RedMax Power Auger AG2300 manual

The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. WARNING OWNER / OPERA T OR MANUAL POWER AUGER 3898-93110 (711) AG2300 Thank you for purchasing a RedMax product. Before using our power auger, please read this manual carefully to understand the proper [...]

Read this manual carefully to understand all safety precautions, controls, proper operation and maintenance of your RedMax power auger . Failure to do so could result in serious injury . Instructions labeled as shown at left, concern critical steps or procedures which must be followed in order to prevent accidents which could lead to serious bodily[...]

CONTENTS SAFETY PRECAUTIONS .................................................................................. 4 IN ORDER TO ENSURE PROPER AND SAFE OPERATION OF YOUR POWER AUGER WORK GEAR AND CLOTHING WARNINGS CONSIDERING HANDLING OF FUEL THINGS TO CHECK BEFORE USING YOUR POWER AUGER THINGS TO CHECK BEFORE STARTING UP THE ENGINE AVOID NOISE PROBLEM[...]

■ In order to ensure proper and safe operation of your power auger • Read this Owner/Operator Manual carefully. Be sure you understand how to operate this unit properly before you use it. Failure to do so could result in serious injury. • Be sure to keep this manual handy so that you may refer to it later whenever any questions arise. Also no[...]

Safety Precautions ■ Work gear and clothing • When using your power auger, always be sure to wear strong, durable, work clothing; shirts should be long-sleeved shirts and pants should be full-length pants reaching down to the ankles. • Always be sure to wear and helmet and face protector when using your power auger. • When using your power [...]

 6  Safety Precautions ■ Things to check before using your power auger • Before beginning work, look around carefully to get a feel for the shape of the land, and whether or not there are any obstacles which might get in the way while working, and remove any obstacles which can be cleared away before beginning work. • The area within a [...]

■ Things to be careful about when using your power auger • When using your power auger, grip the handles of the power auger firmly with both hands, place your feet slightly apart (slightly further apart than the width of your shoulders) so that your weight is distributed evenly across both legs, and always be sure to maintain a steady, even pos[...]

 8  Safety Precautions ■ Notes on care and maintenance of your power auger • In order to maintain your power auger in proper working order, perform the maintenance and checking operations described in this manual at regular intervals. In the event that any parts must be replaced or any maintenance or repair work not described in this manu[...]

• Gasoline is very flammable. Avoid smoking or bringing any flame or sparks near fuel. Make sure to stop the engine and allow it cool before refueling the unit. Select outdoor bare ground for fueling and move at least 3m(10ft) away from the fueling stop before starting the engine. • The RedMax engines are lubricated by oil specially formulated [...]

 10  Operation • The throttle lock makes starting easier. Always use it when starting the engine. 5. While firmly holding the auger as illustrated, vigorously pull the starter rope. 6. When engine has ignited first, open the choke (move the choke lever backward), pull the starter rope again and the engine will start. • Keep the drill clea[...]

Operation ■ Stopping Engine • Release the throttle lever and press on the red button until the engine comes to a complete stop. ■ Drilling • Keep a firm grip of the auger at all times on a wide stance and by holding the handle with both hands. •A reacting motion may occur on the auger when spinning drill has hit on stones or tree roots un[...]

 12  Maintenance • Before cleaning, inspecting or repairing your unit, make sure that engine has stopped and is cool. Disconnect the spark plug terminal to avoid accidental engine starts. ■ Daily Inspection •R emove grass or dust, from the entire body. • Check that all nuts and screws are securely tightened, and no parts are missing. [...]

 13  Storage ■ Before Long-term Storage • Drain fuel tank and run engine out until all fuel in the carburetor is used up. • Remove the spark plug and drop a spoonful 2 cycle oil into the cylinder. Crank the engine several times and replace the plug. Pull starter until compression is felt. • Brush off dirt from the drill surface and ap[...]

Model Name AG2300 Engine Displacement cu.in(cc) ........................................................................................1.37 (22.5) Maximum power HP ....................................................................................1.2 at 7500 rpm Carburetor ..........................................................................[...]

Parts List NOTE : 1. Use KOMATSU ZENOAH genuine parts as specified in the parts list for repair and/or replacement. 2. KOMATSU ZENOAH does not warrant the machines, which have been damaged by the use of any parts other than those specified by the company. 3. When placing parts orders for repair and/or replacement, check if the model name and the se[...]

Parts List : AG2300  16  Fig.1 AUGER DRIVE SHAFT GROUP[...]

AG2300 Fig.1 AUGER DRIVE SHAFT GROUP Key# Part Number Description Q'ty 1 3890-11101 CASE(A)COMP 1 2 3890-11112 • CASE(A) 1 3 3890-11140 • PIN 2 4 3890-11201 CASE(B)COMP 1 5 06030-06001 BEARING 1 6 06031-06001 BEARING 1 7 06030-06202 BEARING 1 8 06034-06202 BEARING 1 9 3127-13230 SPACER 1 10 04065-03515 RING 1 11 3890-12110 DRUM 1 12 04064-[...]

Parts List : AG2300  18  Fig.2 DRILL and ACCESSOR Y GROUP[...]

AG2300 Fig.2 DRILL and ACCESSOR Y GROUP Key# Part Number Description Q'ty 1 3206-52700 DRILL S20 ASSY 1 2 3206-52710 • DRILL S20 1 3 3200-51130 • PIN 1 4 3200-51140 • CLIP 1 5 3206-52800 DRILL S30 ASSY 1 6 3206-52810 • DRILL S30 1 7 3200-51130 • PIN 1 8 3200-51140 • CLIP 1 9 3202-51102 DRILL S40 ASSY 1 10 3202-51112 • DRILL S40 1[...]

Parts List : AG2300  20  Fig.3 ENGINE GROUP[...]

AG2300 Fig.3 ENGINE GROUP Key# Part Number Description Q'ty 1 5602-12110 CYLINDER 1 2 5500-12211 GASKET,base 1 3 1850-12130 BOLT 2 4 5500-13162 INSULATOR 1 5 5500-13120 GASKET,insulator 1 6 5500-13130 GASKET,carburetor 1 7 0263-90520 SCREW M5x20 2 8 5602-15110 MUFFLER 1 9 1601-15120 • ARRESTER 1 10 01252-30550 BOLT M5x50 2 11 5500-15210 GASK[...]

Parts List : AG2300  22  Fig.4 CARBURET OR GROUP[...]

AG2300 Fig.4 CARBURET OR GROUP Key# Part Number Description Q'ty 1 5501-81000 CARBURETOR ASSY WYJ-113 1 2 1752-81110 • SCREW 2 3 5500-81120 • BRACKET 1 4 1751-81130 • E-RING 1 5 1881-81140 • SWIVEL 1 6 5501-81150 • VALVE ASSY 1 7 1918-81170 • SCREW,adjust 1 8 1751-81180 • NUT 1 9 1881-81130 • RING 1 10 1751-81240 • O-RING 1 1[...]

KOMA TSU ZENOAH AMERICA INC. 1505 Pavilion Place Suite A Norcross, Georgia 30093 ©P rinted in Japan RedMax ® POWER AUGER MODEL AG2300 2-YEAR LIMITED W ARRANTY For two (2) years [1 year if used commercially] from the date of original purchase of the model AG2300 unit, KOMATSU ZENOAH AMERICA INC. (the “Company”), through any RedMax ® dealer, w[...]