Craftsman 536.8852 manual

3.8 Horsepower 4-Cycle Engine 21 Inch Single Stage Auger Propelled SNOW THROWER MODEL NO. 536.885200 Caution: Read and follow all Safety Rules and Operating Instructions before first use of this product. SEARS, ROEBUCK AND CO., Hoffman Estates, IL 60179 U.S.A. a 0 H 0 H g F-001072M 09101/99[...]

WARRANTY STATEMENT ...... 2 SAFETY RULES ............... 3 INTERNATIONAL SYMBOLS .... 5 ASSEMBLY ................... 7 OPERATION .................. 9 MAINTENANCE ............... 15 SERVICE AND ADJUSTMENT .. 18 STORAGE .................... 23 TROUBLE SHOOTING CHART.. 24 REPAIR PARTS ............... 26 ENGINE REPAIR PARTS ....... 32 SPANISH (ESPANOL)[...]

_IL OOK FOR THIS SYMBOL TO POINT OUT IMPORTANT SAFETY PRECAUTIONS. IT MEANS-- ATTENTION!!! BECOME ALERT!!! YOUR SAFETY IS INVOLVED. ,_ WARNING: Always disconnect the spark plug wire and place it where it cannot make contact with spark plug to prevent accidental starting during: Preparation, Mainte- nance, or Storage of you snow thrower. IMPORTANT: [...]

After striking a foreign object, stop the en- gine (motor), remove the wire from the spark plug, thoroughly inspect snow thrower for any damage, and repair the damage before restarting and operating the snow thrower. 6. if the unit should start to vibrate abnormal- ly, stop the engine (motor) and check im- mediately for the cause. Vibration is gene[...]

IMPORTANT: Many of the following symbols are located on your unit or on literature sup- plied with the product. Before you operate the unit, learn and understand the purpose for each symbol. Control And Operating Symbols Slow Fast Electric Start Engine Start Engine Run I-I N Engine Off Engine Stop On Choke Off Choke On Neutral Ignition Off Ignition[...]

l,"i'_'Io] A-q Safety Warning Symbols A DANGER Thrown Objects. Keep Bystanders Away. IMPORTANT Read Owner's Manual Before Operating This Machine. WARNING Hot Surface DANGER Thrown Objects. Keep Bystanders Away. DANGER Avoid injury From Rotating Auger. Keep Hands, Feet And Clothing Away. STOP WARNING DANGER Stop The Engine Before[...]

Contents of Parts Bag (actual size) 1 - Owner's Manual (not shown) 1 - Packet of Fuel Stabilizer (not shown) 1- Container 5W30 Oil ,_k WARNING: Always wear safety glasses or eye shields while assembling snow thrower, TOOLS REQUIRED 1 - Knife to cut carton Figure 1 shows the snow thrower in the operating position. References to the right or lef[...]

ZA I :) il"d CHECKLIST Before you operate your new snow thrower, to ensure that you receive the best performance and satisfaction from this quality product, please review the following checklist: All assembly instructions have been completed. The discharge chute rotates freely. ._" No remaining loose parts in carton. While learning how to[...]

[o) KNOW YOUR SNOW THROWER READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR SNOW THROWER. Compare the illustrations with your SNOW THROWER to familiarize yourself with the location of various controls and adjustments. Save this manual for future reference. Recoil Starter Chute Deflector Handle Discharge Chute Control Primer Butt[...]

The operation of any snow thrower can result in foreign objects being thrown into the eyes, which can result in se- vere eye damage. Always wear safety glasses or eye shields while operating the snow thrower. We recommend standard safety glasses or a wide vision safety mask for over your glasses. A ARNING: Read Owner's Manual before operating [...]

FILL OIL: NOTE: Engine may already contain some residual oil. Check frequently when filling the crankcase. DO NOT overfill. The snow thrower was shipped with a container of 5W30 motor oil. This oil must be added to the engine before op- erating. 1. Remove the oil fill cap/dipstick and fill the crank case to "FULL" line on dipstick. DO NOT[...]

_lb ARNING: Gasoline is flam- mable. Always use caution when handling or storing gasoline. Do not fill fuel tank while snow thrower is running, when it is hot, or when snow thrower is in an en- closed area. Keep away from open flame or an electrical spark and do not smoke while filling the fuel tank. Never fill the tank completely. Fill the tank to[...]

