iRobot 300 Bedienungsanleitung

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28

Zur Seite of

Richtige Gebrauchsanleitung

Die Vorschriften verpflichten den Verkäufer zur Übertragung der Gebrauchsanleitung iRobot 300 an den Erwerber, zusammen mit der Ware. Eine fehlende Anleitung oder falsche Informationen, die dem Verbraucher übertragen werden, bilden eine Grundlage für eine Reklamation aufgrund Unstimmigkeit des Geräts mit dem Vertrag. Rechtsmäßig lässt man das Anfügen einer Gebrauchsanleitung in anderer Form als Papierform zu, was letztens sehr oft genutzt wird, indem man eine grafische oder elektronische Anleitung von iRobot 300, sowie Anleitungsvideos für Nutzer beifügt. Die Bedingung ist, dass ihre Form leserlich und verständlich ist.

Was ist eine Gebrauchsanleitung?

Das Wort kommt vom lateinischen „instructio”, d.h. ordnen. Demnach kann man in der Anleitung iRobot 300 die Beschreibung der Etappen der Vorgehensweisen finden. Das Ziel der Anleitung ist die Belehrung, Vereinfachung des Starts, der Nutzung des Geräts oder auch der Ausführung bestimmter Tätigkeiten. Die Anleitung ist eine Sammlung von Informationen über ein Gegenstand/eine Dienstleistung, ein Hinweis.

Leider widmen nicht viele Nutzer ihre Zeit der Gebrauchsanleitung iRobot 300. Eine gute Gebrauchsanleitung erlaubt nicht nur eine Reihe zusätzlicher Funktionen des gekauften Geräts kennenzulernen, sondern hilft dabei viele Fehler zu vermeiden.

Was sollte also eine ideale Gebrauchsanleitung beinhalten?

Die Gebrauchsanleitung iRobot 300 sollte vor allem folgendes enthalten:
- Informationen über technische Daten des Geräts iRobot 300
- Den Namen des Produzenten und das Produktionsjahr des Geräts iRobot 300
- Grundsätze der Bedienung, Regulierung und Wartung des Geräts iRobot 300
- Sicherheitszeichen und Zertifikate, die die Übereinstimmung mit entsprechenden Normen bestätigen

Warum lesen wir keine Gebrauchsanleitungen?

Der Grund dafür ist die fehlende Zeit und die Sicherheit, was die bestimmten Funktionen der gekauften Geräte angeht. Leider ist das Anschließen und Starten von iRobot 300 zu wenig. Eine Anleitung beinhaltet eine Reihe von Hinweisen bezüglich bestimmter Funktionen, Sicherheitsgrundsätze, Wartungsarten (sogar das, welche Mittel man benutzen sollte), eventueller Fehler von iRobot 300 und Lösungsarten für Probleme, die während der Nutzung auftreten könnten. Immerhin kann man in der Gebrauchsanleitung die Kontaktnummer zum Service iRobot finden, wenn die vorgeschlagenen Lösungen nicht wirksam sind. Aktuell erfreuen sich Anleitungen in Form von interessanten Animationen oder Videoanleitungen an Popularität, die den Nutzer besser ansprechen als eine Broschüre. Diese Art von Anleitung gibt garantiert, dass der Nutzer sich das ganze Video anschaut, ohne die spezifizierten und komplizierten technischen Beschreibungen von iRobot 300 zu überspringen, wie es bei der Papierform passiert.

Warum sollte man Gebrauchsanleitungen lesen?

In der Gebrauchsanleitung finden wir vor allem die Antwort über den Bau sowie die Möglichkeiten des Geräts iRobot 300, über die Nutzung bestimmter Accessoires und eine Reihe von Informationen, die erlauben, jegliche Funktionen und Bequemlichkeiten zu nutzen.

Nach dem gelungenen Kauf des Geräts, sollte man einige Zeit für das Kennenlernen jedes Teils der Anleitung von iRobot 300 widmen. Aktuell sind sie genau vorbereitet oder übersetzt, damit sie nicht nur verständlich für die Nutzer sind, aber auch ihre grundliegende Hilfs-Informations-Funktion erfüllen.

Inhaltsverzeichnis der Gebrauchsanleitungen

  • Seite 1

    iRobot ® V er ro ™ O WNER’S MANUAL Model 300[...]

