AEG F66602VI0P manual

EN User Manual Dishwasher FAVORIT 66602VI0P[...]

CONTENTS 1. SAFETY INFORMATION................................................................................................. 3 2. SAFETY INSTRUCTIONS................................................................................................ 4 3. PRODUCT DESCRIPTION.............................................................................[...]

1. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.1 General Safety • This appliance is intended to be used in [...]

1.2 Children and vulnerable people safety • This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. ?[...]

WARNING! Dangerous voltage. • If the water inlet hose is damaged, immediately disconnect the mains plug from the mains socket. Contact the Authorised Service Centre to replace the water inlet hose. 2.4 Use • Do not sit or stand on the open door. • Dishwasher detergents are dangerous. Obey the safety instructions on the detergent packaging. ?[...]

3 Lower spray arm 4 Filters 5 Rating plate 6 Salt container 7 Air vent 8 Rinse aid dispenser 9 Detergent dispenser 10 Cutlery basket 11 Lower basket 12 Upper basket 3.1 Beam-on-Floor The Beam-on-Floor is a light that shows on the kitchen floor below the appliance door. • When the programme starts, a red light comes on and stays on for all the dur[...]

5. PROGRAMMES Programme Degree of soil Type of load Programme phases Options P1 1) • Normal soil • Crockery and cutlery • Prewash • Wash 50 °C • Rinses • Dry • ExtraHygiene • TimeSaver • Multitab P2 2) • All • Crockery, cut- lery, pots and pans • Prewash • Wash from 45 °C to 70 °C • Rinses • Dry • ExtraHygiene •[...]

Programme 1) Water (l) Energy (kWh) Duration (min) P2 7 - 14 0.6 - 1.4 40 - 150 P3 12.5 - 14.5 1.4 - 1.6 154 - 164 P4 12 - 14 0.7 - 0.9 75 - 85 P5 10 0.9 30 P6 9 - 10 1.0 - 1.2 219 - 229 1) The pressure and the temperature of the water, the variations of the mains supply, the options and the quantity of dishes can change the values. 5.2 Information[...]

The water softener should be adjusted according to the hardness of the water in your area. Your local water authority can advise you on the hardness of the water in your area. It is important to set the right level of the water softener to assure good washing results. Water hardness German de- grees (°dH) French degrees (°fH) mmol/l Clarke de- gr[...]

• The indicators , and go off. • The indicator continues to flash. • The display shows the current setting: e.g. = level 4. – The levels of rinse aid are from 0A to 6A. – Level 0 = no rinse aid is released. 3. Press again and again to change the setting. 4. Press the on/off button to confirm the setting. 6.4 Use of rinse aid and multi- ta[...]

7. OPTIONS Desired options must be activated every time before you start a programme. It is not possible to activate or deactivate options while a programme is running. Not all options are compatible with each other. If you have selected non compatible options, the appliance will automatically deactivate one or more of them. Only the indicators of [...]

When you start a programme, the appliance can take up to 5 minutes to recharge the resin in the water softener. It seems that the appliance is not working. The washing phase starts only after this procedure is completed. The procedure will be repeated periodically. 8.1 The salt container CAUTION! Only use salt specifically designed for dishwashers.[...]

4. Add the detergent. If you use multi- tablets, activate the option Multitab. 5. Set and start the correct programme for the type of load and the degree of soil. 9.1 Using the detergent A B C CAUTION! Only use detergent specifically designed for dishwashers. 1. Press the release button ( A ) to open the lid ( C ). 2. Put the detergent, in powder o[...]

Cancelling the delay start while the countdown operates When you cancel the delay start you have to set the programme and options again. Press and hold RESET until the appliance is in programme selection mode. Cancelling the programme Press and hold RESET until the appliance is in programme selection mode. Make sure that there is detergent in the d[...]

3. Start the shortest programme with a rinsing phase. Do not add detergent and do not load the baskets. 4. When the programme is completed, adjust the water softener according to the water hardness in your area. 5. Adjust the released quantity of rinse aid. 10.4 Loading the baskets • Only use the appliance to wash items that are dishwasher-safe. [...]

2. Remove the filter ( C ) out of filter ( B ). 3. Remove the flat filter ( A ). 4. Wash the filters. 5. Make sure that there are no residues of food or soil in or around the edge of the sump. 6. Put back in place the flat filter ( A ). Make sure that it is correctly positioned under the 2 guides. 7. Reassemble the filters ( B ) and ( C ). 8. Put b[...]

• If you regularly use short duration programmes, these can leave deposits of grease and limescale inside the appliance. To prevent this, we recommend to run long duration programmes at least 2 times per month. 12. TROUBLESHOOTING If the appliance does not start or it stops during operation. Before you contact an Authorised Service Centre, check [...]

12.1 The washing and drying results are not satisfactory Problem Possible solution There are whitish streaks or bluish layers on glasses and dishes. • The release quantity of rinse aid is too much. Adjust the rinse aid selector to a lower position. • The quantity of detergent is too much. There are stains and dry water drops on glasses and dish[...]

ENGLISH 19[...]

www.aeg.com/shop 117898310_A_132014[...]