WARM START If restarting a warm engine after a short shutdown, leave choke at "OFF" and do not push the primer button. If the en- gine fails to start, follow the Cold Start instructions. FROZEN STARTER If the starter is frozen and will not turn engine: 1. Pull as much rope out of the starter as possible. 2. Release the starter handle and [...]

crushed rock driveways. Move the handle down to slightly raise the au- ger. 9. The forward speed of the snow thrower is dependent on the depth and weight of the snow. Experience will establish the most effective method of using the snow thrower under different conditions. 10. After each snow throwing job, allow the engine to run for a few minutes. [...]

CUSTOMER RESPONSIBILITIES SERVICE RECORDS Fill in dates as you Before Every Every Every complete regular Each 5 10 2S Each Before SERVICE service. Use Often Hours Hours Hours Season Storage DATES Check Engine Oil Level -_ _ Change Engine Oil _j _/ _ghten All Screws and _J Nuts Check Spark Plug -,j _j Lubricate Chute Control _/ Flange Drain Fuel _] [...]

HOW TO REMOVE THE TOP COVER There are no adjustments under the top cover. If removal is required, follow the steps below. 1. Remove screws A that attach the md support clamp the the top cov- er. Pivot crank assembly rod up and lay on unit. 2. Remove locking screw B. 3. Remove attachment screws C from lower rear edge. 4. Slide the top cover approxim[...]

ENGINE LUBRICATION Check the crankcase oil level before starting the engine and after each five (5) hours of continuous use. Bee Figure 11. Add S.A.E. 5W30 motor oil as needed. Tighten oil fill cap/dipstick securely each time you check the oil level. 011 Fill Cap/Dipstick NOTE: Oil level must be between the FULL and ADD mark. Figure 11 Change the o[...]

_ ARNING: To prevent acci- dental starting when making any adjustments or repairs, always disconnect the spark plug wire and place it where it cannot make contact with the spark plug, HOW TO ADJUST THE AUGER DRIVE CABLE The auger drive cable was adjusted at the factory. If the auger will not engage or disengage correctly. Adjust the auger drive cab[...]

HOW TO ADJUST THEAUGERBRAKE The auger brake is adjusted at the faco tory to assure safe operation of the snowthrower. If the auger brake needs an adjustment, follow the steps below: 1. To access the auger brake, tilt the front of the unit up. 2. Make sure the auger drive belt is properly installed. See "How To Re- move The Auger Drive Belt&quo[...]

HOW TO REMOVE THE AUGER DRIVE BELT The auger drive belt is made of special construction and must be replaced with an original equipment belt available from the nearest Sears Store. If the auger drive belt is damaged, the snowthrower will not discharge snow and will not move forward. Replace the damaged belt as follows: 1. Disconnect the spark plug [...]

HOW TO REMOVE THE AUGER 1. Remove the belt cover. See "How To Remove The Belt Cover" in the maintenance section. 2. Remove the auger drive belt. See "How To Remove The Auger Drive Belt" in the Service And Adjustment section. 3. Remove the auger pulley from the auger shaft (threads are left hand; turn clockwise to remove). 4. To [...]

TO ADJUST THE CARBURETOR The carburetor is not adjustable. En- gine performance should not be af- fected at altitudes up to 7,000 feet. For operation at higher elevations, contact your nearest Sears Store. IMPORTANT: Never tamper with the engine governor, which is factory set for proper engine speed. Over-speeding the engine above the factory high [...]

_IL ARNING: Never store your snow thrower indoors or in an enclosed, poorly venti- lated area. If gasoline remains in the tank, fumes may reach an open flame, spark or pilot light from a fur- nace, water heater, clothes dryer, cigarette, etc. NOTE: To prevent engine damage (if snow thrower is not used for more than 30 days) follow the steps below. [...]

TROUBLE Difficult starting CAUSE Defective spark plug. Water or dirt in fuel system. CORRECTION Replace spark plug. Use carburetor bowl drain to flush and refill with fresh fuel. Engine runs erratic Blocked fuel line, empty gas Clean fuel line; check fuel tank, or stale gasoline, supply; add fresh gasoline Engine stalls Unit running on CHOKE. Set c[...]

NOTES F_OO1072M 25[...]