Zanussi ZBB 6244 Bedienungsanleitung

REFRIGERA TOR- FREEZER ZBB 6244 INSTRUCTION BOOKLET 2223 248-75[...]

2 It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transf erred to another owner , or should you mo ve house and leave the appliance, alwa ys ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the ap[...]

3 CONTENTS Instructions f or the User Important Safety Information 2 Operation 4 Before use 4 Setting the temperature 4 The freezer compartment 4 F reezing fresh food 4 F rozen food storage 5 Thawing 5 Making ice cubes 5 F resh food refrigeration 5 Normal operating sounds 5 Mov able shelves 6 Bottle rack 6 P ositioning the door shelves 6 F reezing [...]

4 OPERA TION Before using Remov e all secur ing tapes . Wash inside the appliance with luke war m w ater and bicarbonate of soda (5 ml to 0.5 litre of water). Do not use soap or detergent as the smell may linger . Dry thoroughl y . Setting the temperature The temperature inside the refrigerator and the freezer is regulated by a single thermostat wi[...]

5 Normal Operating Sounds • Y ou ma y hear faint gurgling or bubb ling sounds when the refrigerant is pumped through the coils or tubing at the rear , to the cooling plate/ev aporator or to the fixed freezer shelv es. • When the compressor is on, the refrigerant is being pumped round, and you will hear a whirring sound or pulsating noise from t[...]

6 Mov able shelves The walls of the refrigerator hav e r unners so that the shelves can be positioned as desired . For better use of space , the front half-shelves can lie ov er the rear ones. D338 P ositioning the door shelves T o permit storage of food packages of v arious sizes, the door shelves can be adjusted in height. T o do this proceed as [...]

7 Food Storage • T o obtain the best results from your appliance, neither hot foods nor liquids which ma y ev aporate, should be placed in the larder compar tment. • K eep the time between buying chilled food and placing it in your fridge as shor t as possible. • Do not push food together too m uch, tr y to allow air to circulate around each [...]

8 MAINTENANCE AND CLEANING Before an y maintenance or cleaning work is carr ied out, DISCONNECT the appliance from the ELECTRICITY supply . Internal cleaning Clean the inside and accessories with warm water and bicarbonate of soda (5ml to 0.5 litre of water). Rinse and dry thoroughly . NEVER USE DETERGENTS, ABRASIVE PO WDERS, HIGHL Y PERFUMED CLEAN[...]

9 Remember to wash the defrost cleaner in hot soap y water at regular intervals. Dry throughly before replacing. Freezer When the frost has reached a thickness of up to 4mm it can be remov ed using the ice scraper provided with the appliance. During this operation it is not necessary to disconnect the appliance from the mains and remov e the food. [...]

10 SOMETHING NO T WORKING Symptom No power to the appliance The light does not come on The temperature in the fridge or freezer section is too high The freezer door will not open The compressor runs continously Excessive frost and ice has b uilt up Noise W ater under the salad bin Solution Check there is pow er at the socket. Check there is not a p[...]

11 During a nor mal night time period of approximately 8 hours a traditional fridge freezer can normally maintain the frozen f ood temperature but if the appliance is left for longer period in a low ambient the freez er will defrost . If, after the abo ve checks, there is still a f ault, call your local Service Force Centre. In-guarantee customers [...]

12 Standard guarantee conditions We , Zanussi, under take that if within 12 months of the date of the purchase this Zanussi appliance or any part thereof is prov ed to be defective b y reason only of faulty w or kmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour , materials or carriage on condition th[...]

13 TECHNICAL SPECIFICA TIONS PO WER SUPPL Y VOL T AGE AND FREQUENCY 230-240 V / 50 Hz T O T AL POWER ABSORBED 100 W A VERAGE D AIL Y UNITS ELECTRICITY * 0.80 kWh GROSS CAP A CITY F r idge 173 l F reezer 62 l NET CAP ACITY F r idge 170 l F reezer 60 l ST AR RA TING * This figure is based on standard test results in accordance with European Standard [...]

14 INST ALLA TION P ositioning This appliance should only be installed at a location where the ambient temperature corresponds to the climate classification indicated on the rating plate, which is located at the left on the inside of the appliance. The follo wing table shows which ambient temperature is correct f or each climate classification: SN [...]

15 Electrical connections Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. W ARNING: THIS APPLIANCE MUST BE EARTHED . The manufacturer declines an y liability should this safety measure not be observed. If the plug that is fitted to your appliance is not suitable f or your [...]

16 Instructions for totall y built-in appliances Door rever sal Recess dimensions Height (1) 1446 mm Depth (2) 550 mm Width (3) 560 mm T o ensure adequate ventilation, allo w the clearances shown in figure. 50 mm min. 200 cm 2 200 cm 2 min. D567 Fur thermore, it is necessar y that the cabinet has a ventilation recess with the f ollowing dimensions:[...]

17 D724 Apply the sealing strip pushing it between the refrigerator and the adjacent cabinet. F asten the appliance with 4 screws provided in the kit included with the appliance. (I = shor t) (P = long) Make sure that a distance of 44 mm is maintained in the lower part between the kitchen furniture and the border of the appliance. The lower hinge c[...]

18 Place guide (Ha) on the inside par t of the furniture door , up and down as shown in the figure and mark the position of external holes. After having drilled holes, fix the guide with the screws supplied. 2 1 m m 2 1 m m ca. 50 mm 90° 90° ca. 50 mm Fix cov er (Hc) on guide (Ha) until it clips into place PR33 Hc Ha PR167 Ha Hb 8mm Open the appl[...]

19 After completion of the door rev ersing operation, check that the door gask et adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket ma y not fit perfectly to the cabinet. In that case, wait f or the natural fitting of the gasket or accelerate this process by heating up the part inv olved with a normal hairdr ye[...]

© Electrolux plc 2007[...]