Frigidaire FRA12EHT2 manuale d’uso

T ABLE OF CONTENTS www .frigidaire.com USA 1 -800-944-9044 www .frigidaire.ca Canada 1 -800-265-8352 All a bout th e Us e & Ca r e 10 Care and Cleaning .............................................. 10 Energy Saving Ideas ........................................... 2020213A1056 (June 2009) Product Registration 4 ............................................. Normal Sounds .................................................... 4 Air Conditioner Features 5 ....................................... Important Safety Instructions ............................... 2-3 Operating Instructions 5-10 .......................................... Before You Call ...............................................[...]

115V 15A 230V 15A 230V 20A Do not, under any circumstances, cut, remove or bypass the grounding prong. 230V 30A Grounding Prong Important Safety Instructions WARNING For Your Safety Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or an y other appliance. Read product labels for flammabilit y and other warnings. WARNING Prevent Accidents T o reduce the risk of fire, electrical shock, or injury to persons when using y our air conditioner , follow basic precautions, including the following: Be sure the electrical service is adequate for the model you hav e chosen. This information can be found on the serial plate, which is located on the side of the ca[...]

Important Safety Instructions 3 2009 Electrolux Home Products, Inc. All rights reserved. READ THIS SECTION BEFORE ATTEMPTING TO OPERATE AIR CONDITIONER. Unit must be upright for one hour prior to oper ating. Plug in & press RESET The power supply cord contains a current device that senses damage to the power cord. T o test your power supply cord do the following: Plug in the Air Conditioner . The power supply cord will have TWO buttons on the plug head. Press the TEST button. Y ou will notice a click as the RESET button pops out. Press the RESET button. Again you will notice a click as the button engages. The power supply cord is now supplying electricity to the unit. SAFETY PRECAUTIONS [...]

Record Your Model and Serial Numbers Record in the space provided below the model and serial numbers. On all models, the serial plate is located on the outside of the cabinet. Model No. Serial No. Register Your Product The self -addressed PRODUCT REGISTRA TION CARD should be filled in completely , signed and returned to the Frigidaire Company . Normal Sounds T oday’s high efficiency compressors may have a high pitched chat ter during the cooling cycle. High pitched Chatter Unit may vibrate and mak e noise because of poor wall or window construction or incorrect installation. Vibration Pinging or Swishing Droplets of water hitting condenser during normal operation may cause “pinging or sw[...]

5 Air Conditioner Features & Operating Instructions Before you begin, thoroughly f amiliarize yourself with the control panel and remote as shown below and all its functions, then follow the symbol f or the functions you desire. The unit can be controlled by the touch pad alone or with the remote. ELECTRONIC CONTROL Air Conditioner Features 2009 Electrolux Home Products, Inc. All rights reserved. ADJUSTS TEMPERA TURE OR TIME DISPLA YS TEMPERA TURE/TIME SETS F AN SPEED SETS MODE TURNS UNIT ON OR OFF ACTIV A TES TIMER CHECK FIL TER RESET BUT TON REMOTE TEMP SENSING INDICA TOR (some models) SLEEP MODE w/DISPLA Y & REMOTE SENSING BUT TON FOR HEA T MODELS Battery Size: AAA Warning: Do not[...]

6 Operating Instructions Operating Instructions 2009 Electrolux Home Products, Inc. All rights reserved. TO CHANGE TEMPERATURE SETTlNG: YOU WILL SEE: TO ADJUST FAN SPEEDS: YOU WILL SEE: TO USE AUTO FAN FEATURE: DO THIS: DO THIS: PRESS TO SELECT YOU WILL SEE: DO THIS: PRESS F AN BUT TON SELECT AUT O Note: F an starts at High Speed and adjusts to a slower speed as the room temperature dictates. F or example, if the room doesn't get too warm, it will stay at the slowest speed. If the room temper ature rises quickly , such as a door being opened, it will auto - matically go to the highest speed. The fan speeds will re-adjust back to the slowest speed as the room returns to the original set [...]

