CrimeStopper CS-2016FM manuale d’uso

CS-2016FM The Informer II™ 2-Way FM Paging Alarm & Remote Engine Starting System OPERATION INSTRUCTIONS INTRODUCTION CONGRATULATIONS on your choice of the Informer II ™ by Crimestopper Security Products Inc. This booklet contains the information necessary for oper ati ng your system. If any questions arise, contact your insta llation dealer[...]

TABLE OF CONTENTS Operation Cautions & Warnings ……..…………..……………………………………………………………………2 Transceiver / Pager-Remote ……….....…………..……………… ……………………………………………………3 CS-397TW Sidekick Remote Contro l…………………….?[...]

TRANSCEIVER / PAGER-REMOTE PAGER / REMOTE TRANSCEIVER: #1 ARM/ LOCK #4 ENGI NE ST AR T/STOP #5 RECALL / CAR I OR II #3 TRUNK POP #2 DISARM/ UNLOCK ANTENNA START FIXED LCD SCREEN PM The hand-held remote transceiver is used to send and receive information from the vehicle. Th e Control Module transmits High Frequency FM signals from the vehicle to yo[...]

CS-397TW SIDEKICK REMOTE The CS-397TW 1-Way sidekick remote adds flexibility to your CS-2016FM. You can have the convenience of operating your system without needing to carry the larger pager remote. The Sidekick remote has less range and offers all of the same operation features except for page-back confirmation. See diagram below for Sidekick 1-W[...]

OPERATING INSTRUCTIONS - ALARM Active Arming / Locking: PM ARM/LOCK Press button #1 (Lock symbol) on the transce iver. The System w ill arm emit one siren chirp, one light flash, and the LED will begin to flash. Power locks will lock (if equipped). Starter disable circuit will turn on. LC D Pager will beep once while displaying a Down Arrow and a L[...]

OPERATING INSTRUCTIONS - ALARM Disarming While Tripped (Triggered): Disarming the System while it is triggering requires TW O presses of the #2 Unlock Bu tton. The first press of Button #2 Resets the alarm cycle only (system still arme d) while a second press will disarm/unlock the system. Selective Silent Arming/Disarming: To Arm or Disarm the sys[...]

OPERATING INSTRUCTIONS - ALARM Pre-Warning Shock Protection PM PRE-WARN The Pre-warning (warn-away) feature will activate when a low-level shock or vibration detected by the system’s sho ck sensor. The alarm will chirp the siren 5 times and flash the lights once to help deter any further tampering with the vehicle. The pager/remote will vibrate t[...]

OPERATING INSTRUCTIONS - ALARM Emergency Override (Disarm) If you have lost the transmitter or it stops working for any reason and the Alarm is armed, you will have to disarm the system manually. Open the door with the key [alarm wil l sound], turn the ignition on, and press the override/program button for about 5 second s. The Alarm will disarm an[...]

REMOTE ENGINE CONTROL REMOTE ENGINE STARTING - SUCCESSFUL START 1) Press remote start button on the re mote transmitter. System will chi rp 3 times for audible confirm ation. (Chirps can be programmed on or o ff-See installation manual.) 2) Parking lights flash once, then turn on so lid, Ignition/Accessory circuits turn on. 3) After a few seconds, [...]

REMOTE ENGINE CONTROL UNSUCCESSFUL REMOTE START In the event that the engine does not start on the first attempt, the system shuts down for a few seconds, then attempts to restart the engine a 2 nd and 3 rd time. For hard starting engines, th e unit will allow a starter crank time of up to13 seconds maximum. This should provide ampl e cranking time[...]

REMOTE ENGINE CONTROL IDLE DOWN MODE (T AKE-OVER OPERATION) This mode allows the unit to take over operation of your idling, parked vehicle while the ignition key is removed and you exit the vehicle. The vehicle is put into a remote running condition before you exit and it will remain running for the progra mmed run time, until you return, or until[...]

REMOTE ENGINE CONTROL TIMED SELF START MODE This mode allows the vehicle to be programmed to self-start every 4 hours and run for the programm ed run time. This can be helpful during extremely cold condition s where engine or fluid freez e-up is a concern. !!THE VEHICLE MUST BE OUTDOORS OR IN A WELL VENILATED AREA!! TIMED SELF-START MODE – EXITIN[...]

OPTIONAL TURBO TIMER MODE OPTIONAL TURBO TIMER MODE: IMPORTANT NOTE: This mode requir es the use of an extra part called a momentary switch or button that is not included with the kit. Check with your installer about adding this feature. The optional Turbo Timer mode allows the your system to keep your vehicle running for 1 to 5 minutes [selectivel[...]

ANTI CARJACK PROTECTION REMOTE OPERATED CA RJACK PROTECTION This feature provides Active Carjack protection through the remote control. When the Ignition is on (vehicle is running), press and hold the #1 LOCK Button and #3 TRUNK Button fo r 2 seconds. The parking lights will flash 2 times and the LED will begin to flash rapidly to confirm the begin[...]

LED DIAGNOSTICS The CS-2016FM system includes disarm diagnostics, through the RED LED ligh t, that will help in determining what caused the last trigger of the alarm system. This is a valuable tool in determining how the vehicle was tampered with or if there is a false alarm problem in wh ich case you can make the necessary adjustments to correct t[...]

TRANSCEIVER / REMOTE CONTROL PROGRAMMING IGN OFF W A IT FOR 4 FLA SHES PRESS 4 X's FLA SH 2, 3, or 4 X's (BLUE WIRE GROUNDED) 2-W A Y S YSTEMS & IGN OFF PRESS T OGETHER LOCK & UNLOCK "SideK ick" RE M OTE S COMPLETE LCD Code-Le arn Screen 16[...]

2 VEHICLE OPERATION 2 VEHICLE CONTROL Your CS-2016FM remotes have the abilit y to control a sec ond vehicle with a Crimestopper CS-2016FM or older CS-2015FM system installed. See diagram below on how to switch your remote(s) to vehicle #2 operation. To set up the 2-Vehicle operation you must first program your remotes to Vehicle #2. Follow the “T[...]

TROUBLESHOOTING FAQ’s: “BEFORE YOU CALL SECTION” Before calling your dealer or Crimestopper, read the following section for tips that may remedy or explain your problem. RANGE QUESTIONS (2-Way Pager/Remote): Your CS-2016FM system uses FM High-Frequency signals to send/receive data between the pager and the vehicle and from the vehicle to the [...]

TROUBLESHOOTING continued WHEN ARMING AND DISARMING MY ALARM HAS IRREGULAR “LONG” SIREN CHIRPS: This is an audible warning that the battery in the L CD pager remote is low. Replace the AAA battery in the pager and your chirps w ill return to normal. SYSTEM IS NOT SUCCESSFUL AT REMOTE STARTING DURING EXTREME COLD CONDITIONS: Please be aware that[...]

SETTING THE CLOCK (2-WAY- LCD REMOTE) 1. Press and hold all 4 buttons of remote control for approximately 3 seconds until remote beeps. 2. The minute display will begin flashing. Use the lock and unlock button to change the minute up or down to the correct time and then press button #3 (Trunk) to set the minute value. 3. The hour display should beg[...]

ONLINE TECHNICAL SUPP ORT www.crimestopper.com/techweb 03.html Crimestopper Security Products Inc. 1770 So. Tapo Street Simi Valley, CA 93063 (800) 998-6880 www.crimestopper.com email@crimestopper.com ©2004 Crimestopper Security Products[...]