Haier HSU-24H03/V(ZF) manuale d’uso

No.0010554404 B SPLIT TYPE ROOM AIR CONDITIONER OPERA TION MANUAL Please read this operation manual before using the air conditioner HSU-09C03/VA(ZXF) HSU-09H03/VA(ZXF) HSU-12H03/VA(ZXF) HSU-12C03/VA(ZXF) HSU-18C03/V(ZXF) HSU-18H03/V(ZXF) HSU-22C03/V(ZXF) HSU-22H03/V(ZXF) HSU-22C03/V(ZF) HSU-22H03/V(ZF) HSU-12H03/VB(ZXF) HSU-12H03/V(ZXF) HSU-24C03/[...]

Bef ore disposing an old air conditioner that goes out of use, please mak e sure it's inop- erativ e and saf e. Unplug the air conditioner in order to av oid the risk of child entrapment. It must be noticed that air conditioner system contains refrigerants, which require speciali- zed w aste disposal. The v aluab le materials contained in an a[...]

Do not obstruct or cov er the ventilation grille of the air conditoner.Do not put fingers or any other things into the inlet/outlet and s wing louver. Do not allow children to pla y with the air conditioner.In no case should children be allow ed to sit on the outdoor unit. The refr igerating circuit is leak-proof . 1.Applicable ambient temper ature[...]

Cautions STRICT ENFORCEMENT Safety Instruction Installation W ARNING Please read the f ollowing Safety Instructions carefully prior to use. The instructions are classified into two le vels , WARNING and CA UTION according to the seriousness of possible risks and damages as follo ws. Compliance to the instructions are str ictly required f or saf ety[...]

Cautions W ARNING When abnormality such as burnt-small found, immediately stop the operation button and contact sales shop. OFF Use an exclusive power source with a circuit breaker ENFORCEMENT Connect power supply cord to the outlet completely Use the proper voltage Do not use power supply cord in a bundle. Take care not to damage the power supply [...]

P ar ts and Functions 5 CHANGE-FOR-FRESH-AIR BOX OUTLET CONNECTING PIPING AND ELECTRICAL WIRING INLET 1 2 3 4 CHANGE-FOR-FRESH-AIR TUBE CHANGE FOR FRESH AIR SIGNAL WIRE DRAIN HOSE 5 6 7 UV light degerming device (inside) Displa y board Inlet Air Purifying Filter V er tical flap (adjust up and down air flo w. Don't adjust it manually) Horizonta[...]

P ar ts and Functions Used to select CODE A or B with a press,A or B will be display ed on LCD . Please select A without special explanation. 1.CODE When the remote controller appears abnormal, use a sharp pointed ar ticle to press this button to reset the remote controller normal. 2.RESET Used to select TIMER ON, TIMER OFF , TIMER ON-OFF . 4. TIME[...]

Remov e the batter ies in case unit won't be in usage f or a long per iod. If there are any displa y after taking-out, just need to press reset ke y. P ar ts and Functions Clock Set When unit is star ted for the first time and after replacing batteries in remote controller, clock should be adjusted as f ollows: Remote controller's operati[...]

Note: when the unit is operating health or sterilize function," " displayed on the display board and " " is displayed on the display board in the fresh function. Operation Remote controller 8 STERILIZE 2.Health anion function Air conditioner starts health anion function operation. For twice press, disappears,the operation stops.[...]

A uto Operation Operation Remote controller 9 STERILIZE About A uto Operation Under the mode of auto operation, air conditioner will automatically select Cool or Heat operation according to room temperature and setting temperature. 5.Unit stop Press ON/OFF button, the unit stops . 1. Unit star t Press ON/OFF on the remote controller, unit star ts. [...]

Cool Operation Remote controller 2.Select operation mode Press FAN button. For each press, fan speed changes as follows: Press MODE button. For each press, operation mode changes as follows: Remote controller: Remote controller: Then Select COOL operation Press TEMP. button Every time the button is pressed, temp.setting increase 1 o C,if kept depre[...]

2.Select operation mode Press F AN button. For each press , fan speed changes as f ollows: Press MODE button. For each press , operation mode changes as f ollows: Remote controller : Remote controller : Then Select DR Y operation Press TEMP . button Every time the button is pressed, temp .setting increase 1 o C ,if kept depressed, it will increase [...]

