LG Electronics LSVFSD-LP Bedienungsanleitung

Report No.1 16-L-49-5 I N S T A L L A T I O N A N D O P E R A T I O N I N S T R U C T I O N S FOR YOUR SAFETY Do not store or use gasoline or other flammable vapors or liquids in the vicinity of this or any other appliance. WHA T TO DO IF YOU SMELL GAS: • DO NOT light any appliance. • DO NOT touch any electrical switches. • Do not use any ph[...]

2 IM PO R T A N T SA FET Y AN D W AR NIN G IN FO RM A TI O N REA D T HIS MA NUA L I N I TS ENT IRE TY AND UN DER - ST AND THE SE R ULE S T O F OLL OW FOR SA FET Y . W ARNINGS If t he in for mat ion in t hi s ma nua l i s n ot f ol- lo we d exa ctl y , a fir e or exp los ion ma y re su lt ca us in g p rop ert y d ama ge , pe rs ona l i nju r y or l[...]

3 NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE. These Gas Log Appliances incorporate unitized ceramic fiber logs which provides some glow realistically when the appliance is operating. The gas log sets covered in this document are heater rated units. These units are equipped with a millivolt gas valve. The control knob is set to the desired [...]

NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE. 4 Adhere to all local codes or in their absence the latest edition of The National Fuel Gas Code ANSI Z223.1 or NFP A 54-latest edition which can be obtained from The American National Standards Institute, Inc. (1430 Broadway , New Y ork, NY , 10018) or National Fire Protection Association, Inc. ([...]

NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE. 5 This heater shall not be installed in a confined space or unusually tight construction unless provisions are provided for adequate combustion and v entilati on air . The heat er may be located in u nusuall y tight c onstruc - tion provide d the space is unconfined, or if confined, is provide [...]

NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE. 6 Not e: Illustrations shown in this manual reflect “typical” installations with nominal dimensions and are for reference only . Actual installations may vary due to individual design preferences. However , always main- tain minimum clearances to combustible materials and do not violate any s[...]

NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE. 7 Figure 3 Step 2. Ceiling Clearance: The ceiling must be at least 42" from the top of the appliance opening ( Figure 2 ) . Step 3. Noncombu stible materials (minimum requiremen ts): T o install the appl ianc e wit hout wood mant els, she lves or ot her combus tibl e pro jec- tions directly a[...]

8 NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE. Any outside air ducts and/or ash dumps in the fireplace shall be perma- nently closed at time of appliance installation. A qualified gas appliance installer must install this dual-listed appli - ance. Check gas type: The gas supply must be the same as stated on the applia nce’ s rating pl at[...]

NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE. 9 The appliance gas inlet connection is 3/8" NPT at the regulator/valve, located on the left side facing the appliance. If a right side connection is requ ired, the co nnect ion pi pe may be piped under the rea r of th e appl iance to end at the left hand side for connection to the inlet. Whe[...]

10 NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE. LOG PLACEMENT INSTRUCTIONS 1. Place rear ember bed as shown in Figure 11 . Figure 11 - Install Rear Ember Bed 2. Place rear log onto the two rear grate locating pins as shown in Figure 12 (the locating pins are outlined in Figure 11 ). 3. Place middle log onto left middle grate locating pin and[...]

11 5. Place left top log onto rear log and middle log locating pins as shown in Figure 15 . 6. Place the center top log onto the rear log locating pin and middle log locating pin as shown in Figure 16 . Left T op Log Locating Pins 7. Place the right top log onto rear log locating pin and the right front log locating pin as shown in Figure 17 . Cent[...]

NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE. 12 Periodically check the positioning of all logs. Flame Appearance REFER TO THE OPERA TING INSTRUCTIONS LOCA TED A T THE BACK OF THIS MANUAL BEFORE LIGHTING THE APPLIANCE TO OBSERVE THE FLAMES. Flames from the pilot burner should be visually checked as soon as the appliance is installed. In addit[...]

NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE. 13 An expan ded vie w of the app lian ce with numbe red par ts a nd a part s li st can be f ound on Page 19 . All part s sho uld b e ord ered throu gh yo ur di stri buto r or deal er. Par ts w ill be s hipp ed a t pr evai ling pri ces at t ime of o rder . When ordering repair parts, always give th[...]

NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE. 14 Standard Remote Control System (Model RCL) The Model RCL (Standard) Remote Control System, features a simplistic on/off control function for the fireplace. This model includes a hand-held transmitter , a remote receiver with wall-mount cover plate and all hardware required to install the unit.[...]

NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE. 15 ACCESSORY COMPONENTS (CONTINUED) Gas Log Sets* Cat. No. Model No. Description H513 7 L SVFS D-18 Logs Shadowdance™ 18" Logs H513 8 L SVFS D-24 Logs Shadowdance 24" Logs * Fo r us e wit h ga s tra in m odels LSV FSD-N G an d LSV FSD- LP on ly 18" Gas Log Set 24" Gas Log Set[...]

NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE. 16 * For the purpose of input adjustment. PILOT (O.D.S.) ASSEMBLY THERMOPI LE WHITE WHITE WHITE RED MILLIVOL T V AL VE ON/OFF SWITCH PILOT PIEZO IGNITER IGNITION WIRE OFF ON OPTIONAL REMOTE CONTROL (MILLIVOL T) Vented/Unvented Gas Log Appliance T echnical Chart For Millivolt Log Set Model No. BTU/[...]

17 4. Depress gas control knob slightly and turn clockwise to “OFF .” Do not force. 5. Close lower control compartment. LIGHTING INSTRUCTIONS – MILLIVOL T WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTL Y , A FIRE OR EXPLOSION MA Y RESUL T CAUSING PROPERTY DAMAGE, PERSONAL INJUR Y OR LOSS OF LIFE. FOR YOUR SAFETY READ BEFORE LIGHTING [...]

NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE. 18 VENTED/UNVENTED TROUBLESHOOTING GUIDE OBSERVED PROBLEM POSSIBLE CAUSE REMEDY 1. When igniter button is pressed, there is no spark at ODS/pilot. A. Igniter electrode positioned wrong. Replace igniter . B. Igniter electrode broken. Replace igniter . C. Igniter electrode not connected to igniter c[...]

19 NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE. REPLACEMENT P ARTS LIST (MILLIVOL T) - SHADOWDANCE™ SERIES Replacement Parts List (Millivolt) - Shadowdance™ Series, Models LSVFSD-NG and LSVFSD-LP (18" and 24") No. Description Catalog Number 1. Valve, Millivolt (Natural) H1203 Valve, Millivolt (Propane, L.P .G.) H4278 2. Ember B[...]

FPO Lennox Hearth Products reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products. Consult your local distributor for fireplace code information. Printed in U.S.A. © 2007 by Lennox Hearth Products P/N 850,051M REV . A 08/2007 1110 West T aft[...]