Electrolux DD 8794 manuale d’uso

DD 8794 DD 8795 CHDD 8795 Dunstabzugshaube Afzuigkap Hotte Cooker Hood Campana extractora Montage- und Gebrauchsanweisung Installatie- en gebruiksaanwijzing Notice d’utilisation et d’installation Operating and Installation Instructions Instrucciones de montaje y manejo[...]

53 Contents Safety warnings 5 4 For the user 5 4 For the installer 5 4 Description of the Appliance 5 6 Extractor version 5 6 Filter V ersion 5 6 Control Panel 5 7 Switching on the hood 5 8 Switching on the light 5 8 Control device for grease or charcoal filter 5 8 Led signal for grease filter 5 8 Led signal for charcoal filter 5 8 Re-setting the s[...]

54 Safety warnings For the user • The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. • Always cover heating elements, to prevent excess heat from damaging the appliance. In the case of oil, gas and coal fired cookers it is essential to avoid open flames. • Also, when frying, keep the deep fry[...]

55 • The air outlet installation must comply with the regulations laid down by the relevant authorities. • When the unit is used in its extractor version, a sufficiently large ventilation hole must be provided, with dimensions that are approxi- mately the same as the outlet hole. • National and regional building regulations impose a number of[...]

56 Description of the Appliance • The hood is supplied as an extractor unit and can also be used with a filtering function by fitting one charcoal filter . • Y ou will need an original AEG charcoal filter for this function (Available from your local AEG Service Force Centre). Extractor version • In this version fumes are extracted to the outs[...]

57 Control Panel • Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking, you will then get an under pressure in the kitchen. The hood should be left on after cooking for about 15 minutes or until all the odours have disappea[...]

58 Switching on the hood - Fig. 3 The control ball is a balancer switch. Depressing the control ball repeatedly towards the bottom, switches on the hood and you may select the motor level desired, depressing once again the hood switches off. Switching on the light - Fig. 3 Depress the control ball towards the top : once for submersed lighting, once[...]

59 Maintenance and care • The hood must always be disconnected from the electricity supply before beginning any maintenance work. Cleaning the hood • Clean the outside of the hood using a damp cloth and a mild deter- gent. • Never use corrosive, abrasive or flammable cleaning products. • Never insert pointed objects in the motor ’ s prote[...]

60 Handle Fig. 5 Removing the metal grease filter Pull the handle downards, then extract the filter. Fig. 5 . Hand washing Soak grease filter(s) for about one hour in hot water with a grease- loosening cleaner , then rinse off thoroughly with hot water . Repeat the process if necessary . Refit the grease filters when they are dry . Dishwasher Place[...]

61 Charcoal filter • The charcoal filter should only be used if you want to use the hood in the recirculation function. • T o do this you will need an original AEG charcoal filter (available from your local Service Force Centre). • Cleaning/replacing the carbon filter Unlike other carbon filters, the LONGLIFE carbon filter can be cleaned and [...]

62 W arning • Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. Y ou are therefore strongly recommended to follow these instructions. • The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe th[...]

63 Special accessories Charcoal filter KF 14* E-Nr . 942 120 604 Remote control RM 8700* 942 120 658 T elescopic chimney (for extractor version only)* 942 120 750 Stainless steel side panels (Only DD 8794)* 942 120 768 Aluminium side panels 942 120 769 * Not available in UK, please contact your local Service Force Centre. T echnical assistance serv[...]

64 T echnical Specifications Dimensions (in cm): Height x Width x Depth 80 x 89,8 x 33,5 Maximum absorbed power: 235 W Motor absorption: 175 W Lighting: 3 x 12V 20W halogen lamps T ype GU4 Length of the cable: 150cm Electrical connection: 230 V Mounting accessories included 1 support bracket 1 deflector 3 Rubber strips 2 Screw caps 1 template 2 spa[...]

65 Electrical connection (not for UK) Safety warnings for the electrician Before connecting the appliance to the power supply , check that the voltage indicated on the rating plate corresponds to the mains power supply available. Appliances fitted with a plug can be connected to any standard power socket within easy access. Should it be necessary t[...]

66 • Place the three rubber strips on the back of the cooker hood. Where necessary mount the two spacers provided on the drill holes for definitive fixing. The spacers are useful when the wall which is to house the cooker hood is not perfectly vertical (for example: where it is partially covered with wall tiles). W all unit mounting - Fig. 8-9-10[...]

67 1 2 3 4 4 5 5 6 6 7 8 8 9 • Mark the wall with a centre line, this will aid mounting procedure (1) , position the template so that the mid line printed on the template matches with the centre line previously marked, the lower side of the template corresponds to the lower side of the hood once mounted (2) . • Drill two holes Ø 8mm and fix th[...]

68 1 2 3 4 12 14 13 13 10a 10b 11 Fig. 10 Extractor version Filter version Fig. 1 1 • Fix the sides of the cooker hood by fastening the pins (10a) to the sides of the fastening screws (10b). Only DD 8794 (not UK) : side panels are available as a special accessory please contact your local Service Centre (or see paragraph “ Special Accessory ”[...]

LI10U E Ed. 0 4 /03 AEG Hausger ä te GmbH Postfach 1036 D-90327 N ü rnberg http://www .aeg.hausgeraete.de http://www .aeg.co.uk © Copyright by AEG[...]