Hoover HLSI 500GT manuale d’uso

User instructions EN HLSI 500GT DISHWASHER ®[...]

3 CONTENTS Safety advice Setting up, installation W ater softener unit Loading the salt Adjusting the upper basket Loading the dishes Information for test laboratories Loading the detergent T ypes of detergent Loading the rinse aid Cleaning the filters Some practical hints Routine cleaning and maintenance Description of the control panel T echnical[...]

4 Fuses and plugs This appliance should be used only on a socket with a minimum rating of 13 Amp. Our ready-fitted plug is already equipped with a 13 amp fuse which is BS 1362 AST A approved. Any replacement should be exactly the same. If the fuse cover is lost, do not use the plug until it is replaced. A correct replacement fuse cover (obtainable [...]

W ater connection IMPORT ANT The appliance must be connected to the water mains using new hose-sets. The old hose-sets should not be reused. ■ Th e inlet and drain hoses can be directed to left or right. IMPORT ANT The dishwasher can be connected to either cold or hot water , as long as it is no hotter than 60 °C. ■ W ater pressure must be bet[...]

LOADING THE SAL T ■ On the bottom of the machine there is a container for the salt for regenerating the softener . ■ It is important to use only a salt that is specifically designed for dishwasher . O ther types of salt contain small quantities of insoluble particles which over a long p eriod of time may affect and deteriorate the softener perf[...]

10 1 3 a b a b 2 ADJUSTMENT OF THE UPPER BASKET If 27 cm to 31 cm plates are normally used, load them onto the lower basket after the upper basket has been placed in its upper position and proceed as detailed below: 1. Pull out the upper basket; 2. Then grasp the basket from both sides and lift it upwards (fig. 1) . Dishes that are bigger than 14 c[...]

12 ■ The lower basket is fitted with a special adjustable central rack (fig. 3 and 4) . This permits stable and optimum loading, even when the size and/or shape of the dishes is non-standard. - POSITION “A” : for a standard load, or one that excludes pans, salad bowls and the like. - POSITION “B” : for dishes which, although standard size[...]

15 LOADING THE DETERGENT The detergent IMPORT ANT It is essential to use a detergent that is specifically designed for dishwashers either in powder , liquid or tablet form. “FINISH” gives very good results and can be easily obtained. Unsuitable detergents (like those for washing up by hand) do not contain the proper ingredients for use in a dis[...]

17 1 2 3 CLEANING THE FIL TERS The filter system (fig.A “4”) consists of: a central container that traps the larger particles; a flat gauze that continuously filters the wash water; a micro filter , located beneath the gauze, that traps the tiniest particles ensuring a perfect rinse. ■ T o achieve excellent results every time, the filters sho[...]

19 WHEN CYCLE IS FINISHED After every wash it is essential to turn off water supply and to switch off the machine by pressing the On/Off button to the of f position. If the machine is not going to be used for some time, it is advisable to follow these rules: 1. do an empty wash with detergent in order to clean the machine of any deposits; 2. pull o[...]

21 20 EN 50242 place load Capacity with pans and dishes W ater supply pressure Fuse Power input Supply voltage 15 9 persons Min. 0,08 - Max 0,8 MPa (see rating plate) (see rating plate) (see rating plate) DESCRIPTION OF THE CONTROL P ANEL TECHNICAL DA T A: DIMENSIONS: Height Depth Width Depth with door open A DIGIT AL DISPLA Y B "PROGRAMME SEL[...]

23 22 "IMPULSE" programmes The “IMPULSE” programmes use an impluse washing technology , which reduces consumption, noise and increases performances. IMPORT ANT The “intermittent” working of the washing pump MUST NOT BE considered a malfunction, it is a characteristic of the impulse washing so must be considered a normal function o[...]

25 24 AUTOMA TIC F AUL T SIGNALS T urn off the dishwasher , open the inlet hose and reset the cycle. Check if the drain tube is bent or if the siphon or filters are clogged. If the problem persists, contact Customer Service. Check if the drain tube is bent or if the siphon or filters are clogged. If the problem persists, contact Customer Service. C[...]

27 26 PROGRAMME GUIDE W ash with prewash For wash programmes with prewash, it is advisable to add a second dose of detergent (max. 10 g) directly in the machine. 140 • •• • 75°C • • •• • • • •• • • 130 85 75°C 65°C Cycle with alternated action of water jets and steam. Effective in softening and removing dried up soi[...]

29 IDENTIFYING MINOR F AUL TS Should the dishwasher fail to operate, before contacting the Service Centre, make the following checks: 28 F AUL T CAUSE REMEDY 1 - Machine completely dead 2 - Machine does not draw water 3 - Machine does not discharge water 4 - Machine discharges water continuously 5 - Spray arms are not heard to rotate 6 - On electro[...]

30 This appliance is marked according to the European directive 2002/96/EC on W aste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly , you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this pro- [...]

10.10 - 41034648 - www .graficaestampa.it - Printed in Italy - Imprimé en Italie EN 08705-400600 HOOVER SER VICE FOR YOUR LOCAL ENGINEER PLEASE CALL OUR NA TIONAL NUMBER Areas covered by HOOVER SERVICE DEALERS Also Channel Islands, Scilly Isles, Orkney , Shetlands See local telephone directory Hoover policy is one of continuous development and for[...]