Rosen Entertainment Systems 410X Bedienungsanleitung

Warning! THE 410X DVD/CD/MP3 PLA YER IS DESIGNED TO ENABLE VIEWING OF DVD OR CD-VIDEO RECORDINGS ONL Y FOR REAR-SEA T OCCUP ANTS. MOBILE VIDEO PRODUCTS ARE NOT INTENDED FOR VIEW- ING BY THE DRIVER WHILE THE VEHICLE IS IN MOTION. SUCH USE MA Y DISTRACT THE DRIVER OR INTERFERE WITH THE DRIVER’S SAFE OPERA TION OF THE VEHICLE, AND THUS RESUL T IN SE[...]

2 410X INTRODUCTION The 410X is a full-featured disc player , supporting DVD, CD- Video, CD-Audio, and MP3 playback, and is designed specifically for the mobile environment. It is intended for use with other Rosen/necvox products and Rosen/necvox video monitors, and can also be integrated with many other products as part of a complete mobile video [...]

410X 3 FCC Approval This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, [...]

4 410X Do not attempt to open the unit or the remote control. The internal parts are not serviceable by the user . Opening any of the components will void the warranty . THE 410X IS A CLASS I LASER PRODUCT , USING A LASER WHICH COULD CAUSE HAZARDOUS RADIA TION EXPOSURE IF IMPROP- ERL Y DISASSEMBLED. All service should be performed by authorized Ros[...]

410X 5 the DVD disc does not correspond to the Region number of this player (Region 1), this player will not be able to play the DVD disc. Some DVD discs are manufactured to operate in “all” zones, and those discs are compatible with the 410X. Region Icons: Discs Incompatible with the 410X The following disc types are incompatible with the 410X[...]

6 410X Front-Panel Controls Mute Disc slot IR receiver Pow e r Eject button Nav k eys P ause Play/ Title Menu Forw ard Stop Audio Rev erse ENT Previous Next The [ON] button turns the 410X on and off, and is backlit green whenever the ignition switch is in the “accessory” or “run” position. The [POWER] button on the remote can also be used t[...]

410X 7 THE REMOTE CONTROL REPEAT ANGLE FAST FORWARD NEXT TRK/CHPT RIGHT MENU SEARCH AUDIO STOP SLOW RETURN TITLE MUTE EJECT SUBT. ON/OFF FAST REVERSE LEFT PREVIOUS TRACK/ CHAPTER NUMERIC KEYPAD SUBTITLE PLAY/ PAUSE DOWN ENTER/SELECT DISPLAY UP POWER SETUP EJECT TITLE SETUP POWER DISPLAY MENU MUTE SLOW STOP RETURN AUDIO 4 3 8 7 SEARCH RC-1001 ENTER [...]

8 410X DVD/VCD/CD-AUDIO PLA YBACK Inserting a DVD/VCD/CD 1 Turn the vehicle’s ignition key to the ACC or ON position. ACC or engine ON position 2 Press either the [ON] button on the front panel or the [POWER] button on the remote control. 3 Holding the disc by its edges, gently insert the disc label- side up into the loading slot until the power-[...]

410X 9 Moving to the Previous Track or Chapter Press the [PREVIOUS] button during playback. The first time this button is pressed, playback of the current track or chapter will restart from the beginning. Pressing this button again will cause the previous track or chapter to be played. Note: • For some VCD 2.0 discs, the [PREVIOUS] and [NEXT] fun[...]

10 410X Parental Control The Parental Control feature allows authorized users to select an upper limit to film ratings that can be played by the 410X. If a DVD is inserted with a film rating higher than that selected, the following screen appears: The parental setting of this player prohibits play . Would you like this disc to play? NO YES In order[...]

410X 11 MP3 PLA YBACK ON CD-R DISCS What is MP3? MP3 is an audio compression method. This audio compres- sion method has become a standard format with many PC users. MP3 allows the original digital audio data to be compressed to about 10 percent of its initial file size while still retaining high sound quality . This means that about 10 music CDs c[...]

12 410X File Extensions Always add a file extension “ .MP3 ” or “ .mp3 ” to an MP3 file by using single-byte letters. If you add a different file exten- sion, or forget to add the file extension “ .MP3 ” or “ .mp3, ” the file cannot be played. In addition, if you use upper case and lower case letters (capital and small letters) mixe[...]

410X 13 Installation and Wiring 1. Before Starting Read these instructions and the following precautions carefully . W ARNING! Be sure to disconnect the battery (-) terminal before starting. This is to prevent short circuits during installation. Precautions • This unit is exclusively for cars with a negative ground, 12V power supply . • Do not [...]

14 410X 4. Installing the 410X Installing into the DIN Sleeve First, verify that the opening you will be mounting the 410X into will accommodate the mounting sleeve. Sleeve opening dimensions Hole 7-3/16" (182 mm) 2-1/16" (53 mm) Note: • Some car models require special mounting kits for proper installation. Consult your Rosen/necvox dea[...]

