Zanussi ZI 310 DIS Bedienungsanleitung

REFRIGER A T OR - FREEZER ZI 310 DIS INS TRUCTION BOOKLE T 2222 209-42[...]

2 IMPORT ANT SAFETY INFORMA TION It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner , or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to kn[...]

3 CONTENTS 2222 209-42 Instructions for the user Important Safety Information 2 Description of the appliance 4 Operation 5 Before use 5 Setting the temperature 5 The freezer compartment 5 Freezing fresh food 5 Frozen food storage 6 Thawing 6 Making ice cubes 6 Fresh food refrigeration 6 Normal operating sounds 6 Hints and Tips 7 Maintenance and Cle[...]

4 DESCRIPTION OF THE APPLIANCE A B C 3 6 9 12 A - Storage wire baskets B - Bottle storage wire basket C - Freezing fresh food[...]

5 OPERA TION Before using Remove all securing tapes. W ash inside the appliance with lukewarm water and bicarbonate of soda (5 ml to 0.5 litre of water). Do not use soap or detergent as the smell may linger . Dry thoroughly . Setting the temperature The temperature inside the refrigerator and the freezer is regulated by a single thermostat (B) with[...]

6 Normal Operating Sounds ¥ Y ou may hear faint gurgling or bubbling sounds when the refrigerant is pumped through the coils or tubing at the rear , to the cooling plate/evaporator or to the fixed freezer shelves. ¥ When the compressor is on, the refrigerant is being pumped round, and you will hear a whirring sound or pulsating noise from the com[...]

7 Food Storage ¥ T o obtain the best results from your appliance, neither hot foods nor liquids which may evaporate, should be placed in the larder compartment. ¥ Keep the time between buying chilled food and placing it in your fridge as short as possible. ¥ Do not push food together too much, try to allow air to circulate around each item. ¥ D[...]

8 Defrosting Refrigerator The refrigerator automatically defrosts every time the compressor stops. The water is discharged, via the pipe, into a tray located at the back of the appliance above the compressor , where it evaporates. Important T o avoid defrost water overflowing into the fridge, periodically clean the water discharge hole in the centr[...]

9 - Reconnect the appliance to the mains or reset the thermostat to a functioning position. - After letting the appliance run for a least half an hour , replace the previously removed food into the compartment. Important When defrosting the freezer , the fridge is also controlled by the thermostat and will not be operational during this period. A t[...]

10 SOMETHING NOT WORKING Symptom No power to the appliance The light does not come on The temperature in the fridge or freezer section is too high The freezer door will not open The compressor runs continously Excessive frost and ice has built up Noise W ater under the salad bin Solution Check there is power at the socket. Check there is not a powe[...]

11 SER VICE AND SP ARE P ARTS CUST OMER CARE DEP ARTMENT In the event of your appliance requiring service, or if you wish to purchase spare parts, please contact your local Zanussi Service Force Centre by telephoning:- 0870 5 929929 Y our telephone call will be automatically routed to the Service Force Centre covering your post code area. For furth[...]

12 Standard guarantee conditions We, Zanussi, undertake that if within 24 months of the date of the purchase this Zanussi appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour , materials or carriage on condition that: Th[...]

13 TECHNICAL SPECIFICA TIONS POWER SUPPL Y VOL T AGE AND FREQUENCY 220-240 V / 50 Hz T OT AL POWER ABSORBED 1 10 W A VERAGE DAIL Y UNITS ELECTRICITY * 1.00 kWh GROSS CAP ACITY Fridge 202 l Freezer 76 l NET CAP ACITY Fridge 182 l Freezer 70 l ST AR RA TING * This figure is based on standard test results in accordance with European Standard EN 153. A[...]

14 INST ALLA TION Positioning This appliance is designed to operate in ambient temperatures between 10¡C (50¡F) and 32¡C (90¡F). It should be located in a dry atmosphere, out of direct sunlight and away from extreme temperature e.g. not next to a cooker or other sources of direct heat, or in a very cold room e.g. an outhouse, where the temperat[...]

15 Electrical connections Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. W ARNING: THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should this safety measure not be observed. If the plug that is fitted to your appliance is not suitable for your soc[...]

16 Instructions for totally built-in appliances Door reversibility P P1 P1 P C D C B A D337 D Right-hand opening Remove pins (P) and (P1) . Left-hand opening Remove (P) from both sides and also remove the door . Remove centre hinge (A) from the left side and (B)- (C)-(D) from the right side. Refit (B)-(C)-(D) on the left side and (A) on the right s[...]

17 Push appliance into housing until stop strip (A) touches the kitchen unit. Open the door and push the appliance against the side of the kitchen unit opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap ventgrille (C) and hinge cover (D) into position Press in the joint cov[...]

18 Place guide (A) on the inside part of the furniture door , up and down as shown in the figure and mark the position of external holes. After having drilled holes, fix the guide with the screws supplied. 20 mm A 50mm PR166 Separate parts A, B, C, D as shown in the figure PR266 A B C D PR33 C A Fix cover (C) on guide (A) until it clips into place.[...]

If the appliance is fixed to the side of the kitchen unit, simply slacken the screws in fixing brackets (E), move the brackets as shown in the figure and re- tighten the screws. D735 E E PR168 PR167/1 D B Should the lining up of the furniture door be necessary , use the clearance of slots. At the end of operations, it is necessary to check if the d[...]