F an Operation 2.Select operation mode Press F AN button. For each press , fan speed changes as f ollows: Press MODE button. For each press , operation mode changes as f ollows: Remote controller : Remote controller : Then Select F AN operation 3.Fan speed selection 4.Unit stop About F AN operation In F AN operation mode, the unit will not oper ate[...]

Operation 2.Select operation mode Press F AN button. For each press , fan speed changes as f ollows: Press MODE button. For each press , operation mode changes as f ollows: Remote controller : Remote controller : Then Select HEA T operation Press TEMP . button Every time the button is pressed, temp .setting increase 1 o C ,if kept depressed, it wil[...]

2.Up and down air flo w direction V er tical flap P os.1 P os.1 P os.2 P os.3 P os.4 P os.6 P os.5 P os.4 P os.3 P os.2 P os.1 P os.6 P os.1 P os.2 P os.3 P os.4 P os.5 P os.6 P os.2 P os.3 P os.4 P os.5 P os.6 (Auto swing) F or each press of button, air flow direction on remote controller displa ys as f ollows according to different oper ation mod[...]

If the wind speed is high or middle before setting for the sleep, set for lowing the wind speed after sleeping. If it is low wind, no change. 5.Set the wind speed change when sleeping Bef ore going to bed, you can simply press the SLEEP button and unit will oper ate in SLEEP mode and bring you a sound sleep . Use of SLEEP function After the unit st[...]

Remote Controller T imer On/Off Operation Operation Hints: After replacing batteries or a power failure happens, time setting should be reset. Remote controller possesses memory function, when use TIMER mode next time, just press SET button after mode selecting if time setting is the same as previous one. 16 Set clock correctly before starting TIME[...]

Remote Controller T imer On-Off Operation Operation Just press TIMER button several times until TIMER mode disappears. According to the Time setting sequence of TIMER ON or TIMER OFF, either Start-Stop or Stop-Start can be achieved. Set clock correctly before starting TIMER operation. 1. After unit starts, select your desired operation mode Operati[...]

1.Press ON/OFF to starting Operation The liquid cr ystal will displa y the working state of last time (Except timer, sleeping, pow er/soft and health airflow). Setting the comf or t work conditions. 2.The setting of health airflow function 1).Press the button of health airflow, appears on the display. The nether inlet and outlet grills of the air c[...]

When the remote controller is manipulated, it gets the system back to the nor mal operation mode . Emer g ency and T est Operation Operation Emer gency operation: Use this operation only when the remote controller is def ective or lost. When the emergency operation s witch is pressed,the" Pi "sound is heard once, which means the star t of[...]

For Smar t Use of The Air Conditioner Setting of proper room temperature Close doors and windo ws dur ing operation If the unit is not to be used f or a long time, turn off the po wer supply main s witch. Use the timer eff ectiv ely Use the louv ers eff ectiv ely Do not b lock the air inlet or outlet Maintenance Proper temperature During cooling op[...]

For Smar t Use of The Air Conditioner W ARNING Air Filter cleaning Open the inlet grille by pulling it upw ard. Remov e the filter. Clean the filter. Attach the filter. Close the inlet grille. Push up the filter's center tab slightly until it is released from the stopper, and remov e the filter downward. Use a vacuum cleaner to remov e dust, o[...]

The green aspect of the bacteria-killing medium air purifying filter will face outside, the white aspect will face to the machine. 22 Common sense: Note: the bacteria-killing mediums placed on the left side. the multi-lights touching intermediary is placed on the right side. Maintenance 1.Open the lnlet Grille 2.Detach the standard air filter 3.Att[...]

T o K eep Y our Air conditioner in Good Condition after Season. Operate in cooling mode f or 2-3 hours. Put off the po wer supply cord. T ake out the batteries from the wireless remote controller. Cleaning the body . To pre v ent breeding mold or bad smell, be sure to operate at the designated temperature or 30 O C ,cooling mode and High speed f an[...]

Bef ore Setting in High season Cleaning the standard air filter. Connecting the ear thing cable . Do not b loc k the air inlet or outlet. Plug-in Caution Caution After brush awa y dust at the plug, inser t the plug of the pow er supply cord into the outlet completely .In case of suing exclusiv e circuit breaker,s witch on the circuit breaker. NO WE[...]

Is the air filter dir ty? Nor mally it should be cleaned e very 15 days . Are there any obstacles bef ore inlet and outlet? Is temperature set correctly? Are there some doors or windows left open? Is there any direct sunlight through the window during the cooling operation?(Use cur tain) Are there too much heat sources or too many people in the roo[...]