PYLE Audio PLDVD168 manual

DVD/VCD/CD/MP3 PLA YER WITH MANUALL Y TUNED SYNTHESIZER STEREO RADIO ENTER SETUP 5 1 6 9 2 7 0 8 +10 34 F .BWD F .FWD NEXT PREV . ANGLE PLAY/P AUSE SUBTITLE ZOOM TITLE AUDIO DISPLAY EJECT GOTO STOP REPEAT A-B SLOW AUX MUTE DISC-RPT ST FLA T ROCK CLAS POP LOUD LOC TRA C K MUTE RND INT SW PWR EQ CLK MON BND MOD SEL EJ REL TUNE LOC MU OWNER'S MAN[...]

Safety Information ........................................................................................ 3 Disc Notes .................................................................................................... 4 Installation.....................................................................................................5 Electric Co[...]

CAUTION: THIS DVD PLA YER IS A CLASS I LASER PRODUCT . HOWEVER THIS DVD PLA YER USES A VISIBLE/INVISIBLE LASER BEAM WHICH COULD CAUSE HAZARDOUS RADIA TION EXPOSURE IF DIRECTED. BE SURE TO OPERA TE THE DVD PLA YER CORRECTL Y AS INSTRUCTED. USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MA Y RESUL T IN H[...]

Disc formats supported by this player DVD 12 cm disc (Single-sided disc only) Video CD 12 cm disc CD 12 cm disc MP3 12 cm disc Discs which cannot be played with this player • DVD-ROM • DVD-R/DVD-RAM • CDV • CD-G Handling and Cleaning • Dirt, dust, scratches and warping disc will cause misoperation. • Do not place stickers or make scratc[...]

INST ALLA TION Notes: • Choose the mounting location where the unit will not interfer e with the normal driving function of the driver . • Before finally installing the unit, connect the wiring temporarily and make sur e it is all connected up properly and the unit and the system work pr operly . • Use only the parts included with the unit to[...]

6 INST ALLA TION PLAIN WASHER HEX BOL T MET AL MOUNTING STRAP DASH BOARD CONSOLE SLIDE BRACKET HOUSING HEXNUT SPRING WASHER PLAIN WASHER T APPING SCREW[...]

7 HOW TO REMOVE AND INST ALL THE FRONT P ANEL 1. Press the r elease button and pull-off the fr ont panel. Keep the front panel into the case. 2. T o install the front panel, insert the panel into the housing and make sur e the panel is properly installed, otherwise, abnormalities occurs on the display or some keys will not function properly . REMOV[...]

VIOLET/BLACK GREY MEMORY BACK-UP (B+) POWER ANTENNA GROUND (B-) RED YELLOW BLACK BLUE FRONT Lch SPK. REAR Lch SPK. GREY/BLACK VIOLET WHITE WHITE/BLACK GREEN GREEN/BLACK CHOKE BOX ANTENNA CONNECTOR RCA CABLE FRONT RCA OUTPUTCABLE FRONT Rch SPK. REAR Rch SPK. MAIN UNIT 8 ELECTRIC CONNECTION VIDEO IN YELLOW RCH IN RED LCH IN WHITE VIDEO OUT 1 YELLOW V[...]

9 REMOTE CONTROL ENTER SETUP 5 1 6 9 2 7 0 8 +10 34 PBC F .BWD F .FWD NEXT PREV . ANGLE PLAY/P AUSE SUBTITLE ZOOM TITLE AUDIO DISPLAY EJECT GOTO STOP REPEAT A-B SLOW AUX MUTE F .FWD NEXT PREV . ANGLE PLAY/P AUSE SUBTITLE AUDIO DISPLAY EJECT GOTO STOP SLOW AUX MUTE 11 12 13 14 15 16 17 18 19 21 22 1 2 3 4 5 6 7 8 10 20 9 1. GOTO Disc search button, [...]

Preparing the Remote Contr ol Inserting the Batteries 1. Open the battery compartment cover . 2. Insert the new batteries. Make sure that the positive and negative terminals of the batteries are oriented indicated. 3. Close the cover . Using the Remote Control Face the remote contr ol towards the player fr ont face IR mark (remote contr ol signal r[...]

DISC-RPT ST FLAT ROCK CLAS POP LOUD LOC TRA CK MUTE RND INT SW PWR EQ CLK MON BND MOD SEL EJ REL TUNE LOC MU 11 BASIC OPERA TION VOL BAS TRE BAL F AD (V olume) (Bass) (T reble) (Balance) (Fader) 16 17 ON/OFF Press POWER button (13) to turn on the unit. Press it again to turn off. F ACEPLA TE RELEASE SET Press REL button (2) to detach the r emovable[...]