7 Operating Instructions Operating Instructions (continued) 2009 Electrolux Home Products, Inc. All rights reserved. TO USE THE ENERGY SAVER FEATURE: YOU WILL SEE: TIMER: DELAY STOP / START FEATURE YOU WILL SEE HOW MUCH TIME IS CHOSEN: Note: In this mode, the fan will continue to run for 1 minute after the compressor shuts off. The fan then cycles on for 20 sec onds at 10 minute intervals until the room temperature is above the set temperature, at which time the compressor turns back on. DO THIS: PRESS MODE BUTTON CHOOSE ENERGY SAVER THEN DO THIS: PRESS UP/DOWN SET BUTTONS FIRST DO THIS: PRESS TIMER BUTTON Note: For Delay Stop, the unit must be in the On position ． Note: For Delay Start, t[...]

Note: This feature can be activated from the remote control ONLY, the unit must be in a cooling mode. To activate the remote sensing feature, point the remote control towards the unit and press the remote sensing Start button. Ne xt, use the “ ” buttons to set the desired temperature at the remote. (Note that the set temperature will only be displayed on the unit itself ). The LIGHT on the unit control will pulse to indicate it received the signal. The LIGHT on the remote control will pulse each time it sends a signal. lt will periodically send this signal until the feature is deactivated by pressing the remote sensing Stop butt on. lf the unit does not receive the remote sensing signal [...]

9 Operating Instructions Operating Instructions (continued) 2009 Electrolux Home Products, Inc. All rights reserved. TO TURN UNIT OFF: YOU WILL SEE: DO THIS: PRESS ON/OFF BUTTON ADDITIONAL THINGS YOU SHOULD KNOW Now that you have mastered the operating procedure, here are more features in your control that you should become familiar with . The "Cool" circuit has an automatic 3 minute time delayed start if the unit is turned off and on quickly. This prevents overheating of the compressor and possible circuit breaker tripping. The fan will continue to run during this time. The control will maintain the set temperature within 2 degrees Fahrenheit, between 60F and 90F degrees (in cool [...]

Operating Instructions & Care and Cleaning & Energy Saving Ideas 10 2009 Electrolux Home Products, Inc. All rights reserved. Energy Saving Ideas Do not block air flow inside with blinds, curtains or furniture; or outside with shrubs, enclosures, or other buildings. The capacity of the room air conditioner must fit the room size for ef ficient and satisfactory oper ation. Install the room air conditioner on the shady side of your home. A window that faces north is best because it is shaded most of the day . Close the fireplace damper , floor and wall r egisters so cool air does not escape up the chimney and into the duct work. K eep blinds and drapes in other windows closed during the[...]

OCCURRENCE SOLUTION W all plug disconnected. Push plug firmly into wall outlet. Plug Current Device T ripped. Press the RESET button. House fuse blown or circuit breaker tripped. R eplace fuse with time delay type or reset circuit break er . Control is OFF . T urn Control ON and set to desired set ting. Air conditioner will not operate. Air conditioner cooling, but room is too warm - NO ice forming on cooling coil behind decorative front. Dirty air filter - air restricted. Clean air filter . Ref er to Care and Cleaning section. T emper ature is set too high. Set temperature to a lower setting. Air directional louvers positioned improperly . Position louvers for better air distribution. Front[...]

Major Appliance Limited Warranty 12 Exclusions 1. Products with original serial numbers that have been remov ed, altered or cannot be readily determined. This warranty does not cover the following: 2. Product that has been transf erred from its original owner to another party or removed outside the US A or Canada. 3. Rust on the interior or exterior of the unit. 4. Products purchased "as-is" are not cov ered by this warrant y . 5. Food loss due to an y refrigerator or freezer failures. 6. Products used in a commercial setting. 7 . Service calls which do not involve malf unction or defects in materials or workmanship, or f or appliances not in ordinary household use or used other th[...]