Uniden XC633 Bedienungsanleitung

uniden@ XC630 - BLACK XC633 - WHITE Cordless Telephone ~ Operating Guide For Australia and New Zealand[...]

2[...]

PRECAUTIONS Before you read anything else, Please observe the following: W ARNIN G ! rniden Corporation DOES NOT represent this unit to be raterproof. To reduce the risk of fire, electrical shock, or amage to the unit, DO NOT expose this unit to rain or 10isture. NICKEL METAL HYDRIDE BATTERY WARNING . This equipment contains a Nickel-Metal Hydride [...]

TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS 5 ABOUT YOUR CORDLESS TELEPHONE 7 UNPACKING 7 X C630/633 FEA TURES 8 ROLLINGDIGITALCODE SECURITY 8 BASE UNIT CONTROLS & FUNCTIONS 9 HANDSET CONTROL & FUNCTIONS 10 READ THIS BEFORE INST ALLATION 12 OVERVIEW ..13 IMPORTANT INFORMATION 13 INSTALLING YOUR CORDLESS TELEPHONE 14 SELECTING THE INSTAL[...]

Important Safety Instructions When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electrical shock, and injury to persons, including the following: 1. Read and understand all instructions. 2. Follow all warnings and instructions marked on the product. 3. Unplug this product from the wa[...]

12. Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions: A. When the power supply cord is damaged or frayed. B. If liquid has been spilled into the product. C. If the product has been exposed to rain or water. D. If the product does not operate normally when following the operat[...]

About your Cord less Telephone Congratulations on your purchase of this Uniden XC630/633 Cordless Telephone. The XC630/633 is designed and engineered to exact standards for reliability, long life, and outstanding performance. To get the most from your XC630/633, please read this Operating Guide thoroughly. Unpacking Your XC630/633 box should contai[...]

XC630/633 Features . UltraClear Plus noise reduction provides the best quality sound of a cordless telephone 2530/39 MHz Channels (NZ) or 1030/39 MHz Channels (AUS) 10 Number Memory Maximum Operating Range 1 way paging Redial and Flash Auto Standby Tone/Pulse Dialing (Australian models Only) Automatic Digital Code Security Handset Volume Control . [...]

Base Unit Controls & Functions BASE ANTENNA 9VDC INPUT JACK / TEL LINE TONE/PULSE Switch TEL LINE Jack DC Input Jack Base Unit Antenna IN USE LED CHARGE LED PAGE/FIND PAGE IN USE LED CHARGE LED TONE/PULSE SWITCH Use to select either Tone Dialing or Pulse Dialing. (Functional on Australian Models only) Plug a standard telephone line cord into th[...]

Handset Control & Functions 1. TALK INDICATOR 2. FLASH 3. TALK 4. VOLUM 5. 12 DIAL BUTTONS Handset Antenna LOW BA TT Indicator TALK Button TALK Indicator Numeric Keys 10 HANDSET ANTENNA 6. MUTE 7. REDIAL 8. MEMORY 9. CHANNEL 10. BATTERY LOW INDICATOR 11. MICROPHONE Telescopic Antenna The red LED blinks when the Battery Pack is low and needs to [...]

FLASH Button CHANNEL Button MEMORY Button REDIAL Button VOLUME Button MUTE Button ~ NOTE When making a call, press to send a timed "hook-t1ash" on the telephone line for accessing services such as call waiting, etc. Use to select 1 of the 25 (NZ) or 10 (AUS) channels for the clearest operation. (Note: Operates only when the phone is in us[...]

Read This before Installation We have designed your telephone to conform to Australia or New Zealand Radio Frequency regulations, and you can connect it to most telephone lines. However, each device that you connect draws power from the phone line. We refer to the power drawn as the device's Ringer Equivalence Number or RN. The RN is shown on [...]

OVERVIEW IMPO R T ANT INFO RMA TI 0 N Operating range depends on a variety of factors, such as the weather, the . construction and layout of your home, etc. Aluminum siding, foil-backed insulation and iron roofing may limit operating range. Fluorescent lights and some appliance~ such as microwave ovens and baby monitors are also liable to cause int[...]

Installing Your Cordless Telephone Selecting the Installation Location Select a location for the XC630/633 to avoid excessive heat or humidity (as in a kitchen or bathroom). The Base Unit can be placed on a desk or tabletop near a standard 230/240Y AC outlet and standard telephone line socket, or mounted on a wall. Keep the Base Unit and Handset aw[...]

Installing the Telephone on a Desk or Tabletop ~~. ~ 1. 9VDC INPUT JACK TEL LlNE~ Place the Base Unit on a desk or tabletop, and plug one end of the Telephone Line Cord (supplied) into the "TEL LINE" jack on the Base. 2. Plug the other end of the Telephone Line Cord into the telephone socket. 3. Plug the AC Adaptor cord into the 9Y DC inp[...]