  • Seite 2

    2 iRobot V erro Owner’ s Manual Safety Notes WARNING: Y our cleaner should not be used while people are swimming in the pool. A Ground F ault Current Inter rupter (GFCI) must be installed to protect your electric outlet and prevent an y possible electric shock. The unit must be supplied through a Ground F ault Current Inter rupter outlet. The con[...]

  • Seite 3

    www .irobot.com 3 Cautions Please read this manual completely before operating your pool cleaner . Retain the safety and operating instructions for future reference. Do not switch the pool cleaner ON if it is not fully immersed in water . Operating the cleaner out of water will cause se vere damage immediately and will result in loss of warranty . [...]

  • Seite 4

    4 iRobot V erro Owner’ s Manual Tips Tip Clean the filter bag regularly . V erro uses the force of the water pumped through its filter bag to move properly . If the filter bag is not k ept clean, V erro will not move or clean properly . Tip Store V erro in a dr y place out of direct sunlight at a temperature between 50 and 104 degrees F ahrenh[...]

  • Seite 5

    www .irobot.com 5 T able of Contents Anatom y ..................................................................... 6 - 7 P ar ts List .................................................................... 6 - 7 Using V er ro ................................................................. 8 How V er ro W orks .......................................[...]

  • Seite 6

    6 iRobot V erro Owner’ s Manual Anatom y P ar ts List 1. Cable Grommet 2. Body Assembly 3. Jet T ube Bushing 4. Jet T ube 5. F ilter Screen 6. Pump Motor 7. Axle 8. 6” Wheel 9. W asher 10. Steering Axle Housing 11. Square Foam Float 12. F ilter Bag 13. Foam Float Clip 14. Bottom Lid Assembly 15. Jet V alve P or t 16. Jet V alve Housing 17. Floa[...]

  • Seite 7

    www .irobot.com 7 3. P ower (ON/OFF) Switch 4. Time Control Dial 5. Socket (F or Floating P ower Cord) 6. Reset Button Jet V alve Housing Assembly T ime Control Dial 15. Jet V alve P or t 15A. Jet V alve P or t Screw 16. Jet V alve Housing Rear View F ront V iew 1. Fuse Holder 2. P ower Supply cord 16 1 5 A 15[...]

  • Seite 8

    8 iRobot V erro Owner’ s Manual Using V er ro 2 Place V erro upside down in the pool and rock it from side to side to allow air to escape. T urn V er ro o ver and allow it to sink to the bottom of the pool so that the wheels rest on the bottom of the pool. 1 Uncoil the floating pow er cord and spread it over the surface of the water , ensuring t[...]

  • Seite 9

    www .irobot.com 9 Using V er ro (cont...) 6 Set the time control dial to 30 seconds. See Adjusting the Time Control Dial, below . 7 T urn the Power Supply switch ON then press the reset button. The light on the P ower Supply will illuminate and V erro will star t to clean your pool. 8 After approximately two hours, V erro will stop and the Power Su[...]

  • Seite 10

    10 iRobot V erro Owner’ s Manual Using V er ro (cont...) 12 Use the floating power cord to pull V erro to the edge of the pool, then use the handle to lift it out of the water . W ater will drain from V erro as it is lifted. CAUTION: Removing V erro by its floating pow er cord may cause severe damage to the cord requiring costly repairs. 9 W ai[...]

  • Seite 11

    www .irobot.com 11 How V er ro W or ks iRobot V erro uses a powerful motor to dra w 80 gallons of water per minute through the filter bag. This creates strong suction at two inlet por ts under the robot that dra ws dir t and debris, such as bacteria, algae, leaves, and even coins into the filter bag where they are trapped. The pump motor also dri[...]

  • Seite 12

    12 iRobot V erro Owner’ s Manual Adjusting the Time Control Dial The time control dial determines how long iRobot V erro tra vels in one direction before stopping and reversing direction. Adjust it so that V erro goes from the waterline on one side of the pool to the waterline on the other side at the widest point, w aiting approximately two seco[...]

  • Seite 13

    www .irobot.com 13 Cleaning the F ilter Bag It is ver y impor tant to clean V erro’ s filter regular ly in order to k eep it running at peak efficiency . The fine filter bag can trap par ticles as small as two microns across. (For comparison, the period at the end of this sentence is more than 500 microns across.) These small par ticles can c[...]