V olume Adjust volume level by using VOL+ (12) and VOL- (11) buttons. Note:The unit is initially set to volume mode. Bass Press SEL button (10) one time. Adjust bass level by using VOL+(12) and VOL-(11) buttons. T reble Press SEL button (10) two times. Adjust tr eble level by using VOL+(12) and VOL-(11) buttons. Balance Press SEL button (10) thr ee[...]

FLASHING LED If the front panel is not on the main unit, LED (16) will be flashing. RESET BUTTON FUNCTION RESET button (17) is placed on the housing and must be activated with either a ballpoint pen or thin metal object. The RESET button (17) is to be activated for the following reasons: -Initial installation of the unit when all wiring is complete[...]

14 Pause (still picture) Pressing during playback will stop play temporary . Return to normal playback, press once again. Repeat Press the REPEA T button to select repeat mode as follow: DVD: Press the REPEA T button to select repeat mode as follow . VCD/CD Press the REPEA T button to select repeat mode as follow: 1. Continuously repeat at the curr[...]

15 (3) Press DISPLA Y for the third time: T :01/18 P: 00:00:25 LR DISC TOT AL ELAPSED (4) Press DISPLAY for the fourth time: T :01/18 P: 00:00:25 LR DISC TOT AL REMAIN (5) Press DISPLA Y for the fifth time: The message on the screen will be clear ed. for SVCD and VCD. Note: For CD and Mp3, the message will always display on the screen. MP3: Each ti[...]

MP3 Disc Play MP3 disc is playing as the format of FOLDER by FOLDER. For example: Use / / / to select the item or folder , then press ENTER button. Pressing REPEAT button r epeatedly can select three kinds of r epeat play mode. REP-ONE: Play the same song over and over again. FOLDER REPEA T : Play all songs in the current dir ectory in sequence, ov[...]

17 INITIAL SETUP SETUP MENU --- MAIN P AGE 1. Press SETUP in the stop mode. (Press the stop button twice to ensur e the player under STOP mode.) 2. The initial SETUP menu is displayed. 3. Select the preferr ed item by using the / buttons. 4. Press ENTER buttons. a. GENERAL SETUP This setup page includes all the item of TV display & audio output[...]

18 --- GENERAL P AGE --- PIC mode setup Select AUTO, the player PIC mode will depend on DVD disc. Select HI-RES format for best image resolution. Select N-FLICKER format on format on image or picture under noise af fect. --- GENERAL P AGE --- ANGLE MARK display setup If it is set to ON, when the multi-angle DVD disc is playing, (the angle mark) wil[...]

19 --- GENERAL P AGE --- SCR SA VER setup Select the SCR SA VER output ON/OFF . SPEAKER SETUP --- SPEAKER SETUP P AGE --- This is to activate the audio output from DOLBY AC3 5.1 DOWNMIX to 2 channel mode. Select the preferred SPEAKER connection by using the cursor buttons. - Select the L T/RT to activate the Dolby surround compatible output. - Sele[...]

SETUP PREFERENCES SETUP --- PREFERENCES P AGE --- TV type setup This player can play discs recor ded in either P AL or NTSC format. Select NTSC format, when you connected to NTSC TV . Select P AL format, when you connected to P AL TV . Select AUTO format, the player TV output format will according to the DVD disc format. --- PREFERENCES P AGE --- A[...]

21 SETUP --- PREFERENCES P AGE --- P ARENT AL Select suitable parental guidance by the cursor buttons and conformed by pressing ENTER button. --- PREFERENCES P AGE --- P ASSWORD Select the change and press ENTER button. T ype the old password (The initial factory code is 3308 ) and key in 4 characters password now you want to use, and retype again [...]

--- PREFERENCES P AGE --- DEF AUL TS Select reset to become factory initial setting. --- PREFERENCES P AGE --- MP3 PLA Y In this item, you can select NO MENU mode or WITH MENU mode. DEF AUL TS T ABLE 22 SETUP RESET TV TYPE AUDIO SUBTITLE DISC MENU P ARENT AL P ASSWORD DEF AUL TS SMART NA V MAIN P AGE NO MENU WITH MENU TV TYPE AUDIO SUBTITLE DISC ME[...]

SPECIFICA TIONS Supply voltage : 12V DC (11V -15V), test voltage 14.4V , negative gr ound Current consumption : Less than 7A Signal system : Compositive video 1.0Vp-p 75 Ω Discs played : (1) DVD-VIDEO disc 5 ” (12 cm) single-sided, single-layer 5 ” (12 cm) single-sided, double-layer (2) Compact disc (CD-DA,VIEDO CD) 5 ” (12 cm) disc Audio O[...]

TROUBLE SHOOTING Before going thr ough the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer . Symptom Cause Solution No power . The car ignition switch is If the power supply is properly not on. connected to the car accessory terminal, switch the ignition key to [...]