410X 15 Removing the 410X from the DIN Mounting Sleeve Note: • This requires you to have the original release tools provided with the 410X. Keep these tools in a safe place, not in the vehicle. 1 Remove the rear nut. 2 Remove the trim ring. 3 Insert the removal tools as shown, until a ‘click’ is heard. Pull gently and evenly on both the left [...]

16 410X 2 Remove the clips on the sides of the 410X. 3 Mount the unit to the factory radio brackets, and bolt the brackets to the dashboard. Reassemble the dash. Note: • In some cases the factory trim panel may require some slight trimming, or there may be a slight gap that requires filling. 410X in place of factory pocket, below radio Factory tr[...]

410X 17 410X Factory Radio Mounting Bracket (1 pair for the left and right sides) Pocket Factory Trim Bezel Factory Radio Mounting Screws (retain) 5. Wiring the 410X The following pages display wiring diagrams for 410X configu- rations. Read the following precautions before wiring your system. • Disconnect the negative battery terminal before mak[...]

18 410X 410X Rear-panel Connections Red +12V Accessory Y ellow +12V Main power Black - Ground Digital optical output Audio L and R Output (White - L, Red - R) Video Output (Y ellow) Optional External IR input Fuse/ filter box Four-pin P ower Connector Black - Ground Y ellow +12V Main P ower Red +12V Accessory Wire side of P ower Connector: NO TE : [...]

410X 19 410X in a typical system Black - Gr ound Power Harness, 410X T o Radio and Antenna FM Mod Red +12V Accessory Y ellow +12V Main power Digital output Audio L and R Output (White - L, Red - R) Video Output (Y ellow) Optional External IR input Fuse/ filter box Monitor P ower Supply Module f or Monitor Power Harness, Monitor[...]

20 410X SETUP 410X T ypical Setup and Configuration The 410X is shipped with the following configuration: • Standard 4:3 aspect ratio format output • Automatic NTSC/P AL output switching • Analog stereo audio, digital audio output off • All language options set to English • Parental control off, and default password of 3308. Note: • The[...]

410X 21 Changing the Aspect Ratio Mode T o change the aspect ratio mode, select GENERAL, and then select TV DISPLA Y . For widescreen (16:9) monitors, select WIDE. For standard monitors and letterbox viewing (black bars on the top and bottom of the screen, but the entire image preserved), select NORMAL/LB. For standard 4:3 monitors and a full-scree[...]

22 410X Concealing the “Angle Mark” T o display or conceal the “angle mark,” which appears during scenes that support the multiple-viewing-angle feature, select GENERAL and ANGLE MARK. TV DISPLA Y TV TYPE ANGLE MARK OSD LANG MAIN P AGE OFF - - GENERAL P AGE - - ON CAPTIONS SCR SA VER Activating Captions and Subtitles T o enable or disable c[...]

410X 23 Activating the Digital Output T o turn on the digital output, select AUDIO and AUDIO OUT . Note: • Only enable the digital output when a digital audio processor is in use. Some digital audio processors will require you to select an LPCM output frequency . AUDIO OUT DYNAMIC LPCM OUT MAIN P AGE ANALOG SPDIF/RAW -- AUDIO SETUP -- SPDIF/PCM S[...]

24 410X Deactivating the “Smart Nav” On-Screen Menu Display T o play MP3 discs without the “Smart Nav” on-screen menu display , select PREFERENCES, then SMART NA V . DISC MENU AUDIO SUBTITLE LOCALE P ARENTAL P ASSWORD SMAR T NA V DEF AUL TS MAIN P AGE - - PREFERENCES P AGE - - NO MENU WITH MENU Changing Language Settings Several language se[...]

410X 25 T o change the soundtrack language , select PREFER- ENCES and AUDIO. ENGLISH FRENCH SP ANISH CHINESE JAP ANESE - - PREFERENCES P AGE - - DISC MENU AUDIO SUBTITLE LOCALE P ARENTAL P ASSWORD SMART NA V DEF AUL TS MAIN P AGE T o change the subtitle or caption language , select PREF- ERENCES and SUBTITLE. DISC MENU AUDIO SUBTITLE LOCALE P ARENT[...]

26 410X Setup Options List The factory default options are given in bold type. GENERAL P AGE TV DISPLA Y : NORMAL/PS , NORMAL/LB, WIDE. TV TYPE: MUL TI , NTSC, P AL ANGLE MARK: ON , OFF OSD LANG: ENGLISH , CHINESE CAPTIONS: ON , OFF SCRN SA VER: OFF , ON SPEAKER SETUP DOWNMIX: L T/R T , STEREO AUDIO SETUP AUDIO OUTPUT : ANALOG , SPDIF/RAW , SPDIF/P[...]

410X 27 TROUBLESHOOTING “Tinny” sound. Check the “Downmix” setting in the SETUP menus and ensure that it is set to “Stereo,” not “L T/RT .” Picture “rolls.” Check that the TV T ype setting is correct for the monitors being used. (See “Changing the Video Output Mode”. ) P AL video often “rolls” on NTSC monitors. With a wi[...]

28 410X[...]