  • Seite 14

    14 iRobot V erro Owner’ s Manual Cleaning the F ilter Bag (cont...) 4 Remove the filter bag assembly . 5 Remove the filter bag from the suppor t bars. 6 T ur n the filter bag inside out and rinse a wa y any accumulated debris with a hose. Gently agitate and squeeze the bag while rinsing it until the water is clear . If this does not remove all[...]

  • Seite 15

    www .irobot.com 15 Maintenance and Adjustment Rinsing V er ro iRobot recommends that you rinse V erro with a garden hose after using it. This will extend the life of the plastic and keep your robot looking good for years to come. Storage Store V erro in a dr y place out of direct sunlight at a temperature between 50 and 104 degrees F ahrenheit. The[...]

  • Seite 16

    16 iRobot V erro Owner’ s Manual Maintenance and Adjustment (cont...) Untwisting the Floating P ower Cord V erro is designed to tra vel around your pool in a wa y that reduces any tendency for the cord to become twisted. Howe ver , if the cord tangles or kinks, and will not lie properly on the surface of the water , it may be neces- sar y to untw[...]

  • Seite 17

    www .irobot.com 17 Maintenance and Adjustment (cont...) Cleaning the Impeller 1 Unplug the Pow er Supply . (Please keep the plug a wa y from contact with water .) Unplug the floating power cord from the P ower Supply . 2 Remove the scre ws that attach the jet valve por ts. (See Jet V alve Housing Assembly illustration on page 7.) V erro uses an im[...]

  • Seite 18

    18 iRobot V erro Owner’ s Manual 6 Using the bent paper clip, hook the material fouling the impeller . It may be helpful to use a small flashlight to see better . 7 Replace the jet valve por t. 8 Replace the screws.[...]

  • Seite 19

    www .irobot.com 19 Maintenance and Adjustment (cont...) Cleaning the Jet T ubes V erro uses two powerful jets of w ater like pow er washers to loosen attached dir t and debris as it moves around the pool. If the tubes that carr y these jets from the impeller to the nozzles under the robot become blocked, V erro will not be able to clean as well. If[...]

  • Seite 20

    20 iRobot V erro Owner’ s Manual Checking the Flaps in the V acuum Intak es There is a flap just inside each vacuum intake at the bottom of the robot. These flaps must freely open and close. If they do not, remove any dir t or debris that is interfering with their operation. Cleaning the Direction Baffle V erro uses a baffle to redirect the ?[...]

  • Seite 21

    www .irobot.com 21 T roubleshooting Problem likely Cause What to Do V erro moves slowly The filter bag needs to be cleaned Flaps in the vacuum intakes at bottom of robot are blocked Wheels or axles are not turning freely The pump impeller is fouled by dirt or debris Clean the filter bag. (p. 13) Check the flaps in the vacuum intakes. (p. 20) Che[...]

  • Seite 22

    22 iRobot V erro Owner’ s Manual T roubleshooting (cont...) Problem Likely Cause What to Do V erro reverses direction before reaching end of pool The filter bag needs to be cleaned Time control dial is not set properly Flaps in the vacuum intakes at bottom of robot are blocked Wheels or axles are not turning freely The pump impeller is fouled by[...]

  • Seite 23

    www .irobot.com 23 T roubleshooting (cont...) Problem Likely Cause What to Do V erro is not removing attached dir t and debris The filter bag needs to be cleaned Flaps in the vacuum intakes at bottom of robot are blocked The pump impeller is fouled by dirt or debris Jet tube is blocked Clean the filter bag. (p. 13) Check the flaps in the vacuum [...]

  • Seite 24

    24 iRobot V erro Owner’ s Manual iRobot Customer Care Please visit our web site at www .irobot.com for suppor t tips, frequently asked questions or information about accessories and other iRobot products. We would like to hear from you. Should you still need assistance, call our customer care representative at 877.855.8593 iRobot Customer Care Ho[...]

  • Seite 25

    [...]

  • Seite 26

    [...]

  • Seite 27

    [...]

  • Seite 28

    © 2007 iRobot Corporation, 63 South A venue, Burlington, MA 01803. All rights reserved. iRobot is a registered trademark and Verro is a trademark of iRobot Corporation. Cover photo © V eer Incorporated 2002 - 2005. All rights Reser ved. T o purchase accessories: Call 800.727.9077 or visit our w ebsite at store.irobot.com *See registration card fo[...]