Fujitsu fi-5530C manuale d’uso

P3PC-1342-02EN[...]

[...]

fi-5530C Image Scanner Getting Started i CONTENTS ■ Regulatory Informatio n .......................... .............................. ii ■ Note, Liability .................. ..................................................... iii ■ Safety Precautions .... .................................... ........................ v Chapter1 PREPARING THE[...]

ii INTRODUCTION Thank you for purchasing the fi-553 0C Duplex Color Scanner. This document describes h ow to use fi-5530C and basic operation methods. Before you start u sing fi-5530C be sure to thoroughly read this manual to ensure correct use. The "Operator’s Guide" stor ed on the Setup CD Rom provides useful and detailed in formation[...]

fi-5530C Image Scanner Getting Started iii ■ Note, Liability READ ALL OF THIS MANUAL CAREFULL Y BEFORE USING THIS PRODUCT . IF THIS PRODUCT IS NOT USED CORRECTL Y , UNEXPECTED INJUR Y MA Y BE CAUSED T O USERS OR BYST ANDERS. Also, keep this manual in a safe place so that it can be easily referred to during use of this product. While all efforts h[...]

iv All the descriptions in this manual assume the usage of Adobe Acro bat bundled with this product. However , Adobe Acrobat may be upgraded without n otice. If the descriptions differ from the screens actually displayed, refer to the Acrobat’ s “Help”. Manufacturer PFU LIMITED International Sales Dept., Imaging Business Division, Produ cts G[...]

fi-5530C Image Scanner Getting Started v ■ Safety Precautions Do not damage the AC cable. Use only specified AC cables and connector cables Use this scanner only at the indicated power volt age. Do not connect to multiple- power strip s. Do not touch the AC cable with wet hands. Wipe any dust from the power plug. Do not inst all th e devi ce in l[...]

vi Do not install the scanner on unst able surfaces. Do not block the ventilation ports. Do not place heavy object s or st and on top of the scanner . Firmly insert the power plug. A void any contact when scanner is in use. Do not use the scanne r immediately after moving it from a cold place into a warm room. Before moving the scanner , disconnect[...]

fi-5530C Image Scanner Getting Started 1 Chapter1 PREP ARING THE SCANNER 1.1 Checking the Contents of the Scanner Package When you unpack the scanner package, make su re that the packa ge contains a ll the pa rts on the list included in the package . If any parts are missing or defective, contact your scan- ner dealer or an authorized FUJITSU scann[...]

2 1.3 Operator panel The operator panel is located on the right side of the scanner. The panel co nsists of a Function Number Dis- play, four buttons and a LED. . *) About the settings on the launcher, refer to FUJITSU TWAIN32 scanner driver h elp and the "fi-5530 C Operator’s Guid e" on the Setu p CD-ROM. ■ Indications on the Functio[...]

fi-5530C Image Scanner Getting Started 3 Chapter2 INST ALLA TION OF THE SCANNER 2.1 Installing the Scanner 1. Place the scanner at its installation site. For details on the scanner's dimensions and required installation space , refer to the fi-5530C Operator’s Guide "7.2 In stallation Specifications" on the Setup CD-ROM. 2. Attach [...]

4 2. Connect the other end of the USB interface cable to your PC. ■ Connecting with the SCSI Inter- face Cable When using the scanner with a SCSI interface, the fol- lowing SCSI interface cable and SCSI card must be pur- chased. • SCSI interface cable: Use a cable which complies with a 50 Pin Con- tact Shielded High-Density SCSI Devi ce Con- ne[...]

fi-5530C Image Scanner Getting Started 5 2.3 Installing the Scanner Application For scanning documents with this sca nner, both scanner driver and im age capt uring ap plication software (called "application" hereafter) must be installed on your PC. The following scanner drivers and applications are pro- vided: • Scanner Driver: FUJITSU[...]

6 5. Click [INSTALL PRODUCTS]. 6. Click [TWAIN Driver] on the window below. 7. Error Recovery Guide Installation window appears. Error Recovery Guide is a software that d i s- plays troubleshooting infor m ation on screen when any scanner error occurs. Althoug h this software’s installation is highly r ecommended, it can be installed later if you[...]

fi-5530C Image Scanner Getting Started 7 2. Click [INSTALL PRODUCTS]. 3. Click [ScandAll 21] on the window below. 4. Select a language used for insta llation on [Choose Setup Languag e] window and click [OK]. 5. Continue to install the applica tion following the instructions on the window. 6. When the [InstallShield Wizard Complete] win- dow appear[...]

8 6. Set scanning resolution, document size, etc. on the [TWAIN driver] window (for se tting details of scanning) and click the [Scan] butto n. 7. Documents are scanned, and the generated images are displayed on the [ScandAll 21] win- dow. If the scanning is completed without any troubles, the installation was performed successfully. For details on[...]

fi-5530C Image Scanner Getting Started 9 5. Click [INSTALL PRODUCTS]. 6. Click [ISIS Driver] on the window below. 7. Error Recovery Guide Installation windo w appears. Error Recovery Guide is a software that dis- plays troubleshooting information on scree n if any scanner error occurs. Althoug h this soft- ware’s installation is highly re commend[...]

10 3. Click [QuickScan PRO (Trial)] on the window below. 4. Continue to install the application following the instructions on the window. 5. Enter required information, then click [Next >]. 6. Install the application following the instructions on the window. ■ Confirming Installation 1. Load the documents on the scanner. For details on loading[...]

fi-5530C Image Scanner Getting Started 11 5. Select [Preview Scan] from the [Scan] me nu. And then the document is scanned. If the scanning completes without any trouble, the installation was performed successfully. Error Recovery Guide The Error Recovery Guide is a software that displays troubleshooting inform ation on screen if any scanner error [...]

12 Adobe ® Acrobat ® Install Adobe Acrobat from the "Adobe Acrobat CD-ROM" provided with th is scanner. 1. Insert the Adobe Acrobat CD-ROM into the CD-ROM drive. ⇒ The "Adobe Acrobat" wi ndow appears. 2. Select the language and Click [OK] button. 3. Select "Install Adobe Acrobat". 4. Click the [Next] button. The se[...]

fi-5530C Image Scanner Getting Started 13 ■ Uninstalling Supplied Programs Follow the procedure below to uninstall supplied pro- grams. 1. Start up your PC. 2. Exit all currently running programs. 3. Select [Control Panel] - [Add or re move Pro- grams] from the [Start] menu. ⇒ This displays the "Add or remove P rograms" screen which d[...]

14 5. Click the [Change/Remove] or [Remove] but- ton. 6. When the confirmation dialogbox appears, Click the [OK] or [Yes] button. ⇒ This executes the uninstallation. ATTENTION Screen displays may va ry slightly accord- ing to the operation system (OS) you are using. Follow the on screen instructio ns of the OS. Example: When the OS Windo ws 2000 [...]

fi-5530C Image Scanner Getting Started AP-1 Appendix1 TROUBLESHOOTING ■ Troubleshooting checklist Symptom Check this item Remedy Scanner does not turn on. Have you pushed the power button? Push the power button. Are the AC cable and AC adapter prop- erly connected to the scanner? Correctly connect the AC cable and the AC adapter . Disconnect the [...]

AP-2 Paper is not fed (pick error occurs frequen tly, or docu- ment stops midway). Do the documents satisfy the "Docu- ment Quality" and the "Multi feed Detection Conditions" in the chapt er 6 of the fi-5530C Operator’s Guide? Use the documents that satisfy the "Document Quality" and the "Multi feed Detection Co[...]

fi-5530C Image Scanner Getting Started AP-3 ■ Temporary error The following shows the procedure for releasing of each temporary error. • "U1" error 1. Remove j a mmed do cuments. (Refer to fi-5530C Operator’s Guide "5.1 Removing Jammed Documents" on the Setup CD-ROM..) 2. Confirm that the documents meet the paper condition[...]

AP-4 Appendix2 DAIL Y CARE ■ Cleaning Materials For details about the cleaning materials, contact the FUJITSU scanner dealer where you purchas ed the scan- ner. ■ Cleaning Method The ADF must be cleaned with a lint-free cloth moist- ened with the Cleaner F1. ■ Locations and Cycle for Cleaning For details on the cleaning the ADF, refer to &quo[...]

fi-5530C Image Scanner Getting Started AP-5 Appendix3 REPLACING CONSUMABLES ■ Consumables and Replacement Cycle The followings are the specif ications of consumables and their recommended replacement cycles. To purchase consumables, contact the store where you purchased the scanner or an authorized FUJITSU scanner service provider. The replacemen[...]

z Copying of the contents of this manual in whole or in part and copying of the scanner applic ation is forbidden under the copyright la w. z The contents of this manual are subject to change without notice. z PFU LIMITED is not liable whatso ever for any damages resulting from use of this scanner and proc edures described in this manual, profit lo[...]