Mounting the Telephone on a Wall The XC630/633 can be mounted directly on a wall. D---- To TEL LINE Jack To DC IN 9V~ Input Jack 1. Carefully select a location away from electrical cables, pipes, or other items behind the mounting location that could cause a hazard when inserting screws into the wall. Locate a suitable wall surface to a power outle[...]

Installing the Battery Pack Black Wire to top v ~ 1. Remove the battery compartment cover on the back of the Handset by sliding it up. 2. Connect the Nickel-Metal Hydride Battery Pack by plugging it into the socket inside the battery compartment. (Note: The connector fits only one way and requires only a minimal amount of pressure to insert. Always[...]

Low Battery Indicator When the Battery Pack voltage level in the Handset is very low and needs to be charged, the BAIT LOW LED blinks. If this occurs while you are on the phone, a short alert beep will also be heard. When this happens, complete your call as early as possible, and return the Handset to the Base Unit for charging. Allow 12 to 16 hour[...]

Using Your XC 630/633 Selecting Pulse or Tone Dialing (Available on Australian Models only) Australian models can use either Pulse Dialing or Tone Dialing, depending on the local service. New Zealand models are Tone Dialing only. To set the Tone or Pulse Dialing, place the TONE/PULSE switch on the Base Unit in the proper position. The tone pulse sw[...]

~ NOTE ~ NOTE If the noise persists, or a double beep is heard, move closer to the base before pressing CHANNEL. If the noise or interference continues, refer to the section entitled "Trouble shooting" in this manual. If you have more than one cordless phone in your house, they must be set to different channels. Using the Flash Button Use[...]

Answering a Call To.answer a call at the Handset, press TALK. When you have finished your conversation, place the Handset back on the Base Unit. The Auto Standby functions automatically hang up the phone. @J NOTE If you don't place the Handset back on the Base Unit, press TALK to hang up the phone. Sometimes when you press TALK to hang up the [...]

Storing a Mixed Tone/Pulse Number with a Pulse Dial System (Available on Australian Models Only) If your phone is set up for Pulse Dialing, you can store a mixed mode number (up to 16 digits) to easily access long distance services. 1. Press MEMORY (The TALK LED flashes) 2. Enter the number to be stored in Pulse Mode. 3. Press * on the Handset. (No[...]

Dialing a stored Number To dial a number stored in memory, press TALK, then press MEMORY and then the memory location number (0~9) Using the Page/Find Feature The Page/Find Feature sends a signal from the Base Unit to the Handset causing it to beep. This is useful for locating the Handset when it is away from the Base Unit. Press the PAGE button on[...]

Optional Accessories You can purchase these optional items as required: HANDSFREE MICROPHONE This will allow you to hold a conversation hands-free. For optional performance, use only UNIDEN provided microphone. UNIDEN Part Number: CTA630 (NZ only) PENDANT CLIP This Lanyard clip allows you to wear the handset around your neck. UNIDEN Part Number: CT[...]

Troubleshooting If your Cordless Telephone is not performing to your expectations, please try these simple steps. If you are still unable to resolve the problems, contact Uniden Customer Service for assistance. Problem Charge light does not come on when Handset is placed on Base Unit. Audio sounds and/or scratchy. weak Can't make or receive ca[...]

Important Electrical Considerations Unplug all electrical appiiances when you know an electrical storm is approaching. Lightning can pass through your household wiring and damage any device connected to it. The XC630/633 is no exception. Note: Please do not attempt to unplug any appliance during an electrical storm. Operating Range Your handset and[...]

KaClO Interference Radio interference may occasionally cause buzzing and humming in your cordless Handset, or clicking noises in the Base Unit. This interference is caused by external sources such as a TV, refrigerator, vacuum cleaner, fluorescent lighting, or electrical storm. Your unit is NOT DEFECTIVE. If these noises continue and are too distra[...]

Specifications General Frequency control Modulation Operating temperature Base Unit Receive Frequency (Australia) Transmit Frequency (Australia) Receive Frequency (New Zealand) Transmit Frequency (New Zealand) Power Requirements Size Weight Handset Receive Frequency (Australia) Transmit Frequency (Australia) Receive Frequency (New Zealand) Transmit[...]

WARRANTY Uoideo XC630/633 1 YEAR WARRANTY (Batteries and Accessories are covered for 90 Days ONLY) Note: Please keep your sales docket as it provides evidence of warranty. Warranty is only valid in the country where the product has been purchased. WARRANTOR: Uniden Australian Pty Ltd. ACN 001 865498 Uniden New Zealand Limited ELEMENTS OF WARRANTY: [...]

PROCEDURE FOR OBTAINING PERFORMANCE OF WARRANTY: In the event that the product does not conform to this warranty, the product should be shipped or delivered, freight pre-paid, with evidence of original purchase (e.g. a copy of the sales docket), to the warrantor at: UNIDEN AUSTRALIA PTY LTD UNIDEN NEW ZEALAND LIMITED Technical Service Division 150 [...]

uniden@ @ 1887 Unidun Corporation. AD rightsrusurvud. CIBXC6300-02 -----..- ..[...]