, it should be replaced. Defective check valve. Remove and clean, or replace. Knocking Noise. Compressor is not supplying enough air to operate accessories. Prolonged excessive use of air . Compressor is [...]

21 - ENG D23269 PROBLEM CAUSE CORRECTION Motor will not run. Fuse blown, circuit breaker tripped. 1. Check fuse box for blown fuse and replace as neces- sary . Reset circuit breaker . Do not use a fuse or circuit breaker with higher rating than that specified for your particular branch circuit. 2. Check for proper fuse. Y ou should use a time delay[...]

22 - ENG D23269 PROBLEM CAUSE CORRECTION Clean or replace. See Air Filter paragraph in the Maintenance section. Dirty air filter . Restricted air intake Excessive belt wear Loose belt. Loosen wingnut and then tighten wingnut until it contacts the washer , plus one turn. Tight belt. Loosen wingnut and then tighten wingnut until it contacts the washe[...]

23 - ENG D23269 NOTES[...]

24 - ENG D23269 ® LIMITED WARRANTY PORTER-CABLE CORPORA TION warrants to the original pur chaser that each new air compressor and service part is fr ee from defects in material and workmanship and agr ees to repair or r eplace under this warranty any defective product or part as follows fr om the original date of purchase. 5 YEARS – Limited